LWU3720 Series Wireless Security Camera
1 0 8 0 P WI RE LE SS D IG ITA L S ECURI TY CAMER A S YSTEM
LW U3 7 2 0 S E RIE S
Qui c k St a r t G uide
Getting Started
B. Installing the Receiver
A. Installing the Cameras
1
Mount the camera to the wall or ceiling using the included screws and
drywall anchors (optional).
Cable Notch
1
4x wireless 1080p indoor/outdoor cameras*
4x antennas for cameras (pre-attached)*
4x power adapters for cameras*
4x mounting kits for cameras*
1x wireless indoor/outdoor receiver
2x antennas for receiver (pre-attached)
1x mounting kit for receiver
1x double-sided tape for receiver
*Quantity only applies to the LWU3724.
NOTE: The LWU3724 is compatible with Lorex
LH060 series DVRs only.
Visit www.lorextechnology.com for the most
up-to-date list of compatible recorders.
Installation Tips
Before you permanently install your cameras:
Plan where and how they will be positioned.
Determine where you will route the cable that
connects the camera to the power adapter.
Verify the camera’s performance by observing
the image on a monitor when the camera
is positioned where it will be permanently
installed.
Avoid installing cameras in locations that
require the wireless signal to pass through
cement, concrete and metal structures. This
will reduce the transmission range.
For outdoor use, installation in a
sheltered location is recommended.
2
If you run the cables along the
wall / ceiling, you must run the cable through the cable notch on the
base. This will keep the camera
base flush to the wall /
ceiling when mounted.
Adjust the angle of the camera until the desired view is set. Tighten
the lower / upper screws and the adjustment ring to secure the camera
position.
A
B
C
A) Turn the adjustment
ring to tighten / loosen
the stand connection.
Adjust the camera’s
horizontal position.
B) Loosen lower screw
with the included Allen
key to adjust the
camera’s vertical position.
C) Loosen upper screw
with the included Allen
key to rotate the camera
housing.
3
Connect the camera power adapter to the camera. Connect
power adapter to a power outlet.
Use the included double-sided tape to securely attach the receiver to
a flat surface.
OR
NOTE:
The LWU3724 system comes with the following
components:
OPTIONAL
Use the included screws to mount the receiver to a wall.
ATTENTION: Make sure to first connect and power on the
cameras before powering on the receiver. This will ensure a
proper connection.
2
Plug the USB cable from the wireless receiver into your DVR.
NOTE: For optimal video frame rate performance, we recommend you
do not install more than 4 digital wireless security cameras in the
same environment.
Need Help?
Visit us online for up-to-date software and
complete instruction manuals
1 Go to www.lorextechnology.com
2 Search the model number of your product
3 Click on your product in the search results
NOTE: Number of cameras and accessories may vary by model. Check your package label
for specific content information.
4 Click the Downloads tab
www.lorextechnology.com
LWU3720_SERIES_QSG_EN_R1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement