CH-1527TX & RX
DR
A
FT
HDMI over CAT5e/6/7 Extender with LAN/IR/RS-232/
PoE
Operation Manual
FT
A
DR
DISCLAIMERS
The information in this manual has been carefully checked and
is believed to be accurate. Cypress Technology assumes no
responsibility for any infringements of patents or other rights of third
parties which may result from its use.
Cypress Technology assumes no responsibility for any inaccuracies
that may be contained in this document. Cypress also makes no
commitment to update or to keep current the information contained
in this document.
FT
Cypress Technology reserves the right to make improvements to this
document and/or product at any time and without notice.
COPYRIGHT NOTICE
A
No part of this document may be reproduced, transmitted,
transcribed, stored in a retrieval system, or any of its part translated
into any language or computer file, in any form or by any means—
electronic, mechanical, magnetic, optical, chemical, manual, or
otherwise—without express written permission and consent from
Cypress Technology.
© Copyright 2012 by Cypress Technology.
All Rights Reserved.
DR
Version 1.0 January 2012
TRADEMARK ACKNOWLEDGMENTS
All products or service names mentioned in this document may be
trademarks of the companies with which they are associated.
SAFETY PRECAUTIONS
Please read all instructions before attempting to unpack, install or
operate this equipment and before connecting the power supply.
Please keep the following in mind as you unpack and install this
equipment:
Always follow basic safety precautions to reduce the risk of fire,
electrical shock and injury to persons.
•
To prevent fire or shock hazard, do not expose the unit to rain,
moisture or install this product near water.
•
Never spill liquid of any kind on or into this product.
•
Never push an object of any kind into this product through any
openings or empty slots in the unit, as you may damage parts
inside the unit.
•
Do not attach the power supply cabling to building surfaces.
•
Use only the supplied power supply unit (PSU). Do not use the PSU
if it is damaged.
•
Do not allow anything to rest on the power cabling or allow any
weight to be placed upon it or any person walk on it.
•
To protect the unit from overheating, do not block any vents or
openings in the unit housing that provide ventilation and allow for
sufficient space for air to circulate around the unit.
DR
A
FT
•
REVISION HISTORY
VERSION NO.
DATE DD/MM/YY SUMMARY OF CHANGE
RDV1
19/09/14
Preliminary Release
CONTENTS
1. Introduction�������������������������������������������� 1
2. Applications������������������������������������������� 1
3. Package Contents�������������������������������� 1
4. System Requirements���������������������������� 1
5. Features�������������������������������������������������� 2
6.1 Transmitter Front and Rear Panels��3
6.2 Receiver Front and Rear Panels�����4
FT
6.3. IR Cable Pin Assignment����������������5
6.4. D-Sub 9 Pin Definitions��������������������5
7. Connection Diagram���������������������������� 6
8. Specifications���������������������������������������� 7
8.1 CAT5e/6/7 Cable Specification�����8
A
8.2 Timing Support Chart�����������������������8
DR
9. Acronyms����������������������������������������������� 9
1. INTRODUCTION
The HDMI over single CAT5e/6/7 Transmitter and Receiver set can
send uncompressed audio/video and IP data over a single run of
CAT5e/6/7 cable at a distance up to 100 meter. It has the added
benefit of control through the built-in RS-232 and IR ports and a bidirectional LAN serving connection. The Receiver (PD) can be
powered by the PoE 48V function of the Transmitter (PSE), allowing for
greater flexibility in installations.
2. APPLICATIONS
• 48V PoE from Transmitter (PSE) to Receiver (PD)
FT
• Household entertainment sharing and control
• Lecture room display and control
• Showroom display and control
• Meeting room presentation and control
A
• Classroom display and control
3. PACKAGE CONTENTS
• 1×HDMI to CAT5e/6/7 (with LAN/IR/RS-232) Transmitter
DR
• 1×CAT5e/6/7 to HDMI (with LAN/IR/RS-232) Reciever
• 1×IR Blaster
• 1×IR Extender
• 1×48 V/0.83 A DC Power Adaptor
• Operation Manual
4. SYSTEM REQUIREMENTS
Input source equipment such as PS3/Blu-ray player and output HD TV/
display.
