Box Fan with Humidifier

Box Fan with Humidifier
Owner’s Guide
English
Model
N6SY
61401-01
20150202
CONTENTS
........................................................................ 3
............................................................................... 3
Safety Precautions ........................................................................ 4
Fused Plug ................................................................................... 5
Operating Instructions .................................................................. 6
Cleaning and Maintenance ........................................................... 8
Technical Support ......................................................................... 8
Warranty..................................................................................... 9
Products .....................................................................................10
61401-01 20150202
2
PARTS IDENTIFICATION
2
1
3
Parts of the Box Fan
1
Function Switches
2
Display Screen
3
Fan Body
4
Mist Plate
5
Water Tank Panel
6
Base
7
Caster
4
5
6
7
SPECIFICATIONS
Voltage
120V~
Frequency
60Hz
Fan Power
65W
Mist Power
35W
Total Power
100W
Fan Sweep Size
12 inch
Water Tank Capacity
45 oz
61401-01 20150202
3
SAFETY PRECAUTIONS
READ AND SAVE THESE INSTRUCTIONS! Read this entire manual before operating
this product. When using electrical appliances, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and personal injury, including the following:
WARNING: This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this safety feature.
RULES FOR SAFE OPERATION:
1. Use this fan only for purposes described in this manual.
2. This fan is intended for household use only and not for outdoor, commercial or industrial use.
3. This fan is not intended for use in kitchens.
4. To protect against electric shock, do not place fan in a window, immerse unit, plug or cord in
water or spray with liquids.
5. Close supervision is necessary when any appliance is used by or near children.
6. This appliance is not intended for use by persons (including children) with reduced physical,
sensory for mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
7. DO NOT insert fingers or any objects through the grill guard when fan is in operation.
8. DO NOT operate this unit without fan guards properly locked. Avoid contact with moving
parts.
9. DO NOT operate in the presence of explosive and/or flammable fumes.
10. DO NOT place fan or any parts near an open flame, cooking or other heating appliance.
11. DO NOT hang or mount fan on a wall or ceiling.
12. Unplug from outlet when not in use, when moving fan from one location to another, before
putting on or taking off parts, and before cleaning.
13. DO NOT let the cord hang over the edge of a table, counter or come into contact with hot
surfaces.
14. DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. DO NOT route cord under furniture or appliances. Arrange cord away from
traffic areas and where it will not be tripped over.
15. DO NOT operate fan with a damaged cord or plug, after a malfunction or if it has been
dropped/damaged in any manner. Discard fan or return to an authorized service facility for
examination and/or repair.
16. To disconnect, grip the plug and pull from wall outlet. Never pull on the cord.
17. When inserting the rolling casters into the bottom of the unit, please note there will be
approximately a 1/8” space between the base of the unit and the ring on the caster when
they are installed. Do not over insert the casters.
18. Always use on a dry, level surface.
19. To reduce the risks of fire, electric shock, or injury to persons that may exist due to use of
the product. User should place the product and connected cord so that the product is not
likely to be upset.
20. To reduce the potential risk of electric shock due to overfilling or cleaning the product and
removal of the heating element portion of the product. User should disconnect the
power-supply cord.
61401-01 20150202
4
FUSED PLUG
This plug is a safety feature. It contains a safety
device (fuse) that should not be removed. Discard
the product if the attachment plug is damaged. To
injury, DO NOT remove, replace, repair or tamper
with the originally supplied plug. If the fan does
not function properly, it may be due to the safety
device incorporated in this plug.
If the fuse fails, it is generally due to a short circuit
or circuit overload. Replace the fuse as per the
instructions below. If the replacement fuse fails,
immediately unplug the unit and contact our
technical support department for assistance.
Figure 1.
FUSE REPLACEMENT:
1. To replace the fuse, first turn the unit off and unplug
it from the wall. Locate the door on top of the plug.
Grasp plug and remove from the receptacle or other
outlet device. Do not unplug by pulling on cord. Figure 1.
2. Slide the door on top of the plug towards the blades.
Figure 2.
3. Carefully remove the fuse from the clips holding it on the
top and bottom. Figure 3.
Figure 2.
