Control
What’s in the Box
Headphone
Jack
TimoLabs Jackson
Model# TM-S2
Bluetooth Transceiver
Mic
Power
LED
Status
LED
TxRx
Slider
1X
Jackson
Main
Button
microSD
Card Slot
Reset
1X
User
Manual
User Manual
1X
1X
1 Pair X
Bluetooth Transmitting (Tx)
2. Single click main button turning on device.
3. Status LED flash blue fast waiting for Bluetooth connection.
2. Single click main button turning on device.
3. Status LED flash red fast waiting for Bluetooth connection.
4. Have your other Bluetooth receiving device
turned on and ready to connect. (Note: Make
sure your receiving device is not Bluetooth
connected already. )
5. Put Jackson close to Bluetooth receiving
device for faster connection.
6. Status LED flash red slowly when Bluetooth connection established.
7. Plug in audio source into Jackson and enjoy
audio on receiving end.
Rx Control
Main
1-Click
2-Click
Press&Hold
Turn on
Activate
Turn off
Vol +
Vol -
AUX USB Charging Velcro
Cable
Cable
Dots
Bluetooth Receiving (Rx)
computer Bluetooth list, then connect.
5. Status LED flash blue slowly when Bluetooth connection established.
6. Plug in headphone or other audio device
to enjoy your music.
microUSB
Charging Port
Portable MP3
1. Put MP3 music files onto microSD card.
2. Plug microSD card into Jackson.
3. Single click main button turning on device.
4. Status LED flash green when playing music
from microSD.
5. Press Vol+ and Vol- simultaneously cycle
through in-order MP3 playing, shuffle MP3
playing, and Bluetooth, three modes.
6. Press and hold one volume button will skip
songs.
7. Plug in headphone or other audio device
to enjoy your music.
Firmware Update
1. Download latest firmware from timolabs.com
3. Copy firmware file onto microSD card.
4. Plug microSD card into Jackson.
5. Single click main button turning on device.
6. Jackson will update firmware on start, then
turn off when finished.
Phone Call
updating repeatedly.
Specification
Model No.
TM-S2
Dimension
3.4” x 2” x 0.4”
86 mm x 50 mm x 10 mm
0.13 lb / 60 gram
v4.2
v4.2
Support mp3 audio playback
In order or shuffle
125 mW
350 uV
112 dB
0.002%
High definition mic with noise cancellation
Compatible with mic-attached headphone
1450 mAh
20+ hours of Bluetooth streaming
36+ hours of microSD music playing
Weight
Bluetooth
microSD
Amplifier
Microphone
Battery
Tx
Rx
Power
Pop Sound
SNR
THD-N
FCC Notice
Warranty
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
TimoLabs warrants this product to be free
from defects in material and workmanship
for a period of TWELVE MONTHS after the
original date of consumer purchase.
This equipment generates, uses and can radiate audio frequency energy and if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will occur
in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
you are encouraged to try to correct the interference by one
or more of the following measures:
than the one to which the receiver is connected.
for help.
During this period, TimoLabs will, at its option, either repair the defective product with
new or rebuilt parts, or replace it with a new
or rebuilt product at no charge. The parts or
products that are replaced become the property of TimoLabs.
TimoLabs is not responsible for damage to
inbound product that was not properly
packaged.
For Customer Service,
please contact support@timolabs.com
or visit www.timolabs.com