G1, G2 & G3 GRINDERS
USE & CARE INSTRUCTIONS
COFFEE GRINDING
STEP 1
STEP 2
STEP 3
STEP 4
Turn the selector knob to align Raise the top lid and add the Locate the back of a bag behind
the red arrow with the desired whole bean coffee. Close the the dispense chute. (The grinder
will not operate unless the bag
grind.
top lid.
is behind the chute.) This will
activate the bag switch.
Allow the bag to rest on the
screen beneath the chute.
STEP 6
STEP 8
STEP 5
STEP 7
Turn the ON/OFF switch to ON and Flip the cleaning lever a few times Remove the bag when ground
press the start switch.
as dispensing slows.
coffee is no longer dispensed
from the chute. The grinder will
stop automatically when the bag
is removed.
39563.0000A
10/06 ©2006 Bunn-O-Matic Corporation
NOTE - The start switch will have
to be pressed again to continue
the cycle if the bag is removed
before grinding is completed.
Turn the ON/OFF/START switch
to the OFF position.
39563 102506
G1, G2 & G3 GRINDERS
USE & CARE INSTRUCTIONS
CLEANING
STEP 1
Clean all exterior surfaces
using a damp cloth rinsed
in any mild, nonabrasive,
liquid detergent. Care
should be taken not to
scratch the grinder with
any abrasive material.
STEP 2
Empty all beans from
hopper(s). Plug in the
grinder, place an empty
bag behind the dispense
chute. Press and release
the “START” switch. Run
a few cycles until all coffee in the grind chamber
is dispensed and disconnect the grinder from the
power source. Remove
the bag.
STEP 3
WARNING - Prior to
cleaning the grind chamber, unplug the grinder
before removal of any
panel or grind chamber
housing parts.
STEP 4
Remove the two screws
and remove the dial plate
and selector knob assembly.
STEP 6
STEP 7
STEP 8
STEP 9
Remove the two screws
securing the stationary
burr to the grind chamber.
Wash all parts in a mild
solution of detergent with
hot water and a stiff non
metallic bristle brush.
Rinse all parts thoroughly
and allow them to air dry
before reinstalling.
Carefully clean the grind
chamber, dial plate assembly, chute opening
and dial plate opening
with a dry stiff non metallic bristle brush. Wipe
with a clean cloth that has
been soaking in a mild
solution of detergent and
hot water. Reinstall the
spring and rotor with burr
onto the motor shaft.
Align the slot in the motor shaft with the rotor
and reinstall shear plate.
Reinstall rotor cup and
grind selector dial plate
to the burr housing. Refer to the Operating and
Service manual for burr
adjustments.
STEP 5
Slide the burr auger rotor/spring assembly off
the motor shaft and disassemble for cleaning.
39563 102506