1
5. FEATURES
• HDMI with 3D, 4K2K support, HDMI & DVI Compliant
• Supports CEC bypass
• Simultaneous transmission of uncompressed data over a single
100m/328ft CAT5e/6/7 cable
• 5Play™ convergence: HDMI, LAN, PoE & Control (IR & RS-2232)
• Supports resolution up to 4K2K@50/60 & YUV_420 and 21:9
• Supports standard 48V from Transmitter (PSE) to Receiver (PD)
• Installation Friendly
Note:
FT
• Supports HDMI Input/Output cable distance up to 5m at
4K2K@50/60 & YUV_420
A
1. The standard 48V PoE function is designed for powering
compatible Receiver units only---non-PoE Receivers will need
their own power supply. Receivers of another brand may not be
compatible.
DR
2. Displaying HDMI 3D and 4K2K contents, equivalent source signal
and HDMI cable are required in order to secure the quality.
2
3. 6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
IR1
BLASTER
DC 48V
1
2
Rear
HDMI IN
IR2
EXTENDER
CAT5e/6/7 OUT
3
4
STD UPDATE
RS-232 IN
POWER
LAN
5
6
7
8
LINK
9 10
FT
1 DC 48V: Plug the 48V DC power supply into the unit and connect
the adaptor to an AC outlet.
2 IR1 BLASTER: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
A
3 IR2 EXTENDER: Connect to the supplied IR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
4 CAT5e/6/7 OUT: Connect to the Receiver unit with a single
CAT5e/6/7 cable for transmission of all data signals.
DR
5 HDMI IN: Connect to HDMI source equipment such as a DVD or
Blu-ray player.
6 STD/UPDATE Switch: This switch is reserved for factory use only.
7 RS-232 IN: Connect to a PC or Laptop with D-Sub 9-pin male cable
for the transmission of RS-232 commands.
8 LAN: Connect to an internet or network system.
9 POWER LED: This LED will illuminate when the device is connected
to a power supply.
10 LINK LED: This LED will illuminate when both the input source and
output display signals are connected through CAT cable. When
it blinks regularly it states the display is NOT sending signals to
Receiver but the Transmitter and Receiver are linked and if it blinks
irregularly it states an error has occurred.
3
6.2 Receiver Front and Rear Panels
Front
IR2
BLASTER
1
Rear
HDMI OUT
IR1
EXTENDER
CAT5e/6/7 IN
2
3
STD UPDATE
RS-232 OUT
POWER
LAN
4
5
6
7
LINK
8 9
FT
1 IR2 BLASTER: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
2 IR1 EXTENDER: Connect to the supplied IR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
3 CAT5e/6/7: Connect to the Transmitter unit with a single CAT5e/6/7
cable for transmission of all data signals.
A
4 HDMI OUT: Connect to a HDMI equipped TV/monitor for display of
the HDMI input source signal.
5 STD/UPDATE Switch: This switch is reserved for factory use only.
DR
6 RS-232 OUT: Connect to the device that is to be controlled (via
D-Sub 9-pin female cable) by RS-232 commands.
7 LAN: Connect to a PC or Laptop to utilize the Internet or network
function.
8 POWER LED: This LED will illuminate when the device is connected
to a power supply.
9 LINK LED: This LED will illuminate when both the input source and
output display signals are connected through CAT cable. When
it blinks regularly it states the display is NOT sending signals to
Receiver but the Transmitter and Receiver are linked and if it blinks
irregularly it states an error has occurred.
