AMPLIFIER
Owner’s Manual
Models:
XM15.1
XM15.4
XM30.2
JAVELIN
Power Amplifier XM
SERIES
SPECIFICATIONS Monoblock
Amplifier Class
Frequency Response:
Total Harmonic Distortion
Signal to Noise Ratio:
Gain Range Low Pass Crossover Range Subsonic Crossover Range Bass Boost @ 45Hz:
Operational Efficiency
Remote Bass Control
Damping Factor:
CEA-2006 Compliant
Class D
30 - 200Hz
< 0.5%
92dB
0.2 - 6V
50 - 250Hz
15 - 250Hz
0 to +18dB
> 85%
Yes
> 200
Yes
XM15.1
Channels
Into 1 ohm
Into 2 ohm
Fuse Size:
Power/Ground Wire Size:
Dimensions:
1
1500w x 1
1050w x 1
N/A
4 Gauge
15.0 in L x 7.5in W x 2.3in H
SPECIFICATIONS Multichannel
Amplifier Class
Frequency Response:
Total Harmonic Distortion
Signal to Noise Ratio:
Gain Range Low Pass Crossover Range Subsonic Crossover Range Bass Boost @ 45Hz:
Operational Efficiency
Remote Bass Control
Damping Factor:
CEA-2006 Compliant
Class D
30 - 200Hz
<0.5%
92dB
0.2 - 6V
50 - 250Hz
15 - 250Hz
0 to +18dB
> 85%
Yes
> 200
Yes
XM15.4
Channels
Into 4 ohm Into 2 ohm In to 4 ohm Bridged Fuse Size Power/Ground Wire Size Dimensions XM30.2
Channels
Into 4 ohm Into 2 ohm In to 4 ohm Bridged Fuse Size Power/Ground Wire Size Dimensions JAVELIN
Channels
Into 4 ohm Into 2 ohm In to 4 ohm Bridged Into 2 ohm (Sub CH) Into 4 ohm (Sub CH) Fuse Size Power/Ground Wire Size Dimensions © 2017 Exile Audio • www.exileaudio.com 4
150w x 4
225w x 4
450w x 2
40Ax2
4 AWG
12.7in L x7.5in W x 2.3in H
2
300w x 2
420w x 2
840w x 1
40Ax2
4 AWG
10.8in L x 7.5in W x 2.3in H
5
100w x 4
150w x 4
300w x 2
800w x 1
500w x 1
40Ax3
4 AWG
15.0in L x 7.5in W x 2.3in H
Amplifier Manual
JAVELIN 5 Channel Power Amplifier
CONFIG
2 - Set to 2 when only 1 RCA input is available from the source.
This drives all three channels from either the Front, Rear
or Sub input on the amplifier.
4 - Set to 4 when only 2 RCA inputs (Front/Rear) are availble
from the source.This drives the Front and Rear channels
from either the Front or Rear RCA input on the amplifier,
and the Subwoofer channels from the Subwoofer RCA
input on the amplifier.
6 - Set to 6 when 3 RCA inputs (Front/Rear/Sub) are available
from the source. All channels have their own specific input.
FRONT, REAR AND SUB INPUTS
Connect preamp signal cables from the head unit to
these terminals.
DIFF INPUT
Turn ON if your source unit has differential outputs.
GAIN (FRONT, REAR AND SUB CHANNELS)
HPF (FRONT AND REAR CHANNELS)
Controls the high pass crossover point for the
speaker outputs.
LPF (SUB CHANNEL)
Controls the low pass crossover point for the
speaker outputs.
BASS BOOST (SUB CHANNEL)
Variable bass boost from 0 to +18dB @ 45 Hz.
REMOTE
This port is for connecting the optional remote level control
(XMRB1). This allows up to 20dB of volume adjustment. This is
not a bass boost, it controls the level of the low pass signal.
POWER/PROTECT
Indicates if the amplifier is working correctly (BLUE) or gone into
protect mode (RED).
Used to reach maximum amplifier power with a wide
variety of headunits.
SPEAKER OUTPUTS
Used to connect the amplifier to the speakers. Use the
left channel positive (+) and the right channel negative (-) for
bridged mode.
GND
This must be connected to the negative terminal of the car’s
battery or bolted to a clean, unpainted part of the chassis of
the vehicle.
12V+
This must be connected to the fused positive terminal (+12V) of
the car’s battery.
REMOTE
This must be connected to switched +12V, usually a trigger wire
coming from the head unit or ignition.
Amplifier Manual
© 2017 Exile Audio • www.exileaudio.com
2 Channel Power Amplifier XM30.2
OUTPUT
GAIN
INPUT
POWER/PROTECT
Connect preamp signal cables from the head unit to
these terminals.
