HobbyKing BIX 3 airplane Instruction manual

Show HTML Add to My manuals
7 Pages

advertisement

HobbyKing BIX 3 Instruction Manual | Manualzz
 PLEASE READ THIS MANUAL CAREFULLY AND
FOLLOWTHE INSTRUCTION
Thank you for choosing this classic model airplane.
This model is for beginner, intermediate and experi-
enced hobby enthusiast. Hope you have a nice time
with this wonderful model!!! Happy flying !
Disclaimer: Do not fly this Airplane at full-throttle for long
periods of time, recommended 20-25 seconds burst!
TABLE OF CONTENTS
1. Bix 3 ShecHications.......spsissa seinen anaes 2
2. Safety Instructions..... £4 ; N 2
3. Assembly Instructions... ib. ARE RT RE RES 3
4.In the box..... isos MATA love desidia ion 3
37 y 7 rn ai E 4
6. Center of Gravity (CG) otura ae
7. Charging the Li-Po Battery io mi ia ERS A 6
0. Control direacpor 065€ ;..........—. rico. sm арена нежно 7
9. Trouble dioting UN ai aa 8
10.Accessories EEE Tan ARTI is i ERATE Geass As Fad heh 9
Design Features:
1. Durable crash resistant molded EPO airframe
2. Ultra stable flight performance
BIX 3 SPECIFICATION
Specs:
Wingspan: 1550mm (61 inch)
Length: 948mm (37.3 inch)
3. Includes optional canopy for FPV equipment Weight: 890g
4, Easy assembly ESC: 20A
5. Optional wing flaps Servo: 9g x 4 (2 flap servos optional)
Radio: 6-channel
9.
Motor: 2630 KV1400 Brushless motor
Battery: Li-po 11.1v 1800-2200 mAh, 15C
SAFETY INSTRUCTIONS
. Do not fly in storms, strong winds, bad weather or lightning.
. NEVER FEC NEAR, PE pverbepd: wires, pads, railroads or
airports.
. Never fly near houses or people! Your BIX3 can cause ine to property
or injury!
. Do not fly where other models on the same frequency ar are e flying, until you
do a preflight check of all your controls.
. Make sure you do a preflight check- inspect the whole plane od make sure
the motor runs smoothly and all your controls work properly. Do this
before EACH FLIGHT!
. Use only genuine Hobby King replacement parts, < sa
. Don't try to catch the BIX3 during flight- you could be badly
Take off from and land on a suitable landing strip.
. Not recommended for children under 12 years old. Children under 14
should operate the model only with a responisble adult.
‘The BIX3 includes small parts (choking hazards) and sharp edges!
Assemble and store your plane out of the reach of children.
10. Never install batteries incorrectly- check the polarity.
(positive and negative) before connecting or installing batteries.
| 1. Keep your BIX3 out of direct sunlight (unless you're flying it!)
and away from heat sources. Foam can distort when it is overheated.
12. Fly intelligently-don't fly towards yourself or other people, or structures,
EE "7
cars, trees, animals, or anything else on the ground.
Mi
Нан” ООО
First Flight preparation
* Remove and inspect contents.
* Read this instruction manual thoroughly.
* Install the flight battery in the aircraft
(Once it tite edit fully charged).
* Ensure pushrods move freely.
+ Perform the Control Direction Test with
the transmitter
* Find a safe and open area
* Plan fight for flying field conditions
* Adjust battery “for center of gravity(CG)
« Perform a radio system Range Check
* Adjust flight controls and transmitter
* Find a safe and open area
* Plan flight for flying field Sondiions
Maintenance After Flying
* Disconnect as battery from ESC
(Required for Safety)
* Turn off transmitter
* Remove flight battery from aircraft
* Recharge flight battery |
* Repair or replace all damaged parts
* Store flight battery apart from aircraft
and monitor the battery charge
+ Make note of flight conditions and flight
plan results,planning for future flights
ww ASSEMBLY INS" 'RUCTIONS
This manual provides simple step by step assembly instructions.
However, if this i is your first pla
e, we recommend that you ask a
fellow flier for some help putting y
probably j jump at the mo os get a a at cie
Ш” WHAT'S IN THE BOX
BY ASSEMBