INNOKIN T18 1000 mAh Mouth to Lung vaping system User manual
Below you will find brief information for Mouth to Lung vaping system T18 1000 mAh. This is a user manual for the INNOKIN T18 1000 mAh Mouth to Lung vaping system, a portable and sleek device that comes with a 2.5 ml Prism tank and a 1.5 ohm coil. The instructions cover charging, filling the tank, replacing the coil, and safety features.
advertisement
INNOKIN T18 (1000 mAh) Kit – Mouth to Lung vaping system
*Important notice*
To avoid overheating we recommend to turn off the device while transporting.
Kit contains:
1x T18 1000 mah battery
1 x 2.5 ml Prism tank and coil
1 x 1.5 ohm coil
I x USB
1 x Stand
2 x spare drip tips
Spare “O” rings
1 x User manual
Turn ON / OFF:
Press the fire button three times with in two seconds. It is strongly recommended that you turn the battery off when not in use.
Charging the battery:
Your Endura T18 battery is charged via the supplied Micro USB cable. The USB port is protected by the base cover.
The power supply can be either a PC or the certified Cirro 5 volt / 1 amp mains charger.
When charging the device:
The T18 battery charging status is displayed via a green and red LED, Charging takes approximately 3 hours. The T18 has “pass – through” technology so CAN be vaped whilst charging
Red = the battery is charging
Green = the battery is fully charged
When using the devise the battery capacity is displayed as:
Green = Almost fully charged.
Yellow = Half Power.
Red = Low Power.
Filling the Prisim tank:
This is a top filling system. Hold the tank at its base and unscrew the top. Tilt to 45 degrees and add your e liquid to the inside wall of the tank, avoiding getting liquid into the air hole in the centre of the unit. Do not over fill the tank.Re screw the top, don’t over tighten, and begin vaping. Please remember that if you have fitted a new coil you must wait 5 minutes before vaping to avoid a burnt taste and damaging the coil.
Replace the coil:
NB – The tank needs to be empty before you replace the coil.
Turn the tank with the bottom end up. Unscrew the metal base cap, hold the coil and gently pull away from the tank. Properly align the flat sides of the new coil, push to fully insert the new coil and firmly re attach the metal cap
– do not over tighten. Refill the tank with e liquid and wait 5 minutes to allow the liquid to soak into the new coil.
Safety includes:
15 second cut off, Low Voltage Warning, Short Circuit and Atomiser Protection
Protection – Over Discharge, Over Charge and over heat.
Please carefully read the instruction supplied with your purchase, and thank you for buying from Cirro.
* Please remember to uptake water intake whilst vaping *
Any queries please call us at the salford shop on 0161 737 8726 and we will be happy to help you!
advertisement
Key Features
- Mouth to Lung vaping
- 1000 mAh battery
- 2.5 ml Prism tank
- 1.5 ohm coil
- Pass-through charging
- Top filling system
- Safety features
Frequently Answers and Questions
How do I turn the INNOKIN T18 1000 mAh on and off?
How do I charge the INNOKIN T18 1000 mAh?
How do I fill the Prism tank on the INNOKIN T18 1000 mAh?
How do I replace the coil on the INNOKIN T18 1000 mAh?
Related manuals
advertisement
