5 in1
Hair & Beard
Trimmer
with accessories
Instruction Manual
V6-160404
Thank you for purchasing your LloydsPharmacy 5 in 1 Hair &
Beard Trimmer. Please read the instruction manual carefully
before use.
Please keep the instruction manual in a safe place for future
reference.
Getting to know your trimmer
Accessories
Large trimmer
attachment
Medium trimmer
attachment
Shaver
attachment
4mm comb
attachment
8mm comb
attachment
16mm comb
attachment
Detail trimmer
attachment
Nose trimmer
attachment
Stainless steel cutting head
(width 38mm)
Side catches for
removing attachments
ON/OFF switch
Comb
Charging display (LED)
Power supply socket
Cleaning
brush
Sissors
Power supply
Charging unit base
Please note:
Avoid extreme temperature changes. Rapid temperature changes (e.g. when the
trimmer is moved from freezing temperatures to a warm room) may cause condensation
inside the unit and a malfunction when it is switched on. In this case, leave the trimmer
at room temperature for at least 1.5 hours before switching it on. If the trimmer has
been in transit, leave it indoors for at least 1.5 hours before use.
Important Safeguards
Please note the following instructions when using the trimmer. Please observe these
instructions in order to prevent damage to the unit or danger arising from improper use.
1. Please read through the following safety instructions carefully before switching
on the trimmer.
2. Before plugging the trimmer into the mains electrical supply check that
the voltage indicated on the product corresponds with the voltage at the mains
electrical socket.
3. The trimmer is designed for domestic use only.
4. Never use the trimmer in the bath, shower or over a wash basin filled with
water. Do not use the trimmer with wet hands.
5. Do not immerse the unit in water or let it come into contact with water, even
during cleaning.
6. Do not drop the trimmer.
7. Always disconnect the power supply unit if the trimmer is not being
charged or used.
8. Do not use the trimmer if its component parts (power supply cord, plug etc.)
are damaged. Do not attempt to repair the trimmer yourself. Contact an
authorised service centre for qualified inspection and repair.
9. The trimmer can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concerning use of
the unit in a safe way and understand the hazards involved. Children shall not play
with the trimmer.
10. Do not open the trimmer under any circumstances. No warranty claims will
be accepted for damage resulting from improper handling.
Features
This trimmer has the following functions:
• Precise hair cutting at a width of 38mm
• Precise beard trimming at a width of 30mm
• Hair or beard trimming with various cutting lengths (4, 8, 16mm) at widths of
38mm or 30mm
• Thinning out hair
• Close shaving
• Nose hair trimming
Using your trimmer
• Remove the protective cover.
• Switch the unit ON.
• Hold the shaving heads close to the skin for an efficient and comfortable shave.
• After shaving, switch OFF the unit, clean it and then replace the protective cover.
Charging your trimmer
Rechargeable battery operation
When operating the trimmer with the built-in nickel metal hydride
battery, only use the power unit supplied for charging. Check that the voltage
indicated on the type plate of the power supply unit corresponds to your local
power supply.
Notes
• Charge up the batteries completely before you use them for the first time or if you
have not used them for a long time.
• Charging time is 7 hours when the trimmer is switched off. If you switch on
the unit while it is charging, charging will stop. The charging display will no longer
light up.
• The ambient temperature should be between 5˚C and 40˚C.
• When fully charged, the unit works for around 45mins. It is recommended that you do
not recharge the batteries after each use, especially if you do not use the appliance for
the full 45 minutes.
• Charge the batteries at your convenience only when they are completely discharged.
This will increase their service life. Avoid charging every day.
3. Place a towel around the neck and shoulders of the person whose hair you are
trimming.
4. Make sure that the person is seated so that his/her head is roughly at your eye level.
5. Before trimming, comb the hair so that it falls naturally and you can see the direction
in which it grows.
6. Press the ON/OFF button to switch on the trimmer and start using.
7. After use, press the ON/OFF button to switch off the grooming unit.
Beard Trimming
Using the medium trimmer attachment (Width 30mm)
Using the charging unit
1. Plug the socket of the trimmer into the charging unit.
2. Plug the power cord into the socket on the charging unit.
3. Plug the power supply unit into the wall socket.
Using your trimmer
Hair Cutting
Using the stainless steel large trimmer attachment (width 38mm)
1. If necessary, remove the attachment by pressing in both side catches
and lifting off.
2. Insert large trimmer attachment carefully at the top and press
down until it clicks into place.
1. If necessary, remove the attachment by pressing in both side catches
and lifting off.
2. Insert the medium trimmer attachment carefully at the top and press down until it
clicks into place.
