®
User’s Manual &
Operating Instructions
PT-02-230-E / PT-02-240-E / PT-03-230-E / PT-033-230-E /
PT-033-240-E / PT-05-400-E / PT-09-400-E
Electric Heater
PEEA-400
ENGLISH
............................................................................................................1-7
Read The Instruction manual: When this symbol is marked on a product, it means that the instruction
manual must be read.
In order to avoid overheating, do not cover the heater.
--
--------
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
BEFORE USING THE APPLIANCE.
Children of less than 3 years should be kept away unless continuously supervised. Children aged
from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been
placed or installed in its intended normal operating position and they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
The heater must not be located immediately below a socket-outlet.
Do not use the appliance for other than its intended use. For domestic indoor use only.
Place the appliance on a flat, stable, heat-resistant surface. Operating the product in any other
position could cause a hazard.
There may be trace of odour during the first few minutes of initial use. This is normal and will
quickly disappear.
Do not attempt to repair, disassemble or modify the appliance. There are no user-serviceable
parts inside.
WARNING: This heater is not equipped with a device to control the room temperature. Do not use
this heater in small rooms when they are occupied by persons not capable of leaving the room on
their own, unless constant supervision is provided
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
1
PT-02-230-E / PT-02-240-E / PT-03-230-E / PT-033-240-E / PT-05-400-E / PT-09-400-E
5
4
2
3
6
1
SPECIFICATIONS
Specifications subject to change without notice
PT-02-230-E
PT-02-240-E
PT-03-230-E
PT-033-230-E
PT-05-400-E
PT-09-400-E
THERMAL POWER (kW)
2.0
3.0
3.3
5.0
9.0
THERMAL POWER (BTU)
6,820
10,250
11,250
17,060
30,710
AIR FLOW (m /H)
186
540
476
530
708
HEATING AREA (m3)
20
30
33
50
90
POWER (Volt / Hz) (PT-230-E)
230~50
230~50
230~50
400~50
400~50
POWER (Volt / Hz) (PT-240-E)
220-240~50
220-240~50
220-240~50
―
―
3
2
2
2
2
X4
X4
X4
X4
X4
3
HEAT SETTINGS
INGRESS PROTECTION RATING (IP)
FUNCTIONS / SETTINGS
Unit is Off
Fan Runs - No Heating
Fan Runs - Quarter Power Heating
Fan Runs - Half Power Heating
Fan Runs - Full Power Heating
NOTE: PT-03-230-E / PT-03-240-E / PT-033-230-E / PT-033-240-E / PT-05-400-E / PT-09-400-E, the fan will run continuously while
the heater is operating.
NOTE: PT-02-230-E / PT-02-240-E, the fan will shut off when desired temperature is reached. Fan will not run continuously.
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
2
Safety Information
IMPORTANT: Read and understand all of the safety information and instructions in this
manual before operating your heater.
DANGER
RISK OF EXPLOSION! Do Not operate this heater where there are harmful,
explosive or flammable gasses, fumes or hazardous substances.
WARNING RISK OF FIRE! Do Not operate this heater near combustible materials.
WARNING ELECTRIC SHOCK HAZARD! Do not use this heater in the immediate
surroundings of a bath, a shower, or a swimming pool.
WARNING BURN HAZARD! Do Not touch the front of heater while it is operating. This
heater is hot while operating.
WARNING RISK OF INJURY! DO NOT MOVE HEATER WHILE IT IS OPERATING.
CAUTION In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience or and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
NEVER place the heater on a small, uneven or
unstable surface that may cause the heater to fall.
NEVER connect other appliances to the same
electrical outlet as the fan heater.
NEVER operate heater with heater guards removed.
NEVER block hot air outlet while heater is operating.
NEVER cover or obstruct heater.
NEVER use ducting with heater.
Children should be supervised so they do not play
with the appliance.
NEVER pull or carry heater by the power cord.
NEVER use heater with an external switching
device: such as a timer.
ALWAYS use only the electrical power (voltage
and frequency) specified on the model plate of
the heater.
If heater is damaged, do not use it. The heater must
be serviced by a qualified person or service agent.
ALWAYS use an extension cord properly rated for
this appliance.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ALWAYS ensure that all cords are protected
against short circuit and overload.
Do not use this heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
ALWAYS keep power cord away from hot air outlet.
ALWAYS disconnect heater from power source
when not in use.
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
The heater must not be located immediately
below a socket outlet.
3
Operation
Assembly
Thermostat Instructions
1. Align holes in the upper housing with the 2
holes in the handle.
2. Insert screws and tighten firmly.
–– At first, set the thermostat to “+” and let the
heater operate with full power input. When
the room temperature reaches the required
value, turn the thermostat to the left until it
switches off.
