wvifd-02f - CRUX Interfacing Solutions

Rev. 020315
INTERFACING SOLUTIONS
WVIFD-02F
COMPATIBLE RADIO SYSTEM:
MyFord Touch Radio System*
* Important Note: Vehicle must be
equipped with Factory A/V Input for the
kit to function.
FORD
2013 - 2015 F150
2013 - 2015 F150 Raptor
2013 - 2015 F250
2013 - 2015 F350
2013 - 2015 F450
2013 - 2015 F550
Installer must use Toggle Switch for VIM
Control. (See page 3 on instruction sheet).
Activating the VIM will effect the GPS System.
(May cause delay in location updates)
WORKS FOR ALL:
MyFord Touch Radios
NOTE: The radio system will go through
a reboot process that may take up to 1
minute. It will initialize and re-load all
previous settings. Once complete it will
resume the original radio display.
Wi-Fi AUDIO/ VIDEO INTERFACE FOR SELECT F-SERIES TRUCKS 2011-UP
We recommend reading this installation guide first before starting any
work. Following these instructions from “Start” to” Finish” will ensure
a smooth and hassle free installation. We offer telephone support M-F
9:00 AM – 5:00PM PDT at 1 (855) 822-1348. We are here to help.
PARTS INCLUDED:
INSTALLATION OVERVIEW
TO FACTORY
DISPLAY
SONY
8” RADIO
(1) WVIFD-02F Interface (C-125)
(1) WVIFD-02F Interface (C-500)
(1) WVIFD-02F T-Harness
(1) WVI Wi-Fi Interface
(1) Instruction
54-PIN
54-PIN
(female plug)
(male plug)
GREEN/ VIM
WHITE/12V OUTPUT
GREEN/ VIM
WHITE/ 12V OUTPUT
RED WIRE/ TAP HERE
C-500
- Remove the negative side of the battery to avoid any short circuits
during the installation.
- Do not install the interface near any major components or near the
HVAC system. This may cause damage or overheating to the vehicle.
- Do not disconnect the airbag connection behind the radio panel.
PRELIMINARY:
(male plug)
C-125
ON
1
INTERFACE
2
3
4
5
SEE PAGE 2
FOR DETAILS
DISABLE
.
..
.
.
..
.
+
+
10-Pin
10-PIN
CONNECTOR
+
+
ANTENNA
ANTENNA
4
5
6
BLACK/
GROUND
Wi-Fi
INTERFACE
MODE
MODE
SETTING THE DIP SWITCHES
Dip 1: Activates the Video In-Motion feature. The dip switch
is the permanent solution for keeping the VIM unlocked.
The SWC/ Toggle Switch feature will be deactivated with it ON.
Dip 2,3,4: Not Used
Dip 5: Place to the OFF position on both interfaces.
Dip 6: Place to the ON position on both interfaces.
INSTALLER MUST USE THE TOGGLE SWITCH INCLUDED TO
ACTIVATE THE VIDEO IN-MOTION.
Activating the VIM will effect the GPS System.
(May cause delay in location updates)
USB PORT
USB PORT
8. Switch to the new AV input by using the SWC or a toggle switch.
9. Test the interface, then re-install the display into the dash.
10-PIN
(male plug)
TO FACTORY
AV INPUT
+
+
RESET
RESET
3
INCLUDED
TOGGLE SWITCH
6. Connect the RED power lead10-PIN
to 12v and the BLACK wire to ground.
CONNECTOR
As an option we have provided a 12v output wire from our interface, as the vehicle does not provide 12v Acc 250ma.
7. Screw on the Antenna to the interface and select the MODE of the
system type you are connecting.
Mode: Press once to toggle between iOS and Android Systems.
Reset: Press 1 Second = Reset/ Hold 5 Seconds = To Factory Defaults
LED
LED
2
ACTIVE
SEE PAGE 3 FOR GROUND
THE Wi-Fi INTERFACE
5. Connect the 10-Pin Power and AV cable to the Wi-Fi interface.
.
..
.
1
STATUS LED’S
THE AV INTERFACE:
1. Remove the factory display to gain access to the factory connectors.
2. Remove the 54-Pin connector from behind the display.
3. Make the T-Harness connections behind the factory display.
(if the connectors do not match please contact tech support)
4. Connect both Interfaces to an 8-Pin connector. No orientation.
5. Set the dip switches as needed on both interfaces.
(See Setting The DIP Switches)
.
