skylo bottom entry ball valve

skylo
bottom entry
ball valve
!
WARNING
We shall not be responsible or liable for any failure
of, or damage to, this plumbing product caused
by the use of chlorine/bleach cleaners or related
products added to the tank water. Use of such
products will void the warranty and may result in
product failure, possibly causing property damage.
Do not over tighten plastic nuts and always turn off
water supply when installing/removing toilet cistern
parts.
INSTALLATION INSTRUCTIONS
1
To assemble the valve, position
the water level adjuster into
place.
4
Remove the plastic washer and
nut from the thread and position
the valve in the cistern ensuring
the conical rubber sits on the
hole at the cistern base.
7
Please note: Save this instruction sheet for future reference
IMPORTANT: DO NOT use plumber’s putty to seal this fitting
The arm length can also
be adjusted by sliding the
adjustment clip to unlock, move
the arm in or out to desired
length then lock the clip.
2
Slide the adjustable arm over
the water level adjuster and
lock into the latches.
5
Secure valve to the cistern by
replacing the plastic washer
and screwing the nut to the
thread. Do not over tighten.
8
The water level can be adjusted
by turning the adjustment
screw (clockwise for less water,
anticlockwise for more water).
TROUBLESHOOTING
3
Screw the adjustable steady
pin into top of upright stem,
adjust length as required. It
may also be necessary to
shorten the pin.
6
Fit suitable ball float to end of
float arm. The position of the
ball can be adjusted by loosing
plastic wing nut, when desired
position is achieved re tighten
wing nut.
2
1
Ensure water is switched off and
loosen the retaining nut.
Remove the valve from the
retaining nut.
4
3
To access the diaphragm
washer remove white plastic
insert.
Remove the diaphragm washer
and clean or replace.
5
Re-connect valve.
For more information please contact:
VIVA Sanitary
Units 1-2 Capitol Trading Park, Kirkby Bank Road
Knowsley Industrial Estate, Liverpool, L33 7SY
Tel: 0151 546 0531 Fax: 0151 549 4187
E-mail: sales@vivasanitary.co.uk
Installation videos and further
information available now.