BoLtDuwer
Included Items:
* 1X BOLTPOWER Jump Starter
* 1x 110V-240V Wall Charger
* 1x 12V Cigarette Car Charger
* 1x User Guide
* 1x USB Charging Cable (3 in 1)
* 12 Months limited warranty
D29 Diagram & Product Specifications
1. Flashlight Button 5. USB Output 2 DC 5V/2.1A Max
2. LCD Screen Indicator 6. Input (DC 15V/1A Max)
3. Power Switch 7. NO/OFF Power Switch
4. USB Output 1 DC 5V/2.1A Max 8. 12V Car Jumper Connector
Battery Capacity: 18000 mAh Net Weight (Battery Pack): 214 Oz
Input: DC 15V/1A max Dimension: 7.25 x 3.5 x 1.42 in
USB Output 1: DC 5V/2.1A max Starting Current: 500 Amp
USB Output2: DC 5V/2.1A max Peak current: 900 Amp
Recharging Time: Approx. 4 hours Cold Cranking amp: 400 Amp
Operating Temperature: -20°C ~ 60°C / - 4°F ~ 140°F
Instruction to connect to clamps:
Connect positive polarity (Red Clamp +) to positive terminal, and negative
polarity (Black clamp -) to negative terminal to the battery.
[Battery life in good condition]
* When the clamps connected correctly, the LED on the clamps will
automatically change to solid GREEN and wait for 5 to 10 seconds to start
your ignition.
[Battery life in low condition]
* When the clamps connected correctly, if LED keeps blinking Green and
Red means the battery is too low to be detected and you MUST press and
hold “Overload button” for 3 seconds to activate, the LED will change to solid
GREEN and wait for 5 to 10 seconds to start your ignition.
A WARNING
IMPORTANT: If you found reversely connect the battery polarity, the LED on
the clamp will keep blinking RED simultaneously. PLEASE DO NOT PRESS
AND HOLD OVERLOAD BUTTON, YOU MUST DISCONNECT THE
CLAMP IMMEDIATELY.
Manual Overload Button on the Clamps
To enable, push and hold for three (3) seconds. Overload button is on
the side of the clamp.
WARNING: Disables safety protection and manually forces to boost
“On” . Only for use when a battery is too low to be detected.
Charging the Battery Pack
* Connect the battery pack to any power outlet using a home
power adapter and the 15V input port.
» Connect the battery pack to the car's cigarette lighter using the
car charger cable and the 15V input port.
Jump Starting Cars
The battery pack can be used to jump start gasoline powered
engines with a 12V battery.
* Check the battery level on the LCD indicator and make sure at
least 60% power for large vehicles and 25% for smaller vehicles.
* Connect the jumper clamps to the car battery (Red is positive and
Black is negative).
* Plug the jumper cables into the battery pack.
* Start the car by turning on the ignition.
* Disconnect the jump starter within 25 seconds of the car having
been jump started
Charging Mobile Devices
Use any of the two USB charging ports to charge mobile devices
such as smartphones, tablets, and cameras.
* Connect the battery pack to your mobile device using the includ-
ed USB cable or use your OEM cable.
* Turn the battery pack” s power on to start charging.
Note
When connected to a mobile device, the LCD screen will show
“OUT 5V 2.1” indicating that the USB output is working normally.
Power will automatically cut off after 30 seconds if no devices are
connected.
LED Flashlight
Press and hold the main button to cycle ON the flashlight. Solid
Beam(ON), SOS (slow flash), Warning (quick flash) and OFF are
the three different modes available to use.
Caution
* When jump starting, please make sure the jumper cable is
firmly clamped onto the car battery leads. Improper clamping
may damage the battery and even burn the cable.
* |f the car cannot be jump started, please make sure the cable is
firmly clamped. Also, check if the battery leads are rusty or dirty.
Clean the battery lead if necessary.
* |f you still cannot start the car after three attempts, please stop
using the jump battery pack and check if the car has other issues
leading to a breakdown.
* Do not interconnect the two clamps on the same jump cable.
This will cause serious damage to the car.
» Do not dismantle this battery pack. The warranty does not cover
products which have been dismantled.
* Do not expose the product to water or other liquids.
* Do not modify the battery.
* Keep away from children.
* Make sure the jumper cable polarities are correct before using.
* Keep away from fire and extreme heat.
* Stop using if the battery pack becomes hot or changes color.
This may be caused by internal leakage.
» Please recharge the battery pack at least once every 3 months.
* When used to jump start a car, please wait at least 10 seconds
before recharging the battery pack.
* Please do not use it to repeatedly jump start your car; Wait at
least 30 seconds before another attempt.
Warranty
Our company provides customers with a warranty of 12
MONTHS from the date of purchase.
Contact Us
For any inquiries or comments concerning our products, please
send an email to [email protected], and we will respond
to you as soon as possible. If there is any quality-related issue
with the product, you may request a REPLACEMENT by sub-
mitting a request through the eCommerce platform.
Statement
We’ re only able to provide after-sales service for purchases
made directly from BOLTPOWER. If you purchased through a
different retailer, please contact them for any exchange or
refund requests.
* Please note that unauthorized reselling of BOLTPOWER
products is prohibited.
Certificate Of Quality
Item name:
Model:
Inspection:
Date:
">