..
.
BLACK WIRE OF
8-PIN CONNECTOR
6
STATUS LED’S
INSTALLATION
.
..
.
8-PIN
(male plug)
ON
FOR DIP SWITCH SETTINGS
Please read the entire manual before installing this interface.
BLACK WIRE/ TAP HERE
8-PIN
INTERFACE
PRECAUTIONS:
+
+
TO FACTORY
HARNESS
-----------------------------------------------------
TROUBLE SHOOTING
1. No video display while driving.
- Make sure the dip switches are in the proper location.
turned on using the Toggle Switch.
See instruction for how to connect.
Rev. 020315
Dip 1 TRUCKS
ON
ON 2011-UP
VIM Permanently on. No control on SWC
Wi-Fi AUDIO/ VIDEO INTERFACE FOR SELECT F-SERIES
or Optional Toggle Switch. Recommended
for vehicles w/o factory GPS.
INTERFACING SOLUTIONS
WVIFD-02F
COMPATIBLE RADIO SYSTEM:
MyFord Touch Radio System*
* Important Note: Vehicle must be
equipped with Factory A/V Input for the
kit to function.
FORD
2013 - 2015 F150
2013 - 2015 F150 Raptor
2013 - 2015 F250
2013 - 2015 F350
2013 - 2015 F450
2013 - 2015 F550
Installer must use Toggle Switch for VIM
Control. (See page 3 on instruction sheet).
Activating the VIM will effect the GPS System.
(May cause delay in location updates)
SETTING
THE DIP SWITCHES
DETAILS:
DIP SWITCHES
SLIP SHEET
PIN 1/ VIM CONTROL CONFIGURATION
DIP#
C-125
C-500
Dip 1
OFF
OFF
Dip 1
ON
Dip 2
OFF
NOTE: The radio system will go through
a reboot process that may take up to 1
minute. It will initialize and re-load all
previous settings. Once complete it will
resume the original radio display.
OFF
User control of the VIM feature will be
turned on using the Toggle Switch.
See instruction for how to connect.
OFF
OFF
Not Used.
Dip 3
OFF
OFF
Not Used.
Dip 4
OFF
OFF
Not Used.
Dip 5
OFF
OFF
CAN Termination.
Dip 6
OFF
OFF
CAN Termination.
VIM Permanently on. No control on SWC
or Optional Toggle Switch. Recommended
for vehicles w/o factory GPS.
Not Used.
Dip 3
OFF
OFF
Not Used.
CONNECTING
TO THE
WI-FI INTERFACE
Dip 4
OFF
OFF
Not Used.
OFF
CAN Termination.
OFF
CAN Termination.
SETTING UP YOUR DEVICE:
With the
interface
and ready.
Dip
5 on
OFF
Dip 6
WORKS FOR ALL:
MyFord Touch Radios
ON
RESULT
Dip 2
OFF
On the new iOS 7 you can easily do the following:
Swipe your finger from the bottom up on the iPhone or iPad.
From the Quick Menu turn ON the Wi-Fi and connect to “HotSpot”.
After connecting the Wi-Fi, from that same screen select the
AirPlay item to connect to the interface.
IMPORTANT NOTE:
Does Not support Netflix and Youtube on iOS System
(APPLE) Devices due to Restrictions placed by
Apple.
MIRRORING:
The Mirroring connection uses a direct Wi-Fi connection to transfer
the Audio and Video from your device. This does not require a active
network.
If your smartphone has the Screen Time Out,
active
phone,
PIN
5 &on6your
VIM
CAN CONFIGURATION
The VCIP5 cable may be utilized for accessing
and your phone display goes to sleep, you will no longer see the image
Separately).
In the case where the VIMApps
does (Sold
not function
or the radio may not
on the screen. Deactivate to avoid.
these
turn on, this may be due to incorrect combination of Pin Configuration.
To turn on Mirroring, you will need to be connected to the interface
and select the AirPlay item again, and turn on Mirroring option.
ATTEMPT 1
If your device doesn’t support the iOS 7:
1. Settings > Wi-Fi > On
2. Choose Network > “Hot Spot”
3. After connected, double click the Home button to display your
recently used apps.
4. Select the AirPlay icon to begin to mirror. (Wi-Fi must be connected).
If no AirPlay icon, make sure your connected to Hot Spot.
