UNPLUG N USE TI DESCALE REGULARLY IMPORTANT NOTICE: PRODUCT FAILURE DUE TO HEN NO W THE BUILD UP OF LIMESCALE IS NOT COVERED BY GUARANTEE - DESCALE REGULARLY: DUALIT RECOMMENDS KILROCK ESPRESSO & COFFEE MACHINE DESCALER. 1 THE DESCALER 2 FILTER HOLDER & NX® HOLDER 3 CONTAINER LER SCA DE TER WA OR Ensure your descaling product is suitable for coffee machines; follow descaling product instructions carefully. Fill Water Tank with the descaling solution. Descale once a month in hard water areas. 4 WATER TANK Place the Holder most frequently used into the machine, ensuring it is empty. If both Holders and Filters are used frequently, cycle between them. Do not soak the holders in descale solution. Ensure they are rinsed thoroughly after descaling. 5 DESCALE Place a container with a capacity of more than 1 litre on the Drip Tray underneath the Holder. Caution: Do not remove the Drip Tray. Remove Froth Nozzle from the Steam Wand. Direct Steam Wand into container. 6 RINSE TANK AND FLUSH TER WA Insert Water Tank. Plug machine in and turn on; wait until machine has reached operating temperature. Caution: Keep hands away from Steam Wand at all times. Turn dial fully to the left and empty half of the tank. Then turn dial completely to the right to dispense the remaining water through the steam wand. WARNING: ensure that the switch is set to water, not steam. Wait 10 minutes for descaling to take effect, prior to stage 6. 19 Once machine is descaled, discard descaling solution. Thoroughly rinse Water Tank and repeat steps 2-5. Flush at least two full tanks of fresh water through the machine, Filters and Steam Wand to remove any traces of descaling solution.