code
a.b.s. S.r.l. (Milan) Italy
23022_1
Lombardia Street 310, 20861 Brugherio
Tel. +39 039 839631 - Fax. +39 039 8396349
e-mail:info@absfire.it - www.absfire.it - Capital 2.000.000
Technical Bullettin
1370
Control Box 23022_1 and 23022
fire system actuator
Usually fixed on the boat dash board
Red
Description
Green
Made in stainless steel, shine or GOLD plated 24K, used in
combination with Easyfire or Firekill extinguishing system for boat
engine or electrical board.
Pushing the button, the extinguishing will be activated.
During maintance, before opening the box be sure that power
supply is off disactivated otherwise system may work.
Code 23022
Stainless shine
(code 23022) stainless steel shine, or (Code 23022_1) stainless
steel + extraluxury gold plated 24K.
Temperature range -30 +60°C
Voltage 24 Volt 1 A, from boat battery.
Optional version 12 volt 1A
- Led green indicate that circuit is operative, electric
actuator and cable are not interrupted and not in short
circuit.
- Red light indicates that extinguisher has been discharged.
Electric actuator is out of order.
- Alarm audible buzzer included in the units will sound when
system has been activated.
Red
Green
5m
Connection with
thermocable
Connection with
temperature detector
2
3
4
5
6
7
8
m
6
Code 23022_1
Stainless + GOLD PLATED 24K
Remove safety pin, lift up door press red button inside to activate
discharge.
1
95 mm
105 mm
9 10 11 12
1
2
3
4
5
6
7
8
9 10 11 12
Thermocable
Note:
In case thermocable is not used it
is compulsory to connect a short
piece of electric cable between
connectors 3-6 and 4-5.
Electric actuator
Is fixed on the valve Easyfire® or Firekill®.
1
2
Connector base
R = Monitoring LED resistor 1.8 KΩ at 24 V
Pressure switch: 28024 or 23009_1
Contacts 7 and 8 in open status when low
pressure in the cylinder or a discharge
occurred.
If system status is ok contact 7 and 8 are
closed status, green led lightis on.
Technical data are subject to modification
for improvements without prior notice
Fire detection may be automatic using
a thermocable 88°,105°,137°C or
temeperature detectors.
subject to fire risk e.g. all around boat
engine room. For boats engine suggested
105°C.
Data Sheet
Fire Extinguisher
Code
Date
23022_1 05/12/12
Check
Rev
Pag.
2/AS
1/2
code
a.b.s. S.r.l. (Milan) Italy
23022_1
Lombardia Street 310, 20861 Brugherio
Tel. +39 039 839631 - Fax. +39 039 8396349
e-mail:info@absfire.it - www.absfire.it - Capital 2.000.000
Technical Bullettin
1370
Electric wire diagram
+
PULSANTE SOTTOVETRO
PUSH BUTTON ALARM
1.8 K
V
1.8 K
R
S
1
2
3
4
5
6
7
8 9
10
11
+
P
12
-
PRESSURE SWITCH
IF MORE THAN ONE
PRESSURE SWITCH
CONNECT IN SERIES
SIGNAL
CODE
PRESSOSTATO CONTATTO
NORMALMENTE APERTO SE
LA PRESSIONE NELL'ESTINTORE
E' SOPRA I 5 BAR IL CONTATTO
E' CHIUSO
PRESSURE SWITCH
CONTACT ARE NORMALLY OPEN, IF
PRESSURE ON THE EXTINGUISHER
IS OVER 5 BAR THE CONTACT IS CLOSED
PRESSOSTATO
SE PIU' DI UN PRESSOSTATO
SI DEVE COLLEGARE IN
SERIE
CAVETTO TERMICO
THERMOCABLE
OR JAMPER FOR
HEAT DETECTOR
CARTUCCIA ELETTRICA
SE PIU' DI UNA
SI DEVE COLLEGARE IN
PARALLELO
ELECTRIC ACTUATOR
IF MORE THAN ONE
CONNECT THE
ELECTRIC ACTUATOR
IN PARALLEL
CARTUCCIA ELETTRICA
ELECTRIC ACTUATOR
24 VDC
(Optional 12 V)
9 E 10
SONO CONTATTI
NORMALMENTE APERTI
POSSIBILITA' DI COLLEGARE
UN PULSANTE / SENSORE D'URTO (*1).
9 AND 10
ARE OPEN CONTACT:
A REMOTE PUSH BUTTON
CAN BE CONNECTED
OR ANY OPEN CONTACT DEVICE (*2).
(*1) RIVELATORE TERMICO
(*2) HEAT DETECTOR
POSITION LIGHTS
AND BUZZER
SYSTEM STATUS
DESCRIPTION
PERFORM
OPERATION
V
GREEN light ON.
Status System OK.
Devices are properly
installed and fully functional.
NOTHING
R-S
RED light ON.
Buzzer strong sound ON.
The system has been activated, the switch
has been activated (and not yet released)
or thermocables are in short circuit.
Pressurizzed the fire extinguisher
Be sure that there are no leaks or
replace and reinstall
the electric actuator.
R-S-V
RED light ON 1/2.
GREEN light ON 1/2.
Buzzer little sound ON.
The system has been activated, the switch
has been activated and released or
thermocables after short circuit
have been disconnected.
Recharge the extinguisher
replace and reinstall
the electric actuator.
lights OFF
Buzzer OFF
WARNING: SYSTEM FAULT;
Low-pressure on the fire extinguisher
or electric actuator damaged
or wires are not connected properly.
Technical data are subject to modification
for improvements without prior notice
Low-pressure on the fire extinguisher
or verify the functionality of the
pressure switch with a tester or
electric actuator damaged to be
replaced or wires are not connected
properly to be reconnected.
Data Sheet
Fire Extinguisher
Code
Date
23022_1 05/12/12
Check
Rev
Pag.
2/AS
2/2
Download PDF

advertising