TP-552HDCP DVI (HDCP) over Twisted Pair Receiver The TP-552HDCP is a twisted pair receiver for DVI signals. The TP-551HDCP converts a DVI signal to a twisted pair signal and the TP-552HDCP convert the twisted pair back into an DVI signal. FEATURES Max. Data Rate - 1.65Gbps. HDCP & HDMI Compliant. HDTV Compatible. EDID PassThru - Passes EDID/HDCP signals from source to display. EQ (Peaking) Control - DIP−switch setup. Status LEDs. - Input, output, power. System Range - Up to 90m (295ft) at XGA or up to 30m (98ft) at WUXGA on shielded BC−DGKat524 cable. Up to 60m (197ft) at SXGA on shielded BC−DGKat623 cable. Up to 60m (197ft) at SXGA on shielded BC−DGKat7a23 cable. Cable - Requires shielded twisted pair (STP) cable. For optimum range and performance use, use Kramer's BC−DGKat524, BC−DGKat623 and BC−DGKat7a23 cables. Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non−Kramer CAT 5, CAT 6, and CAT 7 cables may not reach these ranges. Use only shielded cable where both ends of the shield are soldered to ground. Compact DigiTOOLS® - 3 units can be rack mounted side−by−side in a 1U rack space with the optional RK−3T rack adapter. TP-552HDCP TECHNICAL SPECIFICATIONS INPUTS: 2 CAT 5 IN on RJ−45 connectors. OUTPUTS: 1 DVI connector. BANDWIDTH: Supports up to 1.65Gbps bandwidth per graphic channel. SYSTEM RANGE: Up to 60m (200ft) @WUXGA using CAT 6 cables. CABLE TYPE: Dual STP CAT 5e 24AWG cables, CAT 6 cables can also be used.Using UTP (Unshielded Twisted Pair) might reduce the system range. COMPLIANCE WITH HDMI STANDARD: POWER CONSUMPTION: Supports HDMI 1.2 and HDCP. DIMENSIONS: 12.1cm x 7.18cm x 2.42cm (4.76" x 2.83" x 0.95"), W, D, H. WEIGHT: 0.3kg. (0.67lbs) approx. INCLUDED ACCESSORIES: Power supply (5V/2A). OPTIONS: Kramer DVI cables, RK−3T 19" rack adapter. 5V DC, 620mA.