Quick Guide for Winmate 3.7" Compact Rugged Tablet PC
(R03TACH-RTSH)
Rugged Tablet PC Overview
Front Components
A.
B.
C.
D.
Light Sensor
Touch Screen
LED Indicator
Keypad
LED Indicator
A. External Function LED
B. Wireless Function LED
C. Power Status LED
Keypad
Back Components
A.
B.
C.
D.
Function
E.
F.
G.
H.
Enter
Home
Phone
Power
External
Camera
Wi-Fi/ Bluetooth
A. Flash
B. Camera
C. Hand Belt Fixing Hole
D. Speaker
E. Stylus
F. Battery Latch Handle
Bottom Connectors
A. DC Jack
B. DC Dock
C. Mini USB
D. RS232
(Optional) With Barcode Reader
A. Barcode Reader
Inserting the SIM Card and Battery
1. Lift the latch handle of the battery cover and turn it to unlock position. Then, open the
cover from the device.
provided by
2. (Optional) Users who need phone function need to install the SIM card
mobile operator. With the SIM card chip side facing up, insert the card fully into the
bottom slot.
3. (Optional) Users who need to extend memory should install the SD card. With the SD
card chip side facing up, insert the card fully into the upper slot.
4. The first way to install the battery is to attach the upper side of the battery to battery
connector and then lower the bottom side to fit into the compartment.
5. Recover the battery cover and secure the latch by turning it to lock position.
Charging the battery
Before beginning
Make sure the battery is correctly installed in the device.
1. Plug the DC cord of the AC adapter into the power connector of the device.
2. Plug the female end of the AC power cord into the AC adapter and the male end into an
electrical outlet
3. The charge indicator glows in amber when charging is in progress. Do not disconnect your
device from AC power until the battery is fully charged, as indicated by the amber indicator
turning into green. This will take a couple of hours.
When the battery charge level is too low for operation, the device switches itself.
Performing the Initial Startup
When turning on your device for the very first time, you will be guided through a setup
process.
1. Make sure that your device is either connected to AC power or the battery has power.
2. Press the power button to turn on your device.
The backlight of the keypad will light up and, after a few seconds, the setup screen
appears.
3. Follow the on-screen instructions to complete the setup wizard.
4. (Optional) For phone function only:
If a SIM card has been inserted and the mobile phone network operator has set
the PIN, you will be prompted to enter the PIN. Enter the PIN and tap Enter.
If a SIM card has not been inserted yet, a message of an invalid or missing SIM
card will appear on the screen. You can tap Cancel to continue the startup
procedure.
5. After the setup is completed, user can now use the device.
">