Connect preamp signal cables from the head unit to
this terminal.
Used to reach maximum amplifier power with a wide
variety of headunits.
Indicates if the amplifier is working correctly (BLUE) or gone into
protect mode (RED).
DIFF INPUT
Turn ON if your source unit has differential outputs.
HPF
Controls the high pass crossover point for the
speaker outputs.
SPEAKER OUTPUTS
Used to connect the amplifier to the speakers. Use the
left channel positive (+) and the right channel negative (-) for
bridged mode.
FUSE
This amplifier requires two 40A fuses.
12V+
REMOTE
This must be connected to switched +12V, usually a trigger wire
coming from the head unit or ignition.
GND
This must be connected to the negative terminal of the car’s
battery or bolted to a clean, unpainted part of the chassis of
the vehicle.
This must be connected to the fused positive terminal (+12V) of
the car’s battery.
© 2017 Exile Audio • www.exileaudio.com Amplifier Manual
XM15.4 4 Channel Power Amplifier
OUTPUT
LPF
INPUT (FRONT AND REAR)
BASS BOOST
Connect preamp signal cables from the head unit to
these terminals.
Connect preamp signal cables from the head unit to
these terminals.
HPF
Controls the high pass crossover point for the
speaker outputs.
XOVER
HF - Sends high frequency signal to speakers.
FULL - Sends a full range signal to speakers.
LF - Sends low frequency signal to subwoofer.
CONFIG
Switches the amplifier from 4 Channel to 2 Channel
(Bridged) mode
SPEAKER OUTPUTS
Used to connect the amplifier to the speakers. Use the
left channel positive (+) and the right channel negative (-) for
bridged mode.
FUSE
This amplifier requires two 40A fuses.
12V+
Controls the low pass crossover point for the
speaker outputs.
Variable bass boost from 0 to +18dB @ 45 Hz.
GAIN
Used to reach maximum amplifier power with a wide
variety of headunits.
POWER/PROTECT
Indicates if the amplifier is working correctly (BLUE) or gone into
protect mode (RED).
REMOTE
This port is for connecting the optional remote level control
(XMRB1). This allows up to 20dB of volume adjustment. This is
not a bass boost, it controls the level of the low pass signal.
REMOTE
This must be connected to switched +12V, usually a trigger wire
coming from the head unit or ignition.
GND
This must be connected to the negative terminal of the car’s
battery or bolted to a clean, unpainted part of the chassis of
the vehicle.
This must be connected to the fused positive terminal (+12V) of
the car’s battery.
Amplifier Manual
© 2017 Exile Audio • www.exileaudio.com
XM15.1 Monoblock Power Amplifier
INPUT
FREQ
DIFF INPUT
BASS BOOST
GAIN
LPF
Connect preamp signal cables from the head unit to
these terminals.
Turn ON if your source unit has differential outputs.
Used to reach maximum amplifier power with a wide
variety of headunits.
PHASE
Controls the lowpass crossover point for the
speaker outputs.
Variable bass boost from 0 to +18dB @ 45 Hz.
Low Pass Filter 25 to 250 Hz.
POWER/PROTECT
Switches the output signal 180°.
Indicates if the amplifier is working correctly (BLUE) or gone into
protect mode (RED).
SUBSONIC
REMOTE
Controls the highpass crossover point for the speaker outputs to
eliminate extreme low frequencies.
SPEAKER OUTPUT
Used to connect the amplifier to speakers.
12V+
This must be connected to the fused positive terminal (+12V) of
the car’s battery.
This port is for connecting the optional remote level control
(XMRB1). This allows up to 20dB of volume adjustment. This is
not a bass boost, it controls the level of the low pass signal.
GND
This must be connected to the negative terminal of the car’s
battery or bolted to a clean, unpainted part of the chassis of the
vehicle.
REMOTE
This must be connected to switched +12V, usually a trigger wire
coming from the head unit or ignition.
© 2017 Exile Audio • www.exileaudio.com Amplifier Manual
Power Amplifier XM
SERIES
Marine Installation Guide POWERFLOW
2
Input:
Source Unit
1
Perko
Battery
Selector
Switch
H
ITC
SW
1/0 ga.
ANL Fuse
Holder
MANL Fused
Power
Distribution
Block
Aux Input:
phone/
mp3 player
2
1
Stereo
Battery
Starting
Battery
XMRB1 Bass Control
Ground
Distribution
Block
1
11
4 ga.
