CC-Dr. Schutz GmbH
Steinbrinksweg 30
Hessisch Oldendorf
Fax: +49-(0)5152-9779-30
Tel: +49-(0) 5152-9779-0
Schutz NA LLC.
4701 Bath St #47
Philadelphia, Pa 19137
Fax: 877-272-4889
Tel: 877-272-4889
sam@schutzna.com www.schutzna.com
Schutz Cleaner
1. Product Description
Ideal cleaner for use after installing and for maintaining factory-cured floor coverings. Removes dirt,
fat, grease and shoe marks. Does not leave a residue.
2. Areas of Application
Resilient flooring with a polyurethane factory finish or treated with Waxnomor, Slipnomor or
3. Method of Application
Cleaning after installation:
Remove coarse dirt using a brush or vacuum cleaner. In case of stubborn dirt, dilute Schutz Cleaner
in a ratio of 1:10 (1 litre to 10 litres of water), reducing the concentration accordingly for slight
soiling. Distribute the cleaning solution over the floor and, after allowing to stand for a short time,
treat the floor surface using a scrubbing brush. Where larger areas are involved, the Monodisc should
be used with red pad or scrubbing brush. Take up the dirt using a wide-headed absorbent wiper
mop, for larger floor areas using a Spray Extractor machine with hard floor adapter. Wipe over with
clear water to neutralise.
Consumption: approx. 1 l = 500- 1000 ft²
Daily Cleaning:
Dilute Schutz Cleaner in a ratio of 1:200 (50 ml to 10 litres of water) and wipe over the floor using
this solution. The concentration can be reduced to 1:400 (25 ml to 10 litres of water) when using a
fully automatic cleaning appliance.
Consumption: 1 l = 10,000 ft²
Sensitive surfaces (such as wood, metal, furnishings) should not be sprayed with the
cleaning solution
Page 1 of 2
PI-GB-06.06 Schutz
- Schutz Cleaner
5. Quality Inspection
Certified in Germany by the Forschungs- und Prüfinstitut für Facility Management GmbH, Metzingen
6. Unit Sizes
5 l canister
Art.-No. 0715000501
The above advice on procedure for use is based on the best of our knowledge and the latest
information available on cleaning technology. For this reason, when using our quality products, no
damage will be incurred to the materials to be cleaned if strict attention is paid to the instructions
printed on the container and the procedure suggested by us is followed. The use to which our
products are put is, however, beyond our control. It is the responsibility of the user and does not
release the user from making his own checks of the products supplied by us as to their suitability for
the intended procedure and purposes. The information supplied by us is therefore non-binding and
cannot be used as a basis for establishing the company's liability for any damage incurred. This also
includes the infringement of any rights for the protection of third parties.
Page 2 of 2
PI-GB-06.06 Schutz
Download PDF