1500FV:Layout 1 - bidonequipment.info

Operating Instructions (7016311)
Relius™ 1500FV Fluid Logic Dispenser
The all pneumatic Relius 1500FV Fluid Logic dispenser is used where hazardous environments prohibit the installation
of electrical powered dispensers.
For pneumatic installation and general operation, refer to the enclosed operation manual. The manual illustrates
hook-up, normal operating procedures, and the use of the vacuum venturi control.
The Relius 1500FV Fluid Logic dispenser, when used with the 5 micron filter/regulator (supplied with the unit), requires
no maintenance. If any problem should occur, please return to EFD for repair.
Most questions you will have are answered in this guide. However, if you need assistance, please do not hesitate to
contact EFD or your authorized EFD distributor.
In Asia, call +86 (21) 3866 9166.
In Europe, call +44 (0) 1582 666334.
In Mexico, call 001-800-556-3484.
In the USA, call 800-556-3484 between 8:30 a.m. and 5:30 p.m. Eastern time.
In all other areas, call your authorized EFD distributor or +1-401-434-1680.
Setup and Operation
Input air pressure (from filter
regulator) should be set at 70
psi (5 kg/cm). Lower or higher
pressures will affect operation.
Relius 1500FV Fluid Logic dispenser
Attach finger switch sensing
hose and adapter assembly
male quick-connect.
Pull out the ON-OFF switch
(green indicator shows air is on.
Input Air to Reservoir
Attach finger switch to barrel,
and tighten knob.
Establish output air pressure
according to material being used.
Time is established by turning the
time control knob — clockwise increases time. Using the test material supplied with the unit, practice adjusting
time to get the “feel” of it. For longer time, turn more clockwise. For very short pulses, turn counterclockwise.
How to Use the Vacuum Control
Making Timed Deposits of Watery-thin Fluids
The vacuum control allows low viscosity liquids, even water, to be consistently dispensed without dripping between cycles.
The vacuum exerts a negative pressure on the liquid in the barrel and prevents dripping.
For these tests, you will use the test barrel with the clear fluid.
1. While holding the barrel upright in one hand, remove the orange end cap and insert the blue LV Barrier.™
Allow an air gap as shown.
2. Attach the barrel to the 10cc adapter. Snap the safety clip tightly closed to prevent
any dripping or bubbling. Remove the tip cap and attach suitable sized tip.
3. Set air pressure at 5 psi, and the time at 0.14 (Fig. 1).
4. Set dispenser timer at approximately 2 sec pulse time.
5. With the barrel pointing downward over a container, unsnap
the safety clip. Then press the foot pedal to fill the tip.
6. If a drop begins to form at the end of the tip, slowly turn the
vacuum control knob counterclockwise to stop the drop from
growing. Wipe the tip and adjust vacuum as necessary.
Normally, only 1 to 2 psi of vacuum pressure is necessary.
Remove
orange
end cap
Insert LV
Barrier™
Air
gap
7. Now set dispenser to desired dispense pulse time.
8. Take the barrel and place the tip on the test sheet. Press
the foot pedal. Check the dot size. Increase or decrease
by adjusting pressure or time.
Remove
tip cap
Internal Schematic – Relius 1500FV Fluid Logic dispenser
Input Air to Reservoir
1
3
4
9
10 12
13
5
27
6
29
10
10
11
11
7
8
16
14
15
28
17 10
19
27
22
14
25
22
23
18
16
20
26
21
26
2
24
11. 7002002
Filter Regulator
15. 7016332
On/Off Indicator
12. 7016350
Foot Pedal Assembly
16. 7016835
1/8 MPT to 1/4 Barb Elbow
13. 7016807
Air Quick Connect, Female
17. 7016334
On/Off Switch
14. 7016806
Air Quick Connect, Male
18. 7016333
Pneumatic Timer
15. 7016849
1/8 Tube
19. 7016352
Subplate for Timer
16. 7016792
1/4 Rigid Tubing
20. 7016337
Quick Connect, Male
17. 7016569
0-100 psi Gauge (0-7 bar)
21. 7016641
Quick Connect Female w/Mtg. Nut
18. 7016576
Regulator 0-100 psi (0-7 bar)
22. 7016787
1/8 MPT to 1/4 Barb
19. 7017016
1/8 MPT-10-32
23. 7016911
Barrel Vacuum Control
10. 7016930
1/8 MPT – Tee 1/4 Barb
24. 7016340
Finger Switch Panel
11. 7016871
1/8 MPT – 1/8 FPT Elbow
25. 7016731
Dispenser End Panel
12. 7016335
Control Valve
26. 7016336
Quick Connect, Female
13. 7020769
Muffler
27. 7016847
10-32 Miniature Barb
14. 7016838
10-32 to 1/4 Barb
28. 7016836
1/8 FPT Elbow to 1/4 Barb