HD4070
Software Upgrade
Kit # 128709
Field Service Bulletin
(P/N 804330)
Revision 1 - November, 2002
Hypertherm, Inc.
Hanover, NH USA
www.hypertherm.com
© Copyright 2002 Hypertherm, Inc.
All Rights Reserved
Hypertherm and HD4070 are trademarks of Hypertherm, Inc.
and may be registered in the United States and/or other countries
HD4070 SYSTEM UPGRADE
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect electrical power before performing any maintenance.
All work requiring removal of the power supply cover must be performed by a
qualified technician.
See Section 1 of the Operator Manual for more safety precautions.
Introduction
Purpose
Describes necessary steps to update the system firmware, cutchart database or the display software.
Tools And Materials Needed
Phillips Head Screwdriver
Kit Contents
Part Number
081056
081059
081088
081058
Description
Disk 1 of 2: System upgrade
Disk 2 of 2: System upgrade
Disk 1 of 1: Cutchart database
Disk 1 of 1: Display upgrade
Call Hypertherm Technical Service with any questions or concerns – 1-800-643-9878
Field Service Bulletin
1
1
HD4070 SYSTEM UPGRADE
HD4070 System Upgrade
1. Turn all power to the system OFF.
2. Remove top cover to Power Supply.
3. Insert Disk 1 (p/n 081056) into the HD4070’s floppy drive, see figure below.
Disk Drive
4. Turn the HD4070 power supply ON, with the interlocks (3) satisfied. The upgrade will start and the touch Screen
display will instruct the user to insert disk 2.
5. Insert Disk 2 (p/n 081059) and press ENTER on the display. When display indicates the upgrade is complete,
turn the HD4070 power supply OFF, remove the disk, replace cover and turn the power ON.
2
0
Field Service Bulletin
HD4070 SYSTEM UPGRADE
Upgrade of Cutcharts or Display
1. Turn all power to the system OFF.
2. Remove top cover to Power Supply.
3. Insert floppy disk (p/n 081088 for cutchart database or 081058 for display upgrade) into HD4070 disk drive
(see figure below).
Disk Drive
Green Light
4. Turn the HD4070 power supply ON, with the interlocks (3) satisfied. The PC starts to run and automatically
copies over the necessary files.
5. Update is complete when disk stops running, (green light goes out).
6. Turn power OFF, remove the floppy disk, replace cover and turn the power ON.
Field Service Bulletin
3
0