Operating instructions 7084 790-01

Operating instructions
Page 2
GB
Chest freezer
7084 790-01
EFE EFI EFL
English
Disposal notes
Safety instructions and warnings
The packaging is made of recyclable materials.
• To prevent injury or damage to the unit, the appliance should be
unpacked and set up by two people.
• In the event that the appliance is damaged on delivery, contact
the supplier immediately before connecting to the mains.
• To guarantee safe operation, ensure that the appliance is set up
and connected as described in these operating instructions.
• Disconnect the appliance from the mains if any fault occurs. Pull
out the plug, switch off or remove the fuse.
• When disconnecting the appliance, pull on the plug, not on the
cable.
• Any repairs and work on the appliance should only be carried
out by the customer service department, as unauthorised work
could prove highly dangerous for the user. The same applies to
changing the mains power cable.
• Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that
the refrigerant circuit is not damaged. In the event of damage,
make sure that there are no ignition sources nearby and keep the
room well ventilated.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack
of experience and knowledge unless they have been given initial
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
• Avoid prolonged skin contact with cold surfaces or chilled/frozen
food. This could cause pain, numbness and frostbite. In the case
of prolonged skin contact, protective measures should be taken,
e.g. gloves should be worn.
• Do not eat ice cream, particulary ice lollies or ice cubes, immediately after taking them from the freezer compartment as there
is a risk of “burning” because of the very cold temperatures.
• Do not consume food which has been stored for too long, as it
could cause food poisoning.
• If you have a lockable appliance, do not keep the key near the
appliance or within reach of children.
• Do not use electrical appliances inside the appliance.
• Do not connect the appliance to the supply with other equipment
using an extension cable. This can cause the extension socket to
overheat.
-
Corrugated board/board
EPS moulded parts
Polythene sheets
Polypropylene straps
• Keep packaging materials away from children - polythene sheets
and bags can cause suffocation!
• Please return the packaging to an official collection point.
Your old appliance: This contains some reusable materials and should be disposed of properly - not simply
with unsorted household refuse.
• Discarded appliances should be disabled: Remove the
plug, cut through the connection cable and render the
catch unusable so that children cannot become trapped
inside.
• Ensure that the refrigerant circuit is not damaged when the appliance that is no longer needed is taken away for disposal.
• Details of the refrigerant can be found on the type plate.
• Appliances which are no longer needed must be disposed of in a
professional and appropriate way, in accordance with the current
local regulations and laws.
Component Description
Lower glass lid
Model plate
Upper glass lid
Lock
Model plate
Casters
Important!
Before starting up the appliance, plug
the defrost drain opening in the floor of
the appliance with the plug provided.
This is important to ensure that the
appliance works properly.
2
Ventilation grille
Temperature control
English
Climate rating
Setting up
The appliance is set to operate within specific ambient temperature
limits according to its climate rating. These temperature limits
should not be exceeded. The correct climate rating for your appliance is indicated on the type plate.
• Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat.
Climate rating
Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
• Do not cover the gap between the lower edge of the freezer and
the floor, as the refrigeration
unit has to be supplied with
air for cooling.
The appliance complies with the relevant safety regulations and
EC directives 2004/108/EC and 2006/95/EC.
The operating instructions apply to several models. Differences
may therefore occur.
Dimensions (mm)
Model
• The floor on which the appliance stands must be horizontal
and level.
A
B
C
D
EFE 1102/1152 ..
EFE 1502/1552 ..
EFE 2202 / 2252
EFE 3002/3052 ..
EFE 3000 ...........
EFE 3802/3852 ..
EFE 3800 ...........
EFE 4602/4652 ..
EFE 6002/6052 ..
825
825
825
825
825
825
825
825
625
835
1045
1045
1255
1255
1465
1885
660
660
660
660
660
660
660
660
-
EFI 1403/1453 ...
EFI 2103/2153 ...
EFI 2803/2853 ...
EFI 3503/3553 ...
EFI 4403/4453 ...
EFI 4803/4853 ...
EFI 5603/5653 ...
825
825
825
825
825
825
825
625
835
1045
1255
1465
1681
1885
660
660
660
660
660
660
660
751
751
751
751
751
751
751
EFL 1505 ...........
EFL 3005 ...........
EFL 3805 ...........
EFL 4605 ...........
EFL 4803/4853 ..
EFL 6005 ...........
825
825
825
825
825
825
625
1045
1255
1465
1675
1885
660
660
660
660
660
660
-
• There must be a gap of
at least 20 cm between
the ventilation grille and
the wall. This gap must
be kept clear and the
ventilation openings uncovered.
mi
n.
