Sputnik Flush Mount Installation Guide
Important Safety Instructions
1.
2.
3.
4.
5.
6.
7.
We recommend installation by a licensed electrician. Please install in accordance with National Electric
Code (NEC) and applicable codes and ordinances.
When you remove fixture, do not pick up using wire as a faulty electrical connection may result.
Please take a moment to locate and identify all hardware and components. Do not discard package
until all parts are identified and fixture is installed.
As you unpack, place contents on a carpeted/padded area to protect from damage.
To reduce risk of injury, always turn off and allow a fixture to cool before replacing light bulb.
Do not touch bulb when fixture is on or look directly at lit bulb.
To avoid risk of fire, do not exceed recommended wattage.
Hardware & Components
Manufacturer No.
20630
Bulb Type
6 - 25 watt max
Type G16.5 or smaller
Candelabra Base E12
(not included)
Assembly
BEFORE ANY WORK IS COMPLETED,
ENSURE POWER SUPPLY TO JUNCTION
BOX IS TURNED OFF!
mounting bracket
(A)
mounting screws
(B)
wire connectors
(D) not included
plate setting
screws (E)
ground screw –
green (C)
* - See fixture for required electrical ratings and use markings.
5.
Tools Required
6.
7.
screwdriver
wire stripper
8.
9.
1.
Place mounting bracket (A) onto
junction box and secure by placing two
mounting screws (B) into bracket slots
lining up with threaded holes in junction
box. Screw both in using screwdriver.
2.
Screw green ground screw (C)
partially into bracket hole marked “GRD”.
3.
Attach junction box ground wire
by wrapping wire around ground screw, and
screw tightly onto ground wire.
4.
With assistance, lift fixture into
position to begin wiring.
Attach white “neutral” fixture wire to “neutral” junction box wire (usually
white) via wire connector (D).
Attach black “hot” fixture wire to “hot” junction box wire (usually black)
via wire connector (D).
Once wired, place fixture mount plate over the mounting bracket,
aligning the three holes on side of plate with three holes on bracket.
Screw in three plate setting screws (E) by hand to secure fixture.
Install light bulbs into sockets. Turn on power to check bulb comes on.
Your installation is complete.
Designed and Manufactured in USA #duttonbrown
www.duttonbrown.com
info@duttonbrown.com
1