INSTALLATION INSTRUCTIONS FOR PART 99-7329
APPLICATIONS
KIA Rondo
2007-2009
99-7329
KIT FEATURES
• Recessed DIN mount radio provision
with pocket
• ISO mount radio provision with pocket
KIT COMPONENTS
A) Radio Housing B) ISO Brackets C) ISO Trim Plate
C
B
A
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• 70-1004 - Hyundai 2006-up/KIA harness 2004-up
• 70-7303 - Hyundai/KIA harness 2009
Antenna Adapter:
• 40-KI11 - KIA antenna adapter 2007-up
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver
1-800-221-0932
www.metraonline.com
© COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION
99-7329
TABLE OF CONTENTS
Dash Disassembly
- KIA Rondo 2007-2009 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Kit Assembly
- Recessed DIN mount radio provision with pocket. . . . . . . . . . . . . . . . . . . . . 2
- ISO mount radio provision with pocket. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
*Note:
Refer also to the instructions included with the aftermarket radio.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills
by enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 for more information
and take steps toward a better tomorrow.
99-7329 DASH DISASSEMBLY
KIA RONDO 2007-2009
A
1 Disconnect the negative battery terminal to prevent an accidental short
circuit.
2 Unclip and remove the panel surrounding the shifter. (Figure A)
3 Remove (2) Phillips head screws
securing the radio trim panel. Unplug
and remove panel. (Figure B)
4 Remove (4) Phillips screws securing
the radio. Unplug and remove the
radio. (Figure C)
Continue to kit assembly.
C
B
1
99-7329 KIT ASSEMBLY
RECESSED DIN MOUNT RADIO PROVISION
WITH POCKET
*Note: Refer also to the instructions included with the aftermarket radio.
A
1 Slide the DIN cage into the radio housing and secure by bending the metal
locking tabs outward. (Figure A)
2 Slide the radio into the DIN cage/housing assembly until it snaps into place.
(Figure B)
Continue to final assembly.
B
2
99-7329 KIT ASSEMBLY
ISO MOUNT RADIO PROVISION WITH POCKET
*Note: Refer also to the instructions included with the aftermarket radio.
A
1 Align the holes from the ISO snap in
brackets with the holes in the side of
the radio and mount the brackets to
the radio using screws supplied with
the radio. (Figure A)
2 Slide the radio/bracket assembly into
the radio housing until the assembly
snaps into place. (Figure B)
3 Snap the ISO Trim-plate onto the Radio
and housing assembly. (Figure B)
B
Continue to final assembly.
3
99-7329 FINAL ASSEMBLY
FINAL ASSEMBLY
A
(A) Strip wire ends back 1/2"
B
B) Twist ends together
C) Solder
C
D) Tape
D
1 Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
2 Re-connect the negative battery terminal and test the unit for proper operation.
3 Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
Right Front (+) . . . . . . . . . . . . Gray
12V Batt / Memory. . . . . . . . . Yellow
Right Front (-). . . . . . . . . . . . . Gray/ Black
Ground. . . . . . . . . . . . . . . . . . Black*
Left Front (+) . . . . . . . . . . . . . White
Power Antenna. . . . . . . . . . . . Blue
Left Front (-). . . . . . . . . . . . . . White / Black
Amp Turn-On . . . . . . . . . . . . . Blue / White
Right Rear (+) . . . . . . . . . . . . Violet
Amp Ground. . . . . . . . . . . . . . Black / White
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Illumination . . . . . . . . . . . . . . Orange
Left Rear (+) . . . . . . . . . . . . . Green
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4
99-7329
NOTES
5
99-7329 INSTRUCTIONS
1-800-221-0932
REV. 06/23/09
www.metraonline.com
© COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION
INST99-7329