Spec Sheet - Restroom Direct

distributed by
704 . 937. 2673
WaterSentry® Fresh
Aesthetic Chlorine, Taste and Odor Replacement Filter
Model WSF6000R
Features include Quick-Disconnect, 1/4 turn installation. Automatic
inlet shut-off valve that closes when filter is removed. Hands never
touch the actual filter media and, therefore, limit the potential for
introduction of bacteria. Outer protective wrap. Spun polypropylene
prefilter mesh to prevent large, coarse sediment and particles from
entering and clogging filter media. High-grade filter is made with
activated carbon media. Radial flow-thru design provides more
surface area for untreated water while final filter mesh prevents
loose carbon from entering water.
Designed to reduce Aesthetic Chlorine, Taste and Odor and
Particulate Class I as verified and substantiated by test data.
Size: 3-1/4” (82.6mm) O.D. x 12-1/2” (317.5mm) length
Water Inlet Connection: 3/8” (9.5mm) O.D. Tube.
Water Outlet Connection: 1/4” (6.4mm) O.D. Tube.
Filter Capacity: 6000 gal. (22,712 L) or 1 year.
Maximum Flow Rate: 1.5 GPM (5.6 L/MIN).
Water Temperature: 40-100°F (4-38°C).
Initial Pressure Drop: 2-5 PSI (14-34 kPa).
Maximum Line Pressure: 105 PSI (724 kPa).
Minimum Line Pressure: 20 PSI (138 kPa).
The filter must be installed in compliance with all state and local laws
and regulations governing the installation and use of this product.
Disconnect electrical power and close water supply valve before
MODEL WSF6000R-2PK is the 2-pack WaterSentry
Fresh replacement filters.
The Filter must be installed in the cold water line.
Flow indicator (arrow) on filter should point in the same direction as
the water flow.
After installing new filter, open water supply valve and check for
leaks. Reconnect electrical power supply. Flush system sufficiently
(approximately 3 minutes) to effectively remove small residue of
carbon fines.
The WaterSentry® Fresh is warranted to be free from
defects in material and workmanship for a period of one
year from date of installation. Warranty is limited to repair
or replacement of defective component.
NOTE: A water shutoff valve (not furnished) should be installed on
the incoming water line to aid in future servicing of filter.
Filter is designed to reduce Aesthetic Chlorine, Taste and Odor.
Do not use with water that is microbiologically unsafe or with
water of unknown quality without adequatedisinfection before
or after the system.
Use on cold water line only. Do not allow installed filter to freeze.
Do not attach hot water line to filter.
Filter should be replaced every 6000 gallons (22,712 liters), or
approximately 1 year after installation.
In keeping with our policy of continuing product improvement,
Elkay reserves the right to change specification without notice.
Please visit elkay.com for the most current version.
This filter has been tested to the following NSF International
standards: NSF/ANSI Standard 42 for Aesthetic Chlorine,
Taste and Odor and Particulate Class I.
2222 Camden Court
Oak Brook, IL 60523
© 2015 Elkay
SPEC00238 (05/2015)
Download PDF