3. Loosen the beard hair by combing the beard in the direction that the hair grows.
4. Press the ON/OFF button to switch on the trimmer and start using.
5. After use, press the ON/OFF button to switch off the trimmer.
Trimming hair or beards to a certain length
Using the comb attachments (designed for thinning out hair)
Comb 16mm
Comb 8mm
Comb 4mm
1. If necessary, remove the attachment by pressing in both side catches
and lifting off.
2. Insert the medium (30mm) or large (38mm) trimmer attachment carefully
at the top and press down until it clicks into place.
Using the shaver attachment
1. If necessary, remove the attachment by pressing in both side catches and
lifting off.
2. Insert the shaver attachment carefully at the top and press down until it clicks
into place.
3. Press the ON/OFF button to switch on the trimmer and start using.
4. Press the ON/OFF button to switch off the trimmer after use.
Notes:
• Do not apply strong pressure when shaving as this could damage the single blade foil.
• You can remove the single blade foil from the shaving attachment.
• To do this, press both side catches on the shaving attachment. Clean the blade head
with the cleaning brush supplied.
Using the nose hair trimmer attachment
3. Push the comb attachment carefully and firmly onto the rounded rear half of the
cutting head from above and let it click into place.
4. Press the ON/OFF button to switch on the trimmer and start using.
5. Press the ON/OFF button to switch off the trimmer after use.
6. After use, remove the comb attachment by pressing the locking tab at the back.
Note: The comb attachments fit both trimmer attachments.
1. If necessary, remove the attachment by pressing in both side catches and
lifting off.
2. Insert the nose hair trimmer attachment carefully at the top and press down until it
clicks into place.
3. Press the ON/OFF button to switch on the trimmer and start using.
4. Press the ON/OFF button to switch off the trimmer after use.
Use the same procedure for trimming ear hair and shaping eyebrows.
Cleaning and care
• Switch off the trimmer and unplug the power supply unit from the mains
electrical supply.
• Remove the attachment and clean the blade head with the brush supplied.
• If cleaning with the brush is not sufficient, rinse the attachment under running water.
However, only do this once the attachment has been removed.
• The cutting head on the attachment does not normally need to be oiled if you clean
the attachment under running water regularly. However, to maintain the original
condition of the cutting head for as long as possible, it is worth oiling it at regular
intervals with light machine oil.
• Children should not be involved in the cleaning of the grooming unit without adult
supervision.
• Use a soft, dry cloth or the brush supplied to clean the unit housing and the
charging unit.
Caution
• Never put the grooming unit, charging unit or power supply unit in water or any
other liquid.
• Before using the unit again, ensure that all the attachments have been carefully dried
using a soft towel.
• Do not use cleaning agents.
Note
• Remove all clippings after each use.
Environmental note
This product has been made from high-quality parts and material, which can
be re-used and recycled. Therefore, do not dispose of the product along with
normal household waste at the end of its service life. Take it to a collection
point for the recycling of electrical and electronic equipment. This is indicated
by this symbol on the product in the operating manual and on the packaging.
Power supply
Batteries: Nickel metal hydride power supply unit
Specifications
Power: 3W
Rated voltage: 220-240V
Rated frequency: 50hz
Rated current: 0.01A
Warranty
This product is guaranteed for a period of one year from the date of purchase against
mechanical and electrical manufacturing defects. There are no user serviceable parts
inside the instrument. Any attempted repair by unauthorised persons invalidates the
warranty. This does not affect your statutory rights.
An electronic version of this user manual is available for download from
www.lloydspharmacy.com
Information on Waste Disposal for Consumers of Electrical & Electronic
Equipment
This mark on a product and/or accompanying documents indicates that when it is to be
disposed of, it must be treated as Waste Electrical & Electronic Equipment (WEEE). Any
WEEE marked waste products must be mixed with general household waste, but kept
separate for the treatment, recovery and recycling of the materials used. For proper
treatment, recovery and recycling; please take all WEEE marked waste to your Local
Authority Civic waste site, where it will be accepted free of charge. If all consumers
dispose of Waste Electrical & Electronic Equipment correctly, they will be helping to save
valuable resources and preventing any potential negative effects upon human health
and the environment, of any hazardous materials that the waste may contain.
Customer feedback
We are constantly striving to delight our customers with our products and customer
service. We value your opinion and feedback on our 5 in 1 Hair & Beard Trimmer as this
helps us to develop and continually improve our products. We would be grateful if you
would share your thoughts in reviewing this product. Please visit www.lloydspharmacy.com and search for the product page, click on the link and leave your review.
Download PDF