APDTY 00260 Programming Instructions (Read &

APDTY 00260 Programming Instructions (Read & Understand Completely Before Starting)
1 WORKING REMOTE IS REQUIRED AT TIME OF PROGRAMMING OR DEALERSHIP IS NEEDED
RUSHING THE PROCEDURE WILL REQUIRE MINIMUM 30 SECOND REMOVAL OF NEGATIVE BATTERY
CABLE! ALL REMOTES MUST BE PRESENT AT TIME OF PROGRAMMING
PROGRAMMER WILL EXPIRE AFTER 5 ATTEMPTS
2007-2008 Nissan Programming (ALSO INCLUDES 2009 MURANO)
1. Insert an already programmed PROX remote into the key slot located to the left of the steering
column. Push the start/stop button to the ON position.
2. Insert programmer into OBD/DLC port located under steering column, near pedals. Programmer will
BEEP twice.
3. Wait 10 seconds. Push start/stop button to the OFF position. BEEP once.
4. Wait 10 seconds. Push start/stop button to the ON position. Programmer will BEEP twice.
5. Wait 10 seconds. Push start/stop button to the OFF position. BEEP once.
6. Wait 10 seconds. Push start/stop button to the ON position. Programmer will BEEP twice.
7. Wait 10 seconds. Push start/stop button to the OFF position. BEEP once.
8. Wait 10 seconds. Push start/stop button to the ON position. Programmer will BEEP twice.
9. Wait 10 seconds. Push start/stop button to the OFF position. Programmer will BEEP 3 times.
10. Wait 10 seconds. Push start/stop button to the ON position. The red car light above the mileage will
flash 5 times.
11. Remove PROX remote and insert the next to be programmed. Push start/stop button to the ON
position. The red car light above the mileage will flash 5 times.
12. Push start/stop button to the OFF position.
13. Push start/stop button to the ON position.
14 Push start/stop button to the OFF position.
15. Depress the brake pedal. Push start/stop button to the ON position and start the vehicle.
16. Turn vehicle OFF and remove the programmer. 2
17. Test the lock and unlock buttons on each remote programmed. If programming has failed restart the
instructions from the beginning.
2009-2014 Nissan Prox Programming
1. Insert an already programmed PROX remote into the key slot located to the left of the steering
column. Push the start/stop button to the ON position.
2. Insert programmer into OBD/DLC port located under steering column, near pedals. Programmer will
BEEP twice.
3. Wait 10 seconds. Push start/stop button to the OFF position. BEEP once.
4. Wait 10 seconds. Push start/stop button to the ON position. Programmer will BEEP twice.
5. Wait 10 seconds. Push start/stop button to the OFF position. Programmer will BEEP 3 times.
6. Wait 10 seconds. Push start/stop button to the ON position. The red car light above the mileage will
flash 5 times.
7. Remove PROX remote and insert the next to be programmed. Push start/stop button to the ON
position. The red car light above the mileage will flash 5 times.
8. Push start/stop button to the OFF position.
9. Push start/stop button to the ON position.
10. Push start/stop button to the OFF position.
11. Depress the brake pedal. Push start/stop button to the ON position and start the vehicle.
12 Turn vehicle OFF and remove the programmer.
13. Test the lock and unlock buttons on each remote programmed. If programming has failed restart the
instructions from the beginning. MODULE LOCK UP PROCEDURE- IN THE EVENT THAT THE
PROGRAMMING INSTRUCTIONS ARE RUSHED, REMOVE THE NEGATIVE BATTERY TERMINAL FOR 30
SECONDS AND RESTART THE INSTRUCTIONS FROM THE BEGINNING
Download PDF