4
6.3. IR Cable Pin Assignment
IR Blaster
1 Power
2 IR Blaster Signal
FT
3 NC
IR Extender
1
2
A
3
6.4. D-Sub 9 Pin Definitions
Pin
N/C
DR
1
Define TX / RX
5
2
TxD / RxD
3
RxD / TxD
4
N/C
5
GND
6
N/C
7
N/C
8
N/C
9
N/C
IR Signal
Power
Grounding
7. CONNECTION DIAGRAM
RS-232 Equipped
PC or Notebook
Internet Modem
or Router
CAT5e/6
1.5m
60°
3m
7m
DVD or Blu-ray Player
RS-232
FT
IR Blaster
Power
Supply
STD UPDATE
RS-232 IN
POWER
LAN
3m
60°
IR1
BLASTER
IR2
EXTENDER
DC 48V
TX
HDMI
RX
TV or Monitor
CAT5e/6/7 OUT
A
IR Extender
LINK
HDMI IN
IR Extender
60°
3m
IR2
BLASTER
HDMI OUT
IR1
EXTENDER
IR Blaster
DR
3m
7m
STD UPDATE
CAT5e/6/7 IN
RS-232 OUT
POWER
LAN
LINK
60°
1.5m
HDMI
RS-232
CAT5e/6
Notebook
RS-232 Equipped
HDMI Switcher
6
8. SPECIFICATIONS
Video Bandwidth
340MHz / 10.2Gbps
Transmitter
Inputs
1 x HDMI
1 x IR Extender
1 x RS-232
1 x LAN
Outputs
1 x CAT5e/6/7
Inputs
FT
1 x IR Blaster
Receiver
1 x CAT5e/6/7, 1 x IR Extender
Outputs
HDMI I/O Resolution
1 x HDMI, 1 x RS-232, 1 X IR Blaster, 1 x LAN
HD: 480i~4K2K@24/25/30/50/60 & YUV_420
PC: VGA ~ WUXGA (RB)
In: 10m/1080p@8-bit or 12-bit and 5m@4K2K
A
HDMI I/O Cable
Distance
Out: 10m/1080p@8-bit, 5m/1080p@12-bit
and 5m@4K2K
CAT5e/6/7 I/O Cable
Up to 100m
DR
Distance
IR Frequency
30~50kHz
ESD Protection
Human Body Model:
±8 kV (air-gap discharge)
±4 kV (contact discharge)
Power Supply
48 V/0.83 A DC (US/EU Standards, CE/FCC/
UL certified)
Dimensions
108mm (W) x 108mm (D) x 25mm (H)
108mm (W) x 116mm (D) x 29mm (H)
Weight
370g/TX, 366g/RX
Chassis Material
Metal
Silkscreen Color
Black
Power Consumption
15w (Max)
7
Operating Temperature 0 °C~40 °C/32 °F ~104 °F
Storage Temperature
−20 °C~60 °C/−4 °F~140 °F
Relative Humidity
20~90 % RH (non-condensing)
8.1 CAT5e/6/7 Cable Specification
Cable
Range
Pixel clock
Video Data
rate
Rate
<=225 MHz
<=5.3 Gbps
Type
CAT5e/6/7
100 m
Up to 1080p,
60 Hz, 36 bits,
3D (data rates
lower than 5.3
Gbps or below
225 MHz TMDS
clock).
FT
(HD Video)
Supported
Video
70 m/
CAT5e/6
>225 MHz
(Ultra HD
A
100 m/CAT7
> 5.3 Gbps
4K2K, 30Hz
video formats
Video)
8.2 Timing Support Chart
OUTPUT
640x480@60/72/75/85
V
V
800x600@56/60/72/75/85
V
V
1024x768@60/70/75/85
V
V
1280x720@60
V
V
1280x1024@60
V
V
1600x1200@60
V
V
1920x1200@60RB
V
V
3840x2160p@24/25/30
V
V
4096x2160p@24
V
V
4096x2160p@50/60(YUV_420)
V
V
480I/576I
V
V
DR
INPUT
8
480P/576P
V
V
720P@50/60
V
V
1080I@50/60
V
V
1080P@50/60
V
V
1080P@24/25/30
V
V
9. ACRONYMS
COMPLETE TERM
CAT5e
Category 5 Cable
CAT6
Category 6 Cable
CAT7
Category 7 Cable
CEC
Consumer Electronics Control
DVI
Digital Visual Interface
HDMI
IR
High-bandwidth Digital Content Protection
High Definition Multimedia Interface
Infrared
Powered Device
DR
PD
A
HDCP
FT
ACRONYM
PSE
Power Sourcing Equipment
FT
A
DR
FT
A
DR
CYPRESS TECHNOLOGY CO., LTD
Home page: http://www.cypress.com.tw
20130524 MPM-CH1527TXRX