WATCH DISPLAY TIMESETTING INSTRUCTION MANUAL Stauer

QuadFold_24140_MonacoF2_Layout 1 8/6/13 5:01 PM Page 1
WATCH DISPLAY
TIMESETTING
A
B
C
D
H
E
F
G
A - CHRONO SECOND HAND
B - START/STOP CHRONO BUTTON
C - CROWN
D - 24-HOUR DIAL
E - SPLIT/RESET CHRONO BUTTON
F - DATE WINDOW
G - SECOND COUNTER DIAL
H - MINUTE COUNTER DIAL
FEATURES
- Precise quartz movement
- Stainless steel case
- Chronograph
- 3 ATM water resistance
- Adjustable nylon band
Locate the crown on your Stauer watch (see
diagram part C) and please note the three
crown positions (0-1-2).
1. To set the time: When the second
hand (part A) is at the 12 o’clock position, pull the crown (part C) out to
position “2.” Rotate the crown until the
desired time is set.
2. When finished setting the time, push
the crown back to the “0” (zero) position. At
this point the second hand (part A) will run.
SETTING THE DATE
1. Pull the crown (part C) out to position “1”.
2. Turn the crown clockwise (away from you)
to set the date (part F).
3. After the date has been set, push the crown
back to position “0” (zero).
USING THE CHRONOGRAPH
This chronograph measures and displays time
in 1 second increments up to a maximum of
59 minutes 59 seconds.
1. The chronograph can be started and
stopped by pressing button “B.” Note: for
measuring split times you will use the “E”
button for stopping.
2. Pressing button “E” resets the chronograph
and the chronograph second hand (part A),
minute counter (part H) and seconds counter
(G) return to the zero position.
3. For split time, pressing “E” again after
stopping the chronograph will restart the
chronograph function. Then press the “B”
button to stop, and the “E” button to reset.
- The date should not be adjusted between
approximately 9:00pm to 1:00am.
CHRONOGRAPH RESET (INCL. AFTER
REPLACING BATTERY)
This procedure should be performed when
the chronograph second hand does not return
to zero position after the chronograph has
been reset and after the battery has been
replaced.
1. Pull the crown (part C) out to position 2.
2. Press button “B” to set the chronograph
second hand (part A) to the zero position.
3. The chronograph second hand “A” and
minute hand dial (part H) can be advanced
rapidly by continuously pressing button “B”.
4. Once the hands have been set to zero position, press button “B” to reset the second
hand (part A) and then return the crown to
the normal “0” position.
IMPORTANT
When resetting the chronograph, only return
the crown to the normal “0” position when
the second hand (part A) is in the zero position. The second hand (part A) stops on the
way when the crown is returned to the normal position and that position is recognized
as the zero position.
®
Stauer Monaco F2 Watch
INSTRUCTION MANUAL
Visit us at www.stauer.com
to learn more about the fantastic
benefits of owning a Stauer Watch!
www.stauer.com