User guide
VH700
VH700VH700
Contents
1......................................................................................................... 3
2......................................................................................................... 4
Headset overview.............................................................................. 4
Introduction........................................................................................4
Charging.............................................................................................4
Turning on and off.............................................................................. 4
Pairing the headset............................................................................ 5
Multipoint........................................................................................... 5
Call handling...................................................................................... 5
Battery................................................................................................6
Resetting the headset........................................................................ 6
Troubleshooting................................................................................. 7
Industry Canada Statement............................................................... 7
Declaration of Conformity for VH700.................................................8
2
1
3
This is an internet version of this publication. © Print only for private use.
2
Headset overview
See illustration 1.
1
Microphone
2
Call handling key
3
Microphone
4
Volume keys
5
Charger connector
6
Clip
7
On/off key
8
Indicator light
Introduction
The Bluetooth™ Noise Shield Handsfree VH700 can be connected to any device with
Bluetooth wireless technology that supports the headset or headset profile. This User
guide focuses on use with a Sony Ericsson mobile phone.
Charging
Before using the headset for the first time, you need to charge it with the supplied
charger for 8 hours. See illustration 2. The normal charging time is 2.5 hours. Use
Sony Ericsson chargers only.
Turning on and off
•
To turn on the headset
Press and hold down until the indicator light shows a steady green or red
light. If the light is red, the headset needs charging. After 3 seconds, the light
turns off and the headset is on.
•
To turn off the headset
Press and hold down until the indicator light shows a green or red light. If the
light is red, the headset needs charging. After 3 seconds, the light turns off and
the headset is off.
4
This is an internet version of this publication. © Print only for private use.
Pairing the headset
Pairing the headset with a phone
To use the headset with a phone, you need to pair the headset with the phone. After
successful pairing, the headset connects automatically to the phone as soon as the
headset is turned on and within range.
To pair the headset with a phone
1
2
3
4
5
6
7
8
Make sure the headset is turned off.
Turn on the Bluetooth function in the phone. For instructions, see the phone
User guide.
Turn on Bluetooth visibility in the phone. This makes the phone visible to other
Bluetooth devices.
Place the phone within 20 cm (8 inches) of the headset.
Press and hold down on the headset for about 5 seconds until the indicator
light flashes green and red alternately.
Auto pairing in your phone: When asked to add the VH700, follow the
instructions that appear.
Normal pairing in your phone: Search for and add a new device.
If a passcode is required, enter 0000.
Pairing the headset with another phone
To use the headset with another phone, you need to pair the headset with the phone.
After successful pairing, the headset connects automatically to the phone as soon as
the headset is turned on and within range.
To pair the headset with another phone
1
2
3
4
5
6
Make sure the headset is turned off.
Turn on the Bluetooth function in the other phone. For instructions, see the
phone User guide.
Place the other phone within 20 cm (8 inches) of the headset.
Press and hold down on the headset for about 5 seconds until the indicator
light flashes green and red alternately.
In the other phone: Search for and add a new device.
If a passcode is required, enter 0000.
Multipoint
With this feature, you can use the headset with two different phones at the same
time. Before you use this feature, you need to enable it.
To enable the multipoint feature
1
2
3
4
Make sure the headset is turned off.
Press and hold down on the headset until the indicator light flashes green
and red alternately.
Multipoint mode: Press and hold down the plus sign on the volume key. Two
orange flashes on the indicator light shows that multipoint has been enabled.
Singlepoint mode: Press and hold down the minus sign on the volume key. One
orange flash on the indicator light shows that singlepoint has been enabled.
When the headset is in multipoint mode, you cannot answer a second call on the same phone.
Call handling
•
To make a call
Dial the number using the phone keys. The call is automatically activated in the
headset.
5
This is an internet version of this publication. © Print only for private use.
•
To end a call
Press the call handling key briefly.
•
To answer a call
A beep indicates an incoming call. Press the call handling key briefly.
•
To reject a call
Press and hold down the call handling key until you hear a short beep (after 2
seconds).
