Access Corporate Service Pty Ltd (ACN 142 688 284) (ACORP) warrants its Sabre® products (the Product) against defects in workmanship and materials,
subject to the limitations and exclusions of this warranty.
Different warranty periods apply to different Sabre® products. To find the warranty period that is applicable to your Product please visit our website at The warranty period commences from the date of proof of purchase.
Some Sabre® Products come with a Mechanical Warranty that applies to all of its products to be free from defects in material and workmanship including
mechanical parts or a Finish Warranty applies to external surfaces of products to be free from defects in material and workmanship, tarnishing and
discolouration. Stainless Steel material however may not be free from tarnishing or discoloration. Tea staining does form part of a natural process and without
proper maintenance staining will always occur. The Finish Warranty does not cover tea staining of any stainless steel product. Please refer to our website
above to see whether your Product is covered by a Mechanical Warranty, a Finish Warranty or both and the terms of the warranties.
If within the relevant warranty period the product is found to be defective (within the meaning of the relevant Mechanical or Finish Warranty) and none of the
exclusions as set out in this warranty apply, ACORP will replace (but will not install or repair) the same or equivalent product free of charge.
If the Product does not appear at then no warranty other than any applicable Statutory Guarantees applies.
This warranty does not cover:
damage caused by or resulting from:
negligent use, misuse or improper installation of the Product; or
use contrary to any installation specifications of the Product; or
normal wear and tear of the Product; or
use or any failure or defect of structures upon which the Product has been applied; or
acts of God, lightning or natural disasters or other cause beyond the direct control of Sabre® including without limitation indirect and
consequential losses or expenses suffered by the Customer; or
corrosion when a the Product is used in a high corrosive environment; or
any other cause other than defective materials or labour.
a Product if it has:
been modified or repaired; or
not been maintained as recommended by ACORP.
personal injury, property damage or economic loss, however caused.
claims of warranty made outside 30 days from the Customer becoming aware of the defect or from when a reasonable person should have become
aware of the defect. This enables ACORP to promptly act and avoids further damages.
claims not accompanied by appropriate documentation evidencing the date of installation, the invoice number, the customer name and address and
the alleged defect.
the costs incurred for the:
removal and/or installation of the Product; or
travelling time.
ACORP reserves the right to alter Sabre® product specifications and introduce improvements at any time.
Statutory Guarantees
Nothing in this warranty shall be interpreted as excluding or restricting the legal obligations of liability of ACORP for guarantees that cannot be excluded
under the Australian Consumer Law and shall be read subject to the provisions of the Competition and Consumer Act 2010 (Cth) (Statutory Guarantees).
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
The Warranty set out in this document is additional to any applicable Statutory Guarantees.
Any provision in this warranty which is unenforceable or partly unenforceable, is to be severed where possible to the extent necessary to make these terms
enforceable, unless this would materially change the intended effect of the terms of the warranty.
Warranty Service
Warranty service is available by contacting ACORP’s service agent, Access Hardware Pty Ltd on the details below and by providing any reasonable details
Access Hardware Pty Ltd may require to verify and support the warranty.
Head Office:
Access Hardware Pty Ltd
74-92 Gracie Street
North Melbourne VIC 3051
(03) 9329 8833
For the avoidance of doubt Access Hardware Pty Ltd is the service agent of ACORP only and the warranties provided under this policy are provided by
ACORP only and not by Access Hardware Pty Ltd.
ACORP will reimburse the person claiming the warranty for the reasonable costs of transporting the Product to ACORP head office for warranty assessment
and for the delivery costs to supply the replacement product, only if ACORP accepts a warranty claim. If a warranty claim is not accepted the person claiming
the warranty will have to collect the Product or have the Product otherwise returned at their own costs.
Sabre Architectural Warranty
Page 1 of 1
September 2013
Download PDF