Warning! Electrical Hazard! Only replace with a fuse type
and rating matching what was removed from the product. If
the product fails a second time, immediately unplug it and
contact our technical support at 1-888-880-3267.
4. Gently push the fuse back into the pins that will hold it in
place.
Note: If the fuse is not seated properly, the unit will not function.
5. Slide the door back over the fuse box in the plug.
6. Plug the fan back in and resume use.
Figure 3.
61401-01 20150202
5
OPERATING INSTRUCTION
This model is novel and attractive with luxurious appearance, reasonable features, and
easy operation. It has both fan and humidifier functions blowing cool mist that may be
used together or separately. This fan uses ultrasonic vibration components, atomizes the
water to 1 - 5 micron particles and spreads the mist into the air through the wind. This
function increases the cool humidity which makes you feel cool in a single room or in the
entire home.
FAN OPERATION
Set the fan base on a dry, level surface. Plug cord
into any standard 120 volt AC outlet, the indicator
light
on the control panel (Figure 4) will be lit.
The fan is ready for use and can be controlled by
using the remote control or the buttons on the
control panel on the fan body.
Figure 4
1. Press "ON/SPEED" button to turn on the fan and to
choose the wind speed: Low, Medium or High. The LED screen on the control panel will
indicate the fan speed selected.
2. Press "PIVOT" button to change the wind direction, meanwhile the corresponding light
will be lit. Press this button again to stop oscillation.
3. Press "WIND" button to choose the wind type, meanwhile the corresponding light will be l
lit.
"Normal": Wind blow based on Low/Medium/High speed.
"Natural": Imitates the natural fluctuations in speed of wind.
"Sleeping": In the first half an hour, the fan runs as strong and soft natural wind, and
then it becomes medium natural wind in the second half an hour. After the hour, it
changes to soft natural wind until the end of preset time.
4. Press "TIMER" button to set the timer function. This fan is equipped with an automatic
shut off feature. To select desired length of operation hours, press the Timer Button a
number of times until the LED displays the desired operation time (from 1 hour to 7 hours,
in 1-hour increments).
5. Press "MIST" button and the corresponding light will be lit. Mist will spread out of the
front mist plate.
6. Press "FAN STOP" button, it switches off the fan and all fan functions return to initial
condition.
REMOTE CONTROL (Figure 5)
The remote control must be directed at the infrared port on the fan
body. If the remote control does not operate well, please check the inside
batteries first, and change with new batteries if needed. Your remote
control uses two (2) “AAA” batteries (not included) for operation.
Notes: Change the batteries with new and same types. Otherwise your
remote control may not operate properly. Remove the batteries out of the
remote control if you won’t use the remote control for a long time.
Figure 5
Remaining batteries may damage your remote control.
61401-01 20150202
6
OPERATING INSTRUCTIONS(CONT.)
WATER TANK
Stabilize the mist fan on the ground and add water into the water tank according
to the six steps below:
Note: Remove and discard the protective foam on the
top of the water tank during the first use.
Important: Do not take out the water tank before
unplugging the power cord. Do not add hot water
(104°F / 40°C or above) into the tank.
Figure 6
1. Loosen the locking screw on the water tank panel.
Open the panel. Figure 6.
2. Lift the water tank. Figure 7.
Figure 7
3. Take out the water tank horizontally. Figure 8.
4. Put the water tank base up. Figure 9.
Figure 8
5. Screw off the tank cap and add water. Then screw
back the tank cap. Figure 10.
Figure 9
6. Put the water tank back into the fan, then close the
water tank panel and tighten with the locking screw.
Figure 11.
Figure 10
Important: Remember to tighten back the
locking screw on the water tank panel after
adding water to the water tank.
Figure 11
61401-01 20150202
7
CLEANING AND MAINTENANCE
1. Disconnect the power cord plug from the electrical outlet
and make sure that your fan is not operating before
beginning any such service or cleaning operation.
2. During cleaning the product including any need for
disassembly (and reassembly) and any need not for the
use of additives. Clean the water tank every two or three
weeks, and clean the flume every week. Figure 12.
3. Take out the water tank when cleaning the fan, and pull
plastic tube out of the atomizing cup properly, then take
out the atomizing cup and clean them. Figure 13.
