Accessories
CTS 602 by Nilan
Electrical heating element
Software-version: 2.17
01-05-2012
Product no. 76413
Table of contents
Table of contents ............................................................................................................................ 2
Introduction..................................................................................................................................... 3
EL-montage ............................................................................... Fejl! Bogmærke er ikke defineret.
Electrical heating element ............................................................................................................... 3
Accessories/spare parts ................................................................................................................. 5
Introduction
Should you have any questions on how to operate the system, contact your nearest Nilan dealer,
who you can find at www.nilan.dk/dealers
The purpose of this instruction is to give the installer instructions about correct installation and possible maintenance.
The electrical installation must be made by an authorized electrician.
Electrical heating element
Electrical heating surface should be installed in the ducting (Ø160/Ø200). When retrofitting an electrical heating surface it should be activated in the CTS 602 control panel. ( HEATING SURFACT)

Power supply of the Electrical heating element must be installed by an authorized electrician.
Heating surface, electrical (retrofitting)
The heating surface should be installed in the inlet duct immediately after the unit.
There should be a safety distance of minimum 150mm from the heating surface to any flammable
materials. The heating surface must be insulated with a fire resistant material. However the electrical box may not be insulated. (Important: instructions from the manufacturer of the heating surface
must be followed).
See electrical chart.
EXHAUST
230 V
INLET
CV
900 W
T7
SIGNAL OVERHEATNING
The heating surface has a temperature regulator and a safety thermostat installed. Clamps 3 & 4 in
CN6 should be shortcircutted. When installing other types of heating surfaces be aware of security.
The heating surface must equipped with a temperature regulator and a safety thermostat
The heating surface must be activated in the CTS 602 control panel.
T2 is annulled when the heating surface is activated in the CTS 602 control.
See installation instructions for heating element and temperature control.
HEATING ELEMENT must be enabled to work with the unit.
Nilan reserves the right to alter these instructions without prior notice
Page 3 af 5
TEMP. CONTROL allows you to choose the controlling temperature sensor for the unit.
After the option of an electrical heating element T7 is the air supply sensor.
Nilan reserves the right to alter these instructions without prior notice
Page 4 af 5
Accessories/spare parts
Electrical heating surface (for fitting in inlet duct)
System
Output
Comfort 300
0,9kW
Spare parts/accessories
Type
CTS 602, control PCB
CTS 602, control panel, complete
CTS 602, white control panel enclosure
Nilan reserves the right to alter these instructions without prior notice
Qty
1
Qty
1
1
1
Nilan item no.
764131
Nilan item no.
239932
2398
2398HX
Page 5 af 5