3-IN-1 BATTERY TESTER
OWNER’S MANUAL —
2210103
Before installing and using the product, please read the instructions thoroughly and retain them for future reference.
GENERAL DESCRIPTION
contacts 10 and 11, make sure that the
positive terminal of the battery is connected to the contact 11 and the negative
terminal of the battery is connected to the
contact 10.
2.Use and read the “9V“ scale. The green
area indicates that the battery is good.
The yellow area indicates that the battery
is low. The red area indicates that the battery is very low and should not be used.
Figure 1
This tester is designed for testing
batteries, bulbs and fuses. It can be
used to test dry cell 1.5V batteries
(AAA, AA, C, D, etc.), 9V batteries,
household and automotive fuses, as
well as various bulbs. Powered by a
9V battery (not included).
DIAGRAM
1, 4 Metal contacts for testing
1.5V batteries (The metal
contact 1 is connected with
a spring for easy use).
2, 3 Metal contacts for
testing fuses
Testing fuses:
1.Refer to Figure 4, connect the two terminals of the fuse to be tested to the metal
contacts 2 and 3.
2.Use and read the “Test continuity” scale.
If the pointer is in the green area, the fuse
is good. If the pointer is in the red area,
the fuse is in open circuit state.
7, 8, 9 Metal contacts for
testing bulbs
10, 11 Metal contacts for
testing 9V batteries
Figure 2
5 Scales
Storage compartment cover
13 Storage for fuses and bulbs
OPERATION INSTRUCTIONS
Installing the battery
Slide out the battery cover located on
the rear of the tester. Connect a new 9V
battery to the cable. Place the battery into
the battery compartment and reinstall
the battery cover. (Tip: You can test the
battery to determine whether it is high or
low by using this tester).
Testing 1.5V Batteries
(AAA, AA, C, D, etc.):
1.Refer to Figure 2, connect the 1.5V
battery to be tested to the metal
contacts 4 and 1 (see Figure 1), make
sure that the positive terminal of the
battery is connected to the contact 4
and the negative terminal of the battery
is connected to the contact 1.
2.Use and read the “1.5V“ scale. The
green area indicates that the battery
is good. The yellow area indicates
that the battery is low. The red area
indicates that the battery is very low
and should not be used.
Testing 9V Batteries:
1.Refer to Figure 3, connect the 9V
battery to be tested to the metal
Fuse
Figure 5
Testing Bulbs:
1.Connect the two terminals of the bulb
to be tested to the contacts 8 and 9,
or to the contacts 7 and 9, depending
on the type of the bulb.
2.Use and read the “Test continuity”
scale. If the pointer is in the green
area, the bulb is good. If the pointer
is in the red area, the bulb is in open
1.5V
circuit state.
battery
Bulb
6 Pointer
12 Figure 4
SPECIFICATION OF BATTERY TEST
Figure 3
9V
battery
Range
Red =
Replace
Yellow =
Low Power
Green =
Good
1.5V
< 0.95V
0.95 ~ 1.10V
>1.1V
9V
<5.6V
5.6 ~ 6.6V
>6.6V
WARNING
1.Batteries can be life-threatening if swallowed. Store batteries and tester
out of the reach of children.
2.Remove the battery from the tester when the battery is discharged or if
you will not use the tester for an extended period of time.
3.Do not expose batteries to heat or discard into fire.
4.Always select the correct battery for your device to ensure safe operation.
THE SOURCE – WARRANTY
The Source warrants that this product will be free from defects in materials and
workmanship for a period of twelve (12) months from the date of purchase. Within
this period, simply take the product and your proof of purchase to any The Source
store or participating dealer and the product will be replaced (where available)
without charge. Any product which has been subject to misuse or accidental damage
is excluded from this warranty.
This warranty is only applicable to a product purchased through The Source
company-owned stores or participating dealers in Canada where the warranty is
included with the product. While this warranty does not confer any legal rights other
than those set out above, you may have additional statutory rights which will vary
under the laws of the various countries, states, provinces and other governmental
entities in which The Source operates. This warranty is subject to all statutory rights
you may have in Canada.
Imported by The Source
Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
For product support please visit www.thesource.ca
© 2015 The Source
All rights reserved.Please Recycle
Download PDF

advertising