Water tank
Figure 12
Figure 13
4. Use a dry cloth to absorb water remaining when cleaning
the atomizing cup, and dry it using a piece of soft cloth.
You may use mild detergent to clean the atomizing cup if
the water is dirty. Figure 14.
5. Please add a few drops of lubricant to the motor shaft after
cleaning to extend motor life every year. Figure 15.
Water
overflow hole
Figure 14
6. Pack the unit properly and store it in a cool dry place if you
are not using it for a period of time.
7. After cleaning, all safety devices (including water tank panel,
grills and blades) must be reinstalled or remounted as
previously installed.
Figure 15
TECHNICAL SUPPORT Figure
12.
If you have any additional questions or problems with your Hunter Box Fan,
please call:
USA: 1-888-880-3267
We open 24 hours a day, 7days a week. You may also reach us online at
www.HunterHomeComfort.com.
An electronic copy of this user manual can also be obtained online at
www.HunterHomeComfort.com.
61401-01 20150202
8
WARRANTY
Hunter Home Comfort makes the following limited warranty to the user or
consumer purchaser of this Hunter Box Fan:
If your Hunter Box Fan motor fails at any time within one year after the date
of sale to you due to a defect in material or workmanship, labor to repair the
defect will be provided free of charge at our nearest service center or our Service
Department in Marietta, Georgia. You will be responsible for labor costs after
this one-year period. The foregoing limited warranty applies only to the motor
itself, and does not apply to electronic controls such as remote controls, remote
control receivers or transmitters used in conjunction with the motor. These
electronic control items are included in the one year limited warranty below.
If any part of your Hunter Box Fan other than the motor fails at any time
within one year after the date of sale to you due to a defect in material or
workmanship, we will repair or, at our option, replace the defective part free
of charge for parts and labor performed at our nearest service center or at our
Service Department in Marietta, Georgia.
IF THE USER OR CONSUMER PURCHASER CEASES TO OWN THE FAN,
THIS WARRANTY AND ANY IMPLIED WARRANTY WHICH THEN REMAINS
IN EFFECT, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE VOIDED.
NO WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS MADE IN
RESPECT TO THE GLASS GLOBES OR LIGHT BULBS OR THE FINISH ON ANY
METAL PORTION OF THE FAN. THIS WARRANTY IS IN LIEU OF ALL OTHER
EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY,
INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IN RESPECT
TO ANY HUNTER FAN MOTOR OR OTHER FAN PART, IS EXPRESSLY LIMITED
TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE FOR SUCH
MOTORS AND OTHER PARTS.
This warranty is voided if your Hunter Fan is not purchased and used in the USA.
This warranty excludes and does not cover defects, malfunctions or failures of
any Hunter Box Fan which were caused by repairs by persons not authorized
by us, use of parts or accessories not authorized by us, mishandling, improper
installation, modifications, or damage to the Hunter Box Fan while in your
possession, or unreasonable use, including failure to provide reasonable and
necessary maintenance.
To obtain servicing, contact the nearest Hunter authorized service center or the
Hunter Home Comfort Service Department, 1831-A West Oak Parkway, Marietta,
61401-01 20150202
9
Georgia, 30062, Please contact us before shipping your fan to us. If we authorize
you to ship it to us, you will be responsible for all insurance and freight or other
transportation charges to our factory service center. We will return your Hunter Fan
freight prepaid. Your Mist Fan should be properly packed to avoid damage in
transit since we will not be responsible for any such damage. Proof of purchase is
required when requesting warranty service. The purchaser must present sales
receipt or other document that establishes proof of purchase.
IN NO EVENT SHALL HUNTER HOME COMFORT BE LIABLE FOR CONSEQUENTIAL
OR INCIDENTAL DAMAGES.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS OR THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATION MAY NOT APPLY TO
YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
PRODUCTS
To learn more about Hunter Home Comfort products, please see our Web page at:
www.HunterHomeComfort.com
1831-A West Oak Parkway, Marietta, GA 30062
Hunter is a trademark of the Hunter Fan Company and
is used under license to Hunter Home Comfort.
Printed in China
61401-01 20150202
10
Download PDF

advertising