PA2-AMP-S SIP VIDEO INTERCOM & PAGING GATEWAY
PA2-AMP-S is a SIP video intercom and paging device for industry applications. The media stream transmission
utilizes standardIP/RTP/RTSPprotocols. It is perfectly compatible with all thecurrent SIP IPPBX /IMS
platforms, such as Ericsson-LG iPECS, Asterisk,Broadsoft, 3CX, Elastix, etc. It hasvarious functions andinterfaces,
suchas Intercom, broadcast, video , security, and recording toadapt to different applicationenvironments.
Highlights

Small form factor
Emergency call button interface, active call
Interact with IPC camera, you can make a video phone call
NVR video recording, standard RJ45 interface
Recording output, 3.5mm standard audio interface
10W-30W adaptive output power
System online management and upgrade






Intercom














Two SIP lines, supporting SIP 2.0
(RFC3261) and related RFC
Supports two lines RTSP
Voice broadcast IP address
Button or remote volume adjustment
Switch signal input and output
Talkback recording output
Handsfree talking
Default auto answer
Dynamic multicast function
Supports DC or POE power supply
Support for Function key interface
Support monophonic active speakers
Network time synchronization
Action URL / Active URI remote control
Audio




Narrowband speech coding: G.711a / u,
G.723.1, G.726-32K, G.729AB
Broadband speech coding: G.722
Half Duplex Echo Cancellation (AEC)
DTMF: In-band, out-of-band DTMF
(RFC2833) / SIP Info
Networking/ Protocols





Supports PoE (802.3af)
Primary and secondary DNS servers
are supported
Support VLAN
Supports SNTP client
Support VPN L2TP / PPTP / IPSec







Supports SRTP
Support for HTTP / HTTPS web pages
Support Qos: 802.1p / q, DSCP
Support MD5 authentication
Supports Web Filter
DHCP / static / PPPoE
STUN



Physical Specifications







2 RJ45 interface:
Yellow: WAN port 10 / 100M adaptive,
support POE
PoE: 802.3af (Class 3: 6.49 ~ 12.95W)
Black: LAN port (Only connected to the
original camera)
Cable: Cat 5 lines or better
1 blue indicator (SIP status and
network status)
2 volume plus or minus key
1 restore factory settings key
1 recording output interface:
3.5mm standard audio interface
15 Ohm impedance
1 ground screw
1 way passive speaker interface:
Output power: 4Ω, POE / 10W, 12V /
10W,18V / 20W, 24V / 30W;
Wire diameter: 18 AWG or larger
diameter
Interface:Pluggable terminal block











1 headset jack：
Output: 32 Ohm 1.2V
interface:Pluggable terminal block
1 DSS key interface (4 lines):
Indicator: Output 5.0V 5mA
Interface:pluggable terminal block
1 way microphone input interface:
Recommendation: Use an electret
condenser microphone
Sensitivity: -38dB, Impedance 2.2 K
Ohm bias voltage 2.2V
Interface:Pluggable terminal block
1 short circuit input and output
interface (built-in relay):
Relay: MAX DC30V / 1A, AC125V /
0.5A,
Interface:pluggable terminal block
2 parallel power input interface:
12V-24V / 2A DC 1 road for the 5.5mm
DC power seat 1 road way 2Pin
pluggable terminal block
Standby power consumption: DC12V
1.32W / POE 1.78W
Housing material: aluminum alloy shell
Installation: Indoor installation
Operating temperature: -30 ~ 70 ℃
Storage temperature: -40 ~ 70 ℃
Relative humidity: 10% - 95%
Equipment size: 113x83x28mm
Packing size: 138x108x77mm
Equipment weight: 250g
The above specifications may be updated in the future without prior notice. All hardware/software/physical features should be based on the final shipped products.
For sales or technical support contact Presence Managtement at 614.652.6500 or sales@presencemanagement.com