R
Cabin
Amplifier
Input
R
Tower
Amplifier
Subwoofer
Amplifier
L
L
R
L
ZLD
zoned line driver
Input
R
R
L
L
Input
R
L
R
L
R
L
4ohm
2ohm
tower speakers
2ohm
subwoofer
cabin speakers
Amplifier Manual
© 2017 Exile Audio • www.exileaudio.com
Installation Diagrams Javelin
System Includes:
1 Javelin
4 pr. Tower Speakers
1 Subwoofer
TERMINAL SIDE
When you only have 1 set
of input RCA’s coming from
your source unit to the
Javelin amplifier set the
Config switch to “2”
120W @ 2ohms
2
4
6
120W @ 2ohms
Front Right
Front Left
4 gauge power and ground required.
Subwoofer
800W @ 2ohms
Rear Left
Rear Right
120W @ 2ohms
120W @ 2ohms
SIGNAL SIDE
Left
Channel
RCA
Right
Channel
RCA
Note: Recommended system settings are indicated by the arrows on the silkscreen shown above. The amplifier should come preset to
these positions. To get back to the recommended settings first turn the knob all the way counter clockwise, then turn it clockwise
untill you reach the arrow indicated for each knob.
© 2017 Exile Audio • www.exileaudio.com Amplifier Manual
Javelin Installation Diagram
System Includes:
1 Javelin
4 pr. Tower Speakers
1 Subwoofer
TERMINAL SIDE
When you have 2 sets of
input RCA’s coming from
your source unit to the
Javelin amplifier set the
Config switch to “4”
120W @ 2ohms
4
6
120W @ 2ohms
Front Left
Front Right
4 gauge power and ground required.
Subwoofer
800W @ 2ohms
Rear Left
Rear Right
120W @ 2ohms
120W @ 2ohms
SIGNAL SIDE
Right
Channel
RCA
Remote
Bass Control
Left
Channel
RCA
Left Subwoofer
Channel RCA
Amplifier Manual
Right Subwoofer
Channel RCA
Note: Recommended system settings are indicated by the arrows
on the silkscreen shown above. The amplifier should come preset
to these positions. To get back to the recommended settings first
turn the knob all the way counter clockwise, then turn it clockwise
untill you reach the arrow indicated for each knob.
© 2017 Exile Audio • www.exileaudio.com
Installation Diagrams Javelin
System Includes:
1 Javelin
4 pr. Tower Speakers
1 Subwoofer
TERMINAL SIDE
When you have 3 sets of
input RCA’s coming from
your source unit to the
Javelin amplifier set the
Config switch to “6”
120W @ 2ohms
2
4
6
120W @ 2ohms
Front Left
Front Right
4 gauge power and ground required.
Subwoofer
800W @ 2ohms
Rear Left
Rear Right
120W @ 2ohms
120W @ 2ohms
SIGNAL SIDE
Front Right
Channel
RCA
Rear Left
Channel
RCA
Rear Right
Channel
RCA
Remote
Bass Control
Front Left
Channel
RCA
Left Subwoofer
Channel RCA
© 2017 Exile Audio • www.exileaudio.com Right Subwoofer
Channel RCA
Note: Recommended system settings are indicated by the arrows
on the silkscreen shown above. The amplifier should come preset
to these positions. To get back to the recommended settings first
turn the knob all the way counter clockwise, then turn it clockwise
untill you reach the arrow indicated for each knob.
Amplifier Manual
Amplifier Manual
© 2017 Exile Audio • www.exileaudio.com
LAKE OSWEGO, OR USA
WWW.EXILEAUDIO.COM
DESIGNED AND ENGINEERED IN THE USA
LIMITED WARRANTY
Exile warrants this product to be free from defects in material and workmanship under normal use for a period of one year from date of original purchase when
purchased from an Authorized Exile Dealer. If the product is labeled B Stock/Refurbished and purchased from an Authorized Exile Dealer, it is warranted for 90
days from date of purchase, regardless of place of installation. Should service be necessary under this warranty for any reason due to manufacturing defect
or malfunction during the warranty period, Exile will replace or repair (at its discretion) the defective merchandise with equivalent merchandise at no charge.
Warranty replacements on B-Stock merchandise may have cosmetic scratches and blemishes. Discontinued products may be replaced with more current
equivalent products. This warranty is valid only for the original purchaser and is not extended to owners of the product subsequent to the original purchaser. Any
applicable implied warranties are limited in duration to a period of the express warranty as provided herein beginning with the date of the original purchase at
retail, and no warranties, whether express or implied, shall apply to this product thereafter. Some states do not allow limitations on implied warranties, therefore
these exclusions may not apply to you. This warranty gives you specific legal rights; however you may have other rights that vary from state to state. This
warranty is only valid within the USA, for warranties outside of the USA consult the appropriate international distributor.
© 2017 Exile Audio • www.exileaudio.com V5 11/30/2017
Amplifier Manual