•
To re-dial a number
Double-click the call handling key.
•
To answer a second call
Press the call handling key. The ongoing call is put on hold.
•
To switch between two calls
Press and hold down the call handling key until you hear a beep.
•
•
To mute the microphone during a call
Press both volume keys simultaneously. A beep indicates that the microphone
has been muted. To turn on the microphone again, press both volume keys
simultaneously.
To change the ear speaker volume
During a call, press a volume key.
Transferring sound
•
•
To transfer the sound from the headset to the phone
See Transferring sound to and from a Bluetooth handsfree in the phone User
guide.
To transfer the sound from the phone to the headset
During a call on the phone, press the call handling key briefly.
Battery
A battery that has been infrequently used, or a new one, could have reduced
capacity. You may need to recharge it a number of times. When the battery level is
low, the indicator light flashes red and you hear a low beep. If you do not charge the
headset, it turns off after 10 minutes.
Resetting the headset
Reset the headset if it behaves unexpectedly. Resetting the headset removes all
information about paired devices.
•
•
To reset the headset
Press and hold down
for 10 seconds.
To reset the headset to factory settings
Simultaneously press and hold down and the call handling key during pairing
mode.
6
This is an internet version of this publication. © Print only for private use.
Troubleshooting
Redial does not work
•
•
•
Make sure the call list in the phone is not empty.
Make sure the correct calling device is selected.
Make sure your phone or other device supports the Bluetooth handsfree profile.
The headset is automatically turned off
•
•
The battery level is too low. You hear a beep approximately 10 minutes before the
headset turns off. Charge the battery.
The headset turns off if you do not pair it with the phone within 10 minutes.
Unexpected behaviour
•
Reset the headset.
No connection to the phone
Make sure the headset is charged and within range of the phone. We recommend a
maximum distance of 10 metres (33 feet) with no solid objects in between. Check or
reset the Bluetooth settings in the phone. Pair the headset with the phone again.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Any change or modification not expressly approved by Sony may void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Statement
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
7
This is an internet version of this publication. © Print only for private use.
Declaration of Conformity for VH700
We, Sony Ericsson Mobile Communications AB of
Nya Vattentornet
SE-221 88 Lund, Sweden
declare under our sole responsibility that our product
Sony Ericsson type DDA-0002026
and in combination with our accessories, to which this declaration relates is in
conformity with the appropriate standards EN 300 328:V1.7.1, EN 301 489-7:V1.3.1,
EN 301 489-17:V2.1.1 and EN 60 950-1:2006 following the provisions of, Radio
Equipment and Telecommunication Terminal Equipment directive 1999/5/EC.
Lund, January 2010
Jacob Sten,
Head of Product Business Unit Accessories
We fulfil the requirements of the R&TTE Directive (1999/5/EC).
Sony EricssonVH700
Prior to use, please read the Important information leaflet separately provided.
This User guide is published by Sony Ericsson Mobile Communications AB or its local affiliated company,
without any warranty. Improvements and changes to this User guide necessitated by typographical errors,
inaccuracies of current information, or improvements to programs and/or equipment, may be made by
Sony Ericsson Mobile Communications AB at any time and without notice. Such changes will, however, be
incorporated into new editions of this User guide.
All rights reserved.
©Sony Ericsson Mobile Communications AB, 2010
Publication number: 1239-2763.1
Bluetooth is a trademark or a registered trademark of Bluetooth SIG Inc. and any use of such mark by
Sony Ericsson is under license.
Interoperability and compatibility among Bluetooth™ devices varies. Device generally supports products
utilizing Bluetooth spec. 1.2 or higher, and Headset or Handsfree profile.
The Liquid Identity logo is a trademark or registered trademark of Sony Ericsson Mobile Communications AB.
Sony and "make.believe" are trademarks or registered trademarks of Sony Corporation.
Ericsson is a trademark or registered trademark of Telefonaktiebolaget LM Ericsson.
8
This is an internet version of this publication. © Print only for private use.
Download PDF