2007-09 Jeep Wrangler About the Vehicle Make: Jeep Model: Wrangler Year: 2007-09 Standard/Optional CD Player Auxiliary Input Infinity Sound System In-Dash 6 Disc Changer MP3 Compatible Satellite Radio Navigation Speaker Notes Front In Dash Application Dash Type: Double Din Aftermarket Type: Single/Double Din Kit: CR1288B/CR1291B Harness: CR07SR Antenna Adapter: VWA3B/VWA3RB Upper Dash: 1" Tweeter Lower Dash: 6 1/2” Midrange Speaker Adapter: SAC656 Speaker Harness: TBA Dimensions: W= L= D= Rear Wire Color Codes Type: Standard Sound Location: Behind Radio +12v Constant = RED +12v Acc. Switch = CAN BUS -12v Chassis Ground= Black +12v Illumination = CAN BUS +12v Dimmer = Antenna/Amp Remote = LF+ = Gray/Yellow LF- = Gray/Violet RF+ = Green/Yellow RF- = Green/Violet LR+ = Gray/Drk. Green LR- = Gray/Lt. Green RR+ = Lt. Green/Gray RR- = Drk. Green/Lt. Green Speaker Sizes NOTES Speaker Sizes Rear Roof: 6.5'' Midrange Speaker Adapter: SAC656 Speaker Harness: TBA Dimensions: W= L= D= NOTES 2007-09 Jeep Wrangler Radio removal 1. With PRT unsnap panel below hazard switch. 2. Remove (2) 7mm screws. 3. With PRT unsnap black 10x10 plastic panel on top of dash. Unsnap rear of panel (closest to windshield) then slide panel back and up. 4. Remove (2) 7mm screws. 5. With PRT unsnap trim panel around stereo. 6. Disconnect A/C cables unplug remaining plugs, lift away. 7. Remove (4) 7mm screws from stereo, disconnect and remove. Images Radio Front Speaker(s) "A" Pillar 1. With PRT unsnap tweeter, disconnect and remove. Front Speaker Lower Door Not available at this time. Tweeter Speaker Rear Speaker Rear Speaker(s) Rear Deck 1. Remove (3) Torx T15 screws, disconnect and remove.