STYLEVIEW®
QUICK REFERENCE
RANGE OF MOTION
20"
(508 mm)
CAUTION! Completely release brake engagement
before raising or lowering the cart. Raising or
lowering the cart with the brake partially engaged
may cause product damage.
20˚
5˚
+12˚
Loosen knob, tilt Display
to desired position then
retighten knob.
16”
(406 mm)
180˚
5" (127 mm)
12˚
3x
KEYBOARD LIGHT
Your computer must be on for this light to function.
Keyboard Light will automatically turn off after 15
minutes if not manually turned off.
Wheel Rotation
Wheel Rotation and Swivel
ERGONOMICS
Working - customize to your size
1 Set top of monitor screen about one inch below eye level - Release brake and lift or
lower riser as needed.
2 Tilt screen for comfortable viewing and to reduce eye and neck strain.
3 Pull keyboard tray forward and position mouse tray and mouse pouch on right or
left, as needed.
4 Work with elbows bent at about 90° to minimize muscle strain.
5 If the riser moves up and down with difficulty, or if it drifts out of set position,
consult the product manual for adjustment information.
6 Stay in charge!
Powered carts should be plugged
1
into outlet as often as possible to
keep battery charged and computer
2
running.
4
3
Locked
Moving - stow before you go
1 During normal movement, release brake and lower worksurface to lowest
position for optimal stability and unobstructed view.
2 Tuck away open trays and return mouse, scanner and other accessories to
their places. Clear worksurface
3 Unlock both front casters.
4 Push cart from rear with elbows bent at about 90° to maximize control and
minimize muscle strain.
5 Don’t run out!
Before moving, make sure
cord is unplugged from
outlet and hooked to basket
for safe travel. Remember,
1
charge battery fully 100%
every day!
4
5
5
2
6
3
EN
777-24-049-G-01 rev.D • 08/17
STYLEVIEW®
QUICK REFERENCE
Unlock Drawer (2 methods): NOTE: All Drawers in row must be closed before a new row can
be unlocked.
• Enter User PIN and press ENTER (only numbers for available drawer rows flash green), then press
desired drawer row number*.
• Key
*Drawer Row Numbers:
1
1
1
2
1
1
2
2
Lock Drawer:
• Wait 4 seconds for lock to engage automatically.
NOTE: Always ensure drawer is pushed in all the way and engaged with lock.
2
3
CAUTION: Open only one drawer at a time. Do Not push cart when drawers are open. Failure to follow these
instructions may cause the cart to be unstable.
This power system interface will alert you to the percentage of charge remaining in the cart battery with a series of steady
or flashing red, yellow or green lights, and an alarm that will beep when charge gets below 30%. Remember, the battery
needs to be charged to 100% every day, and you can use the cart while charging, so plug-in cord as often as possible to avoid
running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
Battery has 100% charge.
Light flashes when charging (power cord plugged into wall outlet)
Allow battery to continue charging until light stops flashing. After
light stops flashing, it is OK to unplug the power cord from the wall.
You can use cart while charging.
Battery has less than 90% charge.
Battery has less than 70% charge.
Battery has less than 50% charge.
When lit, alarm is
enabled and will beep
when battery charge
gets below 30%. For
details on enabling
and disabling alarm
contact Ergotron
Customer Care.
Battery has less than 30% charge. Light is red and alarm beeps.
Plug-in power cord and charge to 100%! You can use cart while
charging.
Alarm Mute button. Pressing this will temporarily mute alarm.
Power button for internal power system outlets. Pressing this will
provide or remove power to/from components plugged into the
internal outlets.
When lit, the power
system is on. When
dark, power system
is off.
NOTE: Frequent operation of the cart while battery charge levels are below 30% will significantly reduce
the life of your battery.
EN
777-24-049-G-01 rev.D • 08/17
Download PDF

advertising