Machinery container
Ordering information
Machinery container
Several configurations and options possible. Ask IHC Hytech for more information.
An additional machinery container can be necesarry, for
example for the high pressure air supply. The following information is an example of a typical machinery container. If
you have other wishes don’t hesitate to contact IHC Hytech.
We can give you information or a quotation fitting your
specific requirements.
The system will be delivered as a working unit. All tested
and ready to set to work.
Description of the container
All the components are placed within the contours of the
container, so no out-sticking parts. The container is outfitted
with an umbilical junction/connection panel on the outside of the container to which the electrical power supply
cables, diving umbilicals, oxygen & therapeutic gas supplies
can be connected.
V-A
The container is outfitted with two sets of (standard) double
entrance doors positioned. Several positions are possible:
in the front, side and rear end (to bring in the DDC for
example).
Electro sytem
The container is complete with a basic electro system,
which contains the following:
• Mains power input 3 x 440 volt - 60 cycles
• Power transformer box from 440 volt – 60 cycles to secondary power 240 volt Single Phase System (240V, 60Hz)
• 3 x double TL lighting sources mounted onto the ceiling in
the container compartment
• Power Sockets (4x)
• Electrical Connection box for the decompression chamber power supply.
Other outfitting
• Emergency Lighting will be installed inside the container.
• The container will be outfitted with a stainless steel penetrator panel – gas inward & electrical supply.
• The container will be outfitted with a back-up / UPS
• The container will be equipped with a foam fire extinguisher
• The container will be delivered with a certified 4-legged
lifting sling complete with aster Link
• The container will be painted white on the inside, and the
outside colour (RAL) to be discussed later on.
Additional information components
Escape hatch
An escape hatch can be integrated in the container
wall, for emergency escape in case the normal exits is
blocked.
Cast floor
A liquid proof cast floor will be installed in the entire
container floor surface.
Container heating system
An electrical heating system to warm the inside of the
container and to be used for stand heating during nonoperation periods can be installed for the comfort of the
operator(s).
Insulation of 20ft Container
In order to maintain the temperature inside the container, the unit is isolated installed against all walls,
and the ceilings, using stone wool, covered with steel
cladding (smooth surface).
Air-conditioning system for the container
The chamber is outfitted with one split unit AC’s integrated in one of the sides of the container, complete with
protection covers for transport.
Fire-fighting system in the container
In the container / against the ceiling, we will install
a central water supply line, complete with a number
of sprinkler nozzles, providing a water spray pattern
which covers the DDC inside the container This sprinkler
system is to be connected to an external water supply
system (not included in our scope)
Emergency breathing apparatus for operator
For the IMCA guidelines the breathing apparatus sets
are required. The Interspiro full-face mask is an emergency breathing apparatus fitted with integrated speech
diaphragm. It is meant for the operator so that he may
perform his duties in a smoky or polluted atmosphere. It
comes complete with a small manifold to connect to the
HP air bank, with second stage, speech diaphragm and
cone, and a two metre LP hose with fitting to connect it
to an air cylinder (such as the HP air bank.
Cabinets/storage
The container will be outfitted with storage cabinets.
Umbilical storage bracket are available.
Smoke / fire detection
IHC Hytech can equip the container with the wiring for
the smoke / fire detection.
DP Alarm
IHC Hytech can equip the container with the wiring for
the DP Alarm.
Example high pressure compressor
Type: Bauer Mariner 320 or comparable.
The compressor will firmly be mounted on the floor.
Filling panel
In the container we can install a filling manifold with 4x hose
connections to charge scuba / diving cylinders.
High pressure air bank
DDC
A decompression chamber is already outfitted with 10 pcs
high pressure air cylinders, all connected with manifolds and
outfitted with high pressure regulators / reducers (mounted
underneath the DDC). Additionally we can install in the machinery container another 10 pcs. 50 liter / 200 bar breathing air
storage cylinders which will be connected to the high pressure
air bank installed underneath the decompression chamber
These high pressure breathing air storage cylinders will be
installed to the container wall by means of heavy duty cylinder
clamps. All air banks to be connected with the high pressure
breathing air compressor by means of heavy duty hard piping
and fittings/manifolds/insulation valves-, etc.
Divers + standby diver
In the container we can also install 10 pcs. 50 liter / 200 bar
breathing air storage cylinders which will be connected to
the primary air supply of the diving control panel for diver 1.
Also another 10 pcs. 50 liter / 200 bar breathing air storage
cylinders which will be connected to the primary air supply of
the diving control panel for diver 2. And another 4 pcs. 50 liter
/ 200 bar breathing air storage cylinders which will be connected to the primary air supply of the diving control panel for the
standby diver.
These high pressure cylinders will be installed to the container
wall by means of heavy duty cylinder clamps. All air banks to
be connected with the high pressure breathing air compressor
by means of heavy duty hard piping and fittings/manifolds/
insulation valves-, etc.
Example low pressure compressor
Type: SCK-30-8 LP compressor or comparable
• Including an Airdryer + Cooler
• Approx. 22 KW
• 1 x Air receiver of 500 liters (CE approved)
• For additional costs we can supply a Lloyds Certified Air
receiver
• LP Breathing Air filtration system
All rights reserved. Reproduction in any form or by any means is not allowed,
without prior permission in writing from IHC Hytech BV
Compressors
In a machinery container several compressors can be installed:
high pressure breathing air compressors and LP compressor +
air receiver and air filtration system.
IHC Hytech BV
Elftweg 3, 4941 VR, Raamsdonksveer
The Netherlands
T +31 162 52 22 02
F +31 162 51 90 69
hytech@ihcmerwede.com
www.ihcmerwede.com
www.ihchytech.com
Download PDF

advertising