GT-18+1L or GT-18+1R Glasswasher

Project:
Item #:Qty:
Model #:
A family company manufacturing in the USA
www.glastender.com
AIA#
SIS#
GT-18+1L or GT-18+1R
Glasswasher
36" wide by 24" deep Rotary Rack, Fill & Dump, Front-to-Side
Pass Thru Door Type Glasswasher
Standard Features
• Built-in drain table on one side to provide glass landing area and
increase throughput
• Removable top for easy cleaning access (GT-18, GT-18+1,
GT-18+1L, GT-18+1R, GT-18+2, and GT-18+2-IC tops are
interchangeable)
• Drive Wheel and Glass Rack lift out for cleaning
• Two 16" diameter polypropylene racks included
• One curtain included
• Removable side panels for easy service access
• Spray box unlatches for easy cleaning and visual inspection - 15
spray nozzles have been engineered for maximum soil removal
• Digital temperature gauge built into switch panel
• Intelligent microprocessor control delays cycle start, up to two
minutes, when incoming water is below 120°F (49°C)
• Automatic peristaltic metering pumps accurately dispense detergent,
sanitizer and rinse aid
• Prime Switch for quick chemical priming
• 1/6 HP pump recirculates wash water and rinse water
• Fractional HP drive motor powers the belt-driven rotary rack and
includes built-in slip clutch
GT-18+1L
4004503
Conforms to NSF/ANSI STD 3 and UL STD 921
Certified to CSA STD C22.2 No. 168
Specifications
General Plumbing
• Plumb with 1/2" water supply. Adapt to 3/8" FMPT.
• Minimum water pressure is 25 PSI
• Maximum water pressure is 100 PSI. Install water pressure regulator if
line pressure is over 100 PSI. Water valve on unit has built-in strainer
and flow control to provide consistent volume between 25 and 100 PSI
• Install separate water shut-off valve
• Unit has built-in air gap - vacuum breaker is not required
• Maximum temperature is 150°F (66°C)
• Minimum temperature is 120°F (49°C)
• Consumption is 2-1/2 gallons per cycle
Drain
• 1-1/2" tailpiece
• Use open type floor drain for maximum drainage
Electrical
G
• 120V, single phase, 60Hz, 6-foot NEMA 5-15P
W
grounded cord included
• Dedicated 15 amp circuit recommended
5-15P
• Power requirements - 3.5 amps
Detergent
• Extra heavy duty, non-foaming, commercial liquid dishwashing detergent is required - .30% concentration
• Consult local chemical supplier to match detergent with local water
conditions
Sanitizer
• Liquid chlorine bleach (sodium hypochlorite - 5.25% solution) adjusted to
50 ppm
Rinse Aid
• Liquid Rinse Aid adjusted for proper sheeting
Capacity
• 2 minute cycle, 70 second wash and 22 second rinse exposure
• 720 - 2-1/2" diameter or 600 - 2-3/4" diameter glasses per hour (maximum
glass height 10" - including pitchers and wine carafes)
Materials
• 20 gauge stainless steel parts include: cabinet
• 18 gauge stainless steel parts include: floor and tanks
• 16 gauge stainless steel parts include: leg mounting brackets and legs
• 11 gauge stainless steel parts include: drive wheel
Installation Considerations
• 1" clearance required to remove top
• Front side service is essential
• Detergent, Sanitizer, and Rinse Aid containers are stored externally - sixfoot lengths of tubing are provided. Storage for three one-gallon containers
is required within five feet.
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
989.752.4275 • 800.748.0423 • Fax 989.752.4444
www.glastender.com
Approval/Notes:
Specifications subject to change without notice. For current specifications please visit our website.
Printed in USA
1.05
Rev. 08-05-15
GT-18+1L or GT-18+1R Glasswasher
Dimensional Information
36"
36"
R E D N E TS A L G
G L A ST E N D E R
19"
24"
19"
24"
G L A ST E N D E R
G L A ST E N D E R
5"
FRONT
FRONT
GLASS RACK
(2 PROVIDED)
DOOR
OPEN
7 1/2"
5"
DOOR
OPEN
GLASS RACK
(2 PROVIDED)
7 1/2"
PLAN VIEWS
GT-18+1L
GT-18+1R
1" Minimun Clearance
o
1" Minimun Clearance
o
o
o
36-1/2"
28-1/2"
28-1/2"
24-3/4"
36-1/2"
1" ADJUSTMENT FROM 38-1/2" TO 39-1/2"
FRONT ELEVATION VIEWS
Mechanicals
Notes: 1. In all cases, consult local plumbing,
electrical, and health codes for
regulations which may not be consistent
with the information on the front of this
specification sheet
36"
2. The utility connections are made from
the floor at the bottom of
the unit approximately 7" to 8" high
4"
4"
1 = HOT WATER
2 = DRAIN
3 = ELECTRICAL
3
1
24"
4"
24"
12-3/4"
12-3/4"
2
27"
36"
3
1
4"
7 1/2"
3. The Glastender policy of constant quality
improvement means specifications are subject
to change without notice
7 1/2"
2
2"
FRONT
5400 North Michigan Road • Saginaw, MI • 48604-9780
989.752.4275 • 800.748.0423 • Fax 989.752.4444
www.glastender.com
2"
27"
Printed in USA
Download PDF

advertising