2
0m
m
• Do not place any objects immediately next to
the outer housing of the
appliance. There must
be a gap of at least 20
mm all round in order to
ensure adequate heat
discharge.
min.
200 mm
Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of
R 290a/ R 600a refrigerant used in the appliance, so as to
avoid the formation of inflammable gas/air mixtures in the
room where the appliance is located in the event of a leak
in the refrigerant circuit. The quantity of refrigerant used in
your appliance is indicated on the type plate
Connecting to the mains
Power supply (a.c.) and voltage at the operating point must comply
with the details on the type plate. The type plate is located on the
rear of the appliance.
The socket must be fused with a 10 A fuse or higher, it must be away
from the rear of the appliance and must be easily accessible.
Connect the appliance with a properly earthed fused plug
and socket only.
Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see “Cleaning”).
To switch the appliance on:
Connect the appliance to the mains - the
appliance is switched on.
The green ON lamp (arrow) comes on.
To switch the appliance off:
Pull out the mains plug or remove/unscrew
the fuse.
Storage
The appliance is suitable for storing ice cream and ready-frozen
foods.
It must not be filled higher than the stacking mark on the inside
of the freezer
3
English
Setting the temperature
Barrel lock (EFE, EFI)
(not standard accessory)
Turn the arrow on the temperature control to a setting between
1 and 7.
Setting 1 = lowest cooling setting
Setting 7 = highest cooling setting, coldest
The temperature control is in the cover grille for the compressor
compartment on the right-hand side wall of the freezer.
The glass lid can be locked using barrel
lock.
Open the hole cover on the lid by sliding
backwards.
Place the barrel lock in the opening provided in the lid, turn the key and remove.
Remove the key and keep it safely.
Caution :
The lock cover must always close during
operation to ensure air tightness in the
cabinet.
Temperature display
The thermometer shows the warmest frozen food temperature.
It is adjusted and designed so that only temperatures below 0°C
are accurately displayed.
Baskets
The baskets make it easier for you to
sort food.
The baskets at can be suspended in the
frame of the freezer by their handles.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch it
off and disconnect the plug or remove the fuse. Clean the appliance
and leave the lid open in order to prevent unpleasant smells.
Lock (EFL)
The lock is equipped with a safety
mechanism.
Locking the appliance:
1 Press the button and keep it
depressed.
2 Turn the key 90°.
4
After decommissioning, the appliance must be stored or transported on its housing feet or castors! If not, the refrigerant
circuit can become blocked.
Do not leave the appliance in direct sunlight either when it
is switched on or when it is in storage - there is the risk of
plastic part deformation.
Defrosting
Malfunctions
After the appliance has been in operation for some time, a layer of
frost or ice will form on the inside walls. This increases energy consumption. You should therefore defrost the appliance regularly.
You may be able to rectify the following faults by checking
the possible causes yourself:
• Pull out the main plug or
remove/unscrew the fuse.
• Remove the frozen food and
store in other units.
• Pull out the plug from the
drain opening and place a
tray underneath the appliance so that the defrosted
water escapes through the
drain opening into the tray.
• Leave the lid open while
defrosting. After defrosting
mop up the remaining water
and clean the appliance.
• Do not forget to close the
defrost drain opening.
Do not use any mechanical devices or other artificial aids for defrosting other than those recommended by the manufacturer.
• Appliance does not function:
- Is the plug correctly fitted in the mains socket?
- Is the socket fuse intact?
• The temperature is not low enough:
- Is the temperature setting correct (see “Setting the temperature”)?
- Does the separately installed thermometer show the correct
reading?
- Is the ventilation system working properly?
- Is the appliance set up too close to a heat source?
If none of the above causes apply and you cannot rectify the
fault yourself, contact the nearest
customer service department
stating the type of appliance ➊,
service number ➋ and appliance
number ➌ as indicated on the
type plate.
Cleaning
Before cleaning always switch off the appliance.Pull out the
mains plug or remove/unscrew the fuse.
• Clean the inside, equipment parts and outer walls with lukewarm
water and a little detergent. Do not use abrasive or acid cleaners
or chemical solvents.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grille.
• Dry all parts well with a cloth.
• The ventilation grilles should be cleaned regularly. Dust deposits
increase energy consumption. Ensure that none of the wires or
other components are dislodged, bent or damaged.
Do not use steam cleaners because of the risk of injury and
damage.
5