RANGE HOOD
USER'S MANUAL
CANBERRA 50 W
CANBERRA 50 X
CANBERRA 60 W
CANBERRA 60 X
Dear customer,
Thank you for buying a PHILCO brand product. So that your appliance serves you well, please read all
the instructions in this user's manual.
2
Contents
PART 1: IMPORTANT SAFETY INSTRUCTIONS ..................................4
Caution .................................................................................................4
PART 2: DESCRIPTION OF THE APPLIANCE ......................................6
PART 3: INSTALLATION ........................................................................7
Use .......................................................................................................7
Electrical connection ............................................................................7
Mounting...............................................................................................7
PART 4: OPERATION .............................................................................9
PART 5: MAINTENANCE AND CLEANING .........................................10
PART 6: BEFORE YOU CALL THE SERVICE CENTRE .....................11
PART 7: TECHNICAL SPECIFICATIONS.............................................12
3
PART 1: IMPORTANT SAFETY INSTRUCTIONS
Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences,
damages or fires caused by not complying with the instructions in this manual, is declined. This appliance is
intended to be used in household and similar application such as: - staff kitchen areas in shop, offices and
other working environments; - farm houses; - by clients in hotels, motels and other residential type
environments; - bed and breakfast type environments.
• It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or
move, make sure it is together with the product.
• Read the instructions carefully: there is important information about installation, use and safety.
• Do not carry out electrical or mechanical variations on the product or on the discharge conduits.
• Before proceeding with the installation of the appliance verify that there are no damaged all components.
Otherwise contact your dealer and do not proceed with the installation.
Note: The parts marked with the symbol "(*)" are optional accessories supplied only with some models or
otherwise not supplied, but available for purchase.
Caution
• Before any cleaning or maintenance operation, disconnect hood from
the mains by removing the plug or disconnecting the mains electrical
supply.
• Always wear work gloves for all installation and maintenance operations.
• This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved.
• Children shall not be allowed to tamper with the controls or play with the
appliance.
• Cleaning and user maintenance shall not be made by children without
supervision.
• The premises where the appliance is installed must be sufficiently
ventilated, when the kitchen hood is used together with other gas
combustion devices or other fuels.
• The hood must be regularly cleaned on both the inside and outside (AT
LEAST ONCE A MONTH).
• This must be completed in accordance with the maintenance instructions
provided. Failure to follow the instructions provided regarding the cleaning
of the hood and filters will lead to the risk of fires.
• Do not flambé under the range hood.
4
• For lamp replacement use only lamp type indicated in the
Maintenance/Replacing lamps section of this manual.
The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided
in all circumstances.
Any frying must be done with care in order to make sure that the oil does not overheat and ignite.
CAUTION: Accessible parts of the hood may become hot when used with cooking appliances.
• Do not connect the appliance to the mains until the installation is fully complete.
• With regards to the technical and safety measures to be adopted for fume discharging it is important to
closely follow the regulations provided by the local authorities.
• The air must not be discharged into a flue that is used for exhausting fumes from appliance burning gas or
other fuels.
• Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks.
• Never use the hood without effectively mounted grids.
• The hood must NEVER be used as a support surface unless specifically indicated.
• Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct
screws type.
• Use the correct length for the screws which are identified in the Installation Guide.
• In case of doubt, consult an authorized service assistance center or similar qualified person.
WARNING!
• Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
• Do not use with a programmer, timer, separate remote control system or any other device that switches
on automatically.
• This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic
Equipment (WEEE).
• By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for
the environment and human health, which could otherwise be caused by inappropriate waste handling of this
product.
• The symbol
on the product, or on the documents accompanying the product, indicates that this
appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local
environmental regulations for waste disposal.
• For further detailed information regarding the process, collection and recycling of this product, please contact
the appropriate department of your local authorities or the local department for household waste or the shop
where you purchased this product.
Appliance designed, tested and manufactured according to:
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233.
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13;
EN/IEC 60704-3; ISO 3741; EN 50564; IEC 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3.
Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum
speed when you start cooking and kept it running for few minutes after cooking is finished. Increase the speed
only in case of large amount of smoke and vapor and use boost speed(s) only in extreme situations. Replace
the charcoal filter(s) when necessary to maintain a good odor reduction efficiency. Clean the grease filter(s)
when necessary to maintain a good grease filter efficiency. Use the maximum diameter of the ducting system
indicated in this manual to optimize efficiency and minimize noise.
5
PART 2: DESCRIPTION OF THE APPLIANCE
1.
2.
3.
4.
6
Control panel
Grease filter support grill
Grill release handle
Hob lighting
PART 3: INSTALLATION
Use
The hood is supplied with an upper air outlet (A1 – attachment to bayonet fitting + screw) for exterior fume
extraction (Aspiration version A), remove the corresponding removable metal panel and install the tube
connector.
Check that selector G is in suction position (A). If it is not possible to discharge the cooking fumes and steam
outside, the filtering version hood can be used, mounting a carbon filter (*). The fumes and steam are
recycled through a front grill placed over the command panel (do not remove the pre-fractural walls!). Check
that selector G is in filtering position (F).
Electrical connection
The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If
provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an
accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located
in an accessible area, after installation, apply a double pole switch in accordance with standards which
assures the complete disconnection of the mains under conditions relating to over-current category III, in
accordance with installation instructions.
WARNING!
Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that
the mains cable is correctly assembled.
Warning! If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid hazard.
Mounting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified
technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling
must be strong enough to take the weight of the hood.
Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest
part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.
7
8
PART 4: OPERATION
The hood is fitted with a control panel with aspiration speed selection control and a light switch to control
cooking area lights.
a.
b.
c.
d.
e.
on/off light switch
off aspiration switch
minimum power selection aspiration switch
medium power selection aspiration switch
maximum power selection aspiration switch
9
PART 5: MAINTENANCE AND CLEANING
Clean using ONLY the cloth dampened with neutral liquid detergent. DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS. Do not use abrasive products. DO NOT USE ALCOHOL!
Grease filter - Carbon filter (*): it is/they are mounted on the back of the grill and must be changed once a
month.
If the metal fats filter is envisaged in the model in your possession, this must be cleaned once a month with
non-aggressive detergent manually or in a dishwasher at low temperature and short cycle.
The metal anti-fats filter might discolour by washing in a dishwasher but its filtering characteristics do not
change at all.
Changing bulbs (Attention! Make sure that the bulbs are cool before touching them):
Remove the grill.
Remove the damaged light and replace it with a new one (see the table below):
Lamp
Voltage (V)
Power (W)
Socket
28
E14
Dimension (mm)
67 (Light Center
230
Length)
ILCOS D Code
(according IEC 61231)
HSGSB/C/UB-28-230-E14-67
Put the grill back.
10
PART 6: BEFORE YOU CALL THE SERVICE CENTRE
If the appliance is not working as it should check the following recommendations for resolving the most
common problems.
If the problem persists or it is not included in the table below, turn off the appliance and disconnect it from the
power socket and contact an authorised service centre.
Problem
The range hood is not working.
The lights are not working.
Exhaust power is weak.
The range hood does not extract the air
directly out (for models without an exhaust).
Solution
Check that the power plug is properly inserted in a
properly grounded power socket with the parameters 220
– 240 V ~ 50 Hz.
Check that the motor power switch is in the "On" position.
Check that the power plug is properly inserted in a
properly grounded power socket with the parameters 220
– 240 V ~ 50 Hz.
Check that the motor power switch is in the "On" position.
Check whether the light bulb or fluorescent tube is
broken.
Check whether the aluminium filters are dirty.
Check the air outlet, it should be open.
Check whether the carbon filter is not too dirty.
Check whether the aluminium filters are dirty.
Check whether the carbon filter is not too dirty.
ATTENTION:
Use the range hood together with the stove. This will ensure the correct air exhaust. We recommend
to leave the range hood running a few minutes longer than the stove to ensure that all odours are
extracted.
11
PART 7: TECHNICAL SPECIFICATIONS
Low speed
Air flow (m³/h)
Noise level (dba)
95
52
High speed
Air flow (m³/h)
Noise level (dba)
165
64
Pressure (Pa): 115
Power (W): 108
Input Voltage: 220-240V ~ 50/60 Hz
Air outlet diameter:12,5 cm
12
Download PDF