RW04
IEEE802.11g Wireless Access Point
Turbo-G series
The Access Point is the ideal solution for any network administrator who needs to expand the
capacity of the wireless network. This is especially applicable to wireless networks in high traffic
areas such as airports, coffee shops, shopping centers, sporting venues, and university campus
deployments. At transfer rates of up to 54Mbps and 108Mbps turbo mode in the 2.4GHz frequency
range, users connected to the device will enjoy faster downloads and truly instant email
communication.
In addition to bridging 802.11b/g wireless networks, the device can bridge to wired networks with
its integrated 10/100Mbps Ethernet port. For more secure communication, the device supports the
encryption settings up to 152-bit WEP, and advanced security of WPA and AES. With its webbased configuration the device is easy to install, alter or activate advanced setting, or update with
the latest firmware.
Features--•
•
•
•
•
•
•
Provide Ethernet to Wireless LAN bridge fully IEEE 802.3 compatible on the
Ethernet side and fully interoperable with IEEE 802.11b/g compliant equipment.
Compatible with IEEE 802.11b high rate standard to provide wireless 11Mbps
data rate
Operation at 2.4~2.5GHz to meet worldwide regulations
Allows auto fallback data rate for reliability, optimized throughput and transmission
range
Supports IEEE 802.11 b/g wireless data encryption with 64/128/152-bit WEP for security
Web-based configuration and management
Dual diversity antennas for the multi-path environment
1. Supports enhanced security – WPA, 802.1x, RADIUS client, and Cipher negotiation, and
AES
2. Supports DFS/TPC for European operations
3. Supports 10/100M Ethernet port Type approval compliant with USA, Japan, and Europe
regulation
SPECIFICATION
IEEE 802.11b Section
Standard
Radio and Modulation Schemes
Operating Frequency
Channel Numbers
Data Rate
Media Access Protocol
Transmitter Output Power
Receiver Sensitivity
IEEE 802.11g Section
Standard
Radio and Modulation Type
Operating Frequency
Channel Numbers
Data Rate
Media Access Protocol
Transmitter Output Power
Receiver Sensitivity
General Section
Interface
Antenna Type
Ethernet Standard
Operating Voltage
Current Consumption
LEDs
Wireless Setting
Wireless Band
Transmit Power Control
Radio control
Auto Channel selection
DFS/TPC
Security Setting
WEP Enable/Disable
Authentication Type
WEP Key Type
IEEE 802.11b
DQPSK, DBPSK and CCK
2400 ~ 2497MHz ISM band
11 channels for United States 13 channels for Europe
Countries 14 channels for Japan
11, 5.5, 2, and 1Mbps
CSMA/CA with ACK
Typical 18dBm at 11, 5.5, 2 and 1Mbps
Typical –83dBm for 11Mbps @ 8% PER(Packet Error Rate)
Typical –89dBm for 2Mbps @ 8% PER(Packet Error Rate)
IEEE 802.11g
BPSK, QPSK, 16QAM, 64QAM, OFDM
2400 ~ 2483.5MHz ISM band
11 channels for United States ; 13 channels for Europe
Countries ; 14 channels for Japan
108, 54, 48, 36, 24, 18, 12, 9 and 6Mbp
CSMA/CA with ACK
Typical RF Output Power at each Data Rate
+14 ~ 15dBm at 54Mbps and 108Mbps; +14 ~ 16dBm at
48Mbps;
+16 ~ 18dBm at 36, 24, 18, 12, 9, and 6Mbps
Typical Sensitivity at Which Frame (1000-byte PDUs) Error
Rate = 10%
–87dBm at 6Mbps; –86dBm at 9Mbps; –85dBm at 12Mbps;
–83dBm at 18Mbps
–80dBm at 24Mbps; –76dBm at 36Mbps;–71dBm at 48Mbps
; –66dBm at 54Mbps
Power Jack ; Factory Reset Button ; 10/100M Base-T
(UTP) ;Wireless Dipole Antenna
Dipole antennas with 2dBi gain for 2.4GHz ;
PIFA antennas with 2dBi gain for 2.4GHs -TBD
IEEE 802.3, IEEE 802.3u, IEEE 802.3x
5VDC +/- 10%
Max. 6W (TBD)
Power LED ; 10/100M LED ;Wireless LED
The Wireless Band of the AP can be viewed and set
Control TX power level from full, 50%, 25%, 12.5%, and min.
Radio on/off supported.
Scan channel and find a clear channel.
Dynamic Frequency Selection and Transmit Power Control
Enable or disable WEP for security function
Open System Authentication, Shared Key Authentication or
both enabled
WEP Key Format: Option for both Hex and ASCII
Download PDF