Operation
1. Position the fan heater so that it stands upright
on a firm, level surface and at a safe distance
from wet environments and flammable objects.
2. Connect the fan heater to the proper electrical
power.
3. Set the thermostat dial to the maximum
temperature.
4. The fan heater will switch on when the function
selector dial is set to one of the three power
settings.
Setting
–– The thermostat will then switch on and off
automatically to control the room temperature
according to the preset value and keep the
room temperature constant.
–– When using the heater for the first time, you
may notice a slight emission of smoke. This
is quite normal and it stops after a short
time. The heating element is made of steel
and was coated with a layer of protective oil
during production. The smoke is caused by
the leftover oil as it is heated.
Function
Unit is Off
Fan Runs - No heating
Fan Runs - Quarter Power Heating
Fan Runs - Half Power Heating
Fan Runs - Full Power Heating
NOTE: PT-03-230-EU / PT-033-230-EU / PT05-400-EU / PT-09-400-EU, the fan will run
continuously while the heater is operating.
NOTE: PT-02-230-EU the fan will shut off when
desired temperature is reached. Fan will not run
continuously.
NOTE: This chart does not apply to all models.
Check your heater for appropriate symbols.
Cleaning and Maintenance
–– Before cleaning the appliance, disconnect it
from the outlet and let it cool down.
–– The enclosure is easy to get dirty. Wipe it
often with a soft sponge. For very dirty parts,
wipe with a sponge dipped in < 50°C water
and mild detergent, then dry the heater
enclosure with a clean cloth. Be careful not to
let the water enter the inside of the appliance
–– In order to protect the enclosure, don’t
splash water onto the heater, and never
use a solvent like gasoline, isoamyl acetate,
toluene, etc. to clean the heater.
5. Once the room reaches the desired
temperature, turn the thermostat dial back
until heating element turns off.
–– When you store the heater, let it cool down
first and, keep it dry. Then cover it with a
plastic bag, put it in the packing box and
store it in a dry, ventilated place.
Automatic Overheat Safety Control
–– This heater is equipped with safety internal
heat limiting thermostat and overheat
protection circuit. When a potential overheat
temperature is reached, the system will
automatically shut the heater off.
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
4
Plug Replacement
WARNING RISK OF ELECTRIC SHOCK! DISCONNECT FROM POWER BEFORE MAINTENANCE.
NOTE: This section only applies to heaters sold or used in Great Britain.
This appliance is supplied with a BS1363 3 pin plug fitted
with a fuse. Should the fuse require replacement, it must
be replaced with a fuse with the proper amp rating. (see
Technical Specifications page 2) and approved to BS1362.
NOTE: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed cable,
it must be destroyed to prevent engaging into a socket.
connect live or neutral
WARNING Never
wires to the earth terminal of
the plug.
In the event the mains plug has to be removed/ replaced for
any reason, please note:
IMPORTANT: The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral Brown – Live
Green/Yellow – Earth
Plug Replacement Wiring Diagram
GREEN / YELLOW
Earth
Figure 3
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows:
The blue wire must be connected to the terminal marked
with an N or colored black. The brown wire must be
connected to the terminal marked with an L or colored red.
The green/ yellow wire must be connected to the earthing
terminal which is marked with an E or with the earth
symbol.
BROWN
Live
BLUE
Neutral
FUSE
13 Amps
CORD CLAMP
Troubleshooting
Problem
Cause
Solution
Fan stays on when heat shuts off.
1. Fan runs continuously while the
heater is operating.
1. Heater is operating correctly.
Fan speed stays the same when
changing settings.
1. Fan speed stays constant. Setting
changes amount of heat output
only.
1. Heater is operating correctly.
Heating element does not glow red.
1. Heating element is made of
stainless steel and will not glow
red to produce heat.
1. Heater is operating correctly.
1. No power to heater.
1. Check power connections /
connect heater to power supply.
2. Thermostat will shut off once
desired room temperature is
reached. Heater is operating
correctly.
3. Heater is operating correctly.
Do not feel heat or air flow.
2. Desired room temperature
reached.
3. Heater does not heat area in front
of heater, it will disperse heat
throughout room to heat entire
space.
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
5
Exploded View
14
1
5
6
9
10
7
2
3
4
8
12
11
13
Parts List
PT-02-230-EU / PT-02-240-EU / PT-03-230-EU / PT-033-230-EU / PT-05-400-EU / PT-09-400-EU
1
2
3
4
5
6
7
8
9
10
11
12
13
14
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
Top
Fan Blade
Rear Guard
Power Cord
Switch
Thermostat
Left Side Panel
Safety Thermostat
Knob
Front Guard
Heating Element
Base
Right Side Panel
Handle
6
®
© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
Download PDF