BATTERY POWERED
TOOLS
Battery powered press
Battery powered press
Battery powered hydraulic press for terminals and connectors:
• ring terminals without insulation (ZA dies) 10-120 mm2
• ring terminals with insulation (ZE dies) 10-120 mm2
• cable-end sleeves with and without insulation (ZT dies) 25-185 mm2
• Cu tubular terminals and connectors on cable conductors (ZS dies) 6-300 mm2
• Al tubular terminals and connectors on cable conductors (ZS dies) 6-300 mm2
• round forming Al sector conductors (ZF dies) 16-240 mm2
Special features:
• efficient lithium-ion battery
• automatic off switch ending operation cycle
• flip top, rotatable by 360 head
• electronic control of operation cycles
• temperature sensor cause automatic stop of the tool in case temperature
reach over then 60°C
• sound signal means, that tool will not continue operation until lowering
temperature
Battery powered hydraulic press for terminals and connectors:
• ring terminals without insulation (ZA dies) 10-120 mm2
• ring terminals with insulation (ZE dies) 10-120 mm2
• cable-end sleeves with and without insulation (ZT dies) 25-185 mm2
• Cu tubular terminals and connectors on cable conductors (ZS dies) 6-300 mm2
• Al tubular terminals and connectors on cable conductors (ZS dies) 6-240 mm2
• round forming Al sector conductors (ZF dies) 16-240 mm2
Speacial features:
• automatic off switch ending operation cycle after crimping
• proper crimping signal - green LED, not accurate crimping - red LED
• electronic record of operation cycle - data transfer via USB
• efficient lithium-ion battery
• automatic pressure control
EPZ 300N
Battery powered press
EPZ 120
EPZC 300
Battery powered hydraulic press for terminals and connectros:
• ring terminals without insulation (ZAM dies)
• ring terminals with insulation (ZEM dies)
• cable-end sleeves with and without insulation (ZTM dies)
• Cu tubular terminals and connectors on cable conductors (ZSM dies)
• Al tubular terminals and connectors on cable conductors (ZSM dies)
• round forming Al sector conductors (ZFM dies)
Special features:
• automatic off switch ending operation cycle after crimping
• proper crimping signal - green LED, not accurate crimping - red LED
• electronic record of operation cycle - data transfer via USB
• efficient lithium-ion battery
• automatic pressure control
Battery powered shears
EGC 45
Battery powered hydraulic shears
for cutting wires:
• copper and aluminum diameter
up to 45 mm
• reinforced wires (included AFL) or steel
tape, max diameter up to 30 mm
Special features:
• efficient lithium-ion battery
• automatic off switch ending operation
cycle after cutting
• temperature sensor cause automatic stop
of the tool in case when temperature
reach over 60°C
• sound signal means, that tool will
not continue operation until lowering
temperature
Battery powered punching tool
EWHE 80
Battery powered hydraulic punching tool
for punching round, square and rectangular
holes. Thanks to rotatable head it is possible
to cut holes in places with difficult acces.
Works with punches:
• WO 12,7 - 80 mm
• WON 12,7 - 32,5 mm
• WK 68,5 x 68,5 mm
• WP
Special features:
• bi-articulated swivel head
• efficient lithium-ion battery
ERKO
11-042 Jonkowo, Hanowskiego 7
tel./fax +48 89 512 92 73
sales: sales@erko.pl
www.erko.pl