Device
Display message
“LOAD TEST
MODE”
Boiler
“HEATER ON”
The coffee heating element goes ON. (check with amperometer
the power consumption)
Pump
"PUMP ON"
The pump goes ON. The pump will only vibrate (the pump
goes on only with tank in place and water on it)
Grinder motor
"GRINDER ON"
w
ht
tp
://
Infuser motor
Lower limit
nk
i
se
Pressing the "OK" button, the grinder goes ON.
ou
"MOTOR UP"
w
Infuser motor
Upper limit
To enter the "Test Mode" press simultaneously "Short" and
"Large" coffee, then plug on the machine
w
.h
Button
tc
he
n.
co
m
Delonghi ESAM3500 & ESAM4500 Test Mode (Early models)
"MOTOR DOWN"
Pressing the "ON / OFF" button, the motor will move upwards.
When the infuser will close the upper switch the motor will
stop and display will show: "LIMIT SWITCH UP" (the motor
will move only with service door closed and coffee ground
container in place)
Pressing the "Taste" button, the motor will move downwards.
When the infuser will close the lower switch, the motor will
stop and the display will show: "LIMIT SWITCH DOWN"
(the motor will move only with service door closed and coffee
ground container in place)
Pressing the "SHORT COFFEE" button, the
discharge valve goes ON.
EV1
"EV1 ON"
EV2
"EV2 ON"
Pressing the "MEDIUM COFFEE" button, the
steam valve goes ON.
Steamer
"VAPORIZER ON"
Pressing the "LARGE COFFEE" button, the
STEAM BOILER goes on.
(check with amperometer the power consumption)
DISPLAY TEST mode
Press simultaneously "MEDIUM" and "LARGE"
coffee buttons, then plug on the machine
BUTTON 1
tc
he
n.
co
BUTTON 3
m
BUTTON 2
BUTTON 4
://
w
w
w
.h
ou
se
nk
i
BUTTON 5
ht
tp
COUNTING MODE
BUTTON 6
BUTTON 7
BUTTON 8
BUTTON 9
BUTTON 10
To enter the "COUNTING MODE" press
simultaneously "MENU" and "CHANGE"
buttons then plug on the machine
- number of coffees made,
- liters of water used.
- number of descaling procedures performed,
- number of washing cycles performed
- number of cappuccinos made.
Display message
“LOAD TEST
MODE”
To enter the "Test Mode" press simultaneously "Short" and "Large"
coffee, then plug on the machine
EV2
"EV2 ON"
Pressing the "Menu" button, the steam valve goes ON.
Grinder motor
"GRINDER ON"
Pressing the "NEXT" button, the grinder goes ON.
Pump
"PUMP ON"
EV1
w
.h
se
nk
i
Device
The pump goes ON. The pump will only vibrate (the pump goes on
only with tank in place and water on it)
ou
"EV1 ON"
Pressing the "OK" button, the discharge valve goes ON.
EV1 ON
EV2 ON
EV1 and EV2 are ON
Infuser motor
Lower limit
"MOTOR
DOWN"
Boiler
“HEATER ON”
Pressing the "Taste" button, the motor will move downwards.
When the infuser will close the lower switch, the motor will stop
and the display will show: "LIMIT SWITCH DOWN" (the motor
will move only with service door closed and coffee ground
container in place)
The coffee heating element goes ON. (check with amperometer the
power consumption)
Steamer
"VAPORIZER
ON"
Pressing the "LARGE COFFEE" button, the
STEAM BOILER goes on.
(check with amperometer the power consumption)
Infuser motor
Upper limit
"MOTOR UP"
Pressing the "ON / OFF" button, the motor will move upwards.
When the infuser will close the upper switch the motor will stop
and display will show: "LIMIT SWITCH UP" (the motor will move
only with service door closed and coffee ground container in place)
ht
tp
://
w
EV1 + EV2
w
Button
tc
he
n.
co
m
Delonghi ESAM3500 & ESAM4500 Test Mode (New models)
DISPLAY TEST mode
Press simultaneously "MEDIUM" and "LARGE"
coffee buttons, then plug on the machine
BUTTON 1
tc
he
n.
co
BUTTON 3
m
BUTTON 2
BUTTON 4
BUTTON 6
BUTTON 7
BUTTON 8
BUTTON 9
BUTTON 10
://
w
w
w
.h
ou
se
nk
i
BUTTON 5
ht
tp
COUNTING MODE
Press “Next” to show data on the display
To enter the "COUNTING MODE" press
simultaneously "MENU" and "CHANGE"
buttons then plug on the machine
- number of coffees made
- number of cappuccinos made
- liters of water used
- number of descaling procedures performed
- number of washing cycles performed
- Sw release power
- Sw release display
Download PDF
Similar pages