ATTEMPT 2
ATTEMPT 3
ATTEMPT 4
PIN 5 & 6 VIM CAN CONFIGURATION
Dip 5
Dip 6
Dip 5
Dip 6
Dip 5
Dip 6
Dip 5
Dip 6
ANDROID System Devices are fully compatible with
C-125
C-500
the above Apps.
OFF
ON
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
ON
OFF
OFF
ON
ON
In the case where the VIM does not function or the radio may not
turn on, this may be due to incorrect combination of Pin Configuration.
For the Android systems, make sure you switch the MODE on the
C-125
interface.
For Android devices you will need
or output your
Dipto5know how to mirror
OFF
ATTEMPT
1from the Home screen, swipe down from the top
media.
On Samsung,
Dip 6
OFF
of the screen to access the Screen Mirroring item, then scan for the
Dip 5
OFF
HotATTEMPT
Spot device. This
2 can take up to 20 seconds.
Dip 6
Dip 5
ATTEMPT 3
Dip 6
Dip 5
ATTEMPT 4
Dip 6
Wi-Fi TROUBLESHOOTING:
OFF
OFF
ON
OFF
ON
When exiting and coming back to the vehicle you may encounter
a delay when re-connecting. If a separate Wi-Fi connection is made,
you may need to manually reconnect.
C-500
ON
ON
OFF
ON
ON
ON
OFF
ON
SAFETY WARNING:
THIS INTERFACE IS DESIGNED TO ACTIVATE
VIDEO IN-MOTION TO ALLOW THE PASSENGER
ACCESS TO THE ADDRESS INPUT WHILE THE
VEHICLE IS IN-MOTION. THIS INTERFACE MAY
CAUSE AN ERROR WHEN SERVICED AT THE OEM
DEALER. BE AWARE THAT MOST DEALERS
WILL ATTEMPT TO VOID THE MANUFACTURERS
WARRANTY WHEN INSTALLING ANY AFTERMARKET EQUIPMENT. IMPROPER USE OF THIS INTERFACE BY THE DRIVER MAY RESULT IN CITATION.
DRIVER MUST KEEP FULL ATTENTION ON THE
ROAD AND RESPONSIBILITY ON THE SAFETY OF
THEIR PASSENGERS.
Rev. 020315
Wi-Fi AUDIO/ VIDEO INTERFACE FOR SELECT F-SERIES TRUCKS 2011-UP
WVIFD-02F
COMPATIBLE FACTORY MYFORD TOUCH RADIOS (NO CONTROL ON THE SWC)
COMPATIBLE RADIO SYSTEM:
MyFord Touch Radio System*
* Important Note: Vehicle must be
equipped with Factory A/V Input for the
kit to function.
FORD
2013 - 2015 F150
2013 - 2015 F150 Raptor
2013 - 2015 F250
2013 - 2015 F350
2013 - 2015 F450
2013 - 2015 F550
Installer must use Toggle Switch for VIM
Control. (See page 3 on instruction sheet).
Activating the VIM will effect the GPS System.
(May cause delay in location updates)
WORKS FOR ALL:
MyFord Touch Radios
NOTE: The radio system will go through
a reboot process that may take up to 1
minute. It will initialize and re-load all
previous settings. Once complete it will
resume the original radio display.
INSTALLING THE TOGGLE SWITCH
You will be able to use any of the 8-Pin connectors from the interface modules.
Use the RED wire as your constant source for the toggle switch and both of the
GREEN wires from the T-Harness’.
USING THE 8-PIN FOR GROUND
We recommend using the BLACK wire on the 8-Pin C-500 connector.
See picture below for where to tap.
To be used on 2013-2014 Ford F-Series vehicles as they do not offer SWC activation.
GREEN/ 12V SWITCH
INCLUDED
TOGGLE SWITCH
GREEN/ 12V SWITCH
(SAME FUNCTION AS DIP 1)
NON-PERMANENT
12V
CONSTANT
C-125
C-500
DEACTIVE/
CURRENT =
POSITION
WHITE/ OPTIONAL
12V OUTPUT
(MAY VARY)
C-500
(Wire View)
WHITE/
OPTIONAL
12V OUTPUT
(MAY VARY)
8-PIN
(male plug)
C-125
TAP HERE
RED/ 12V CONSTANT
8-PIN
(male plug)
TAP HERE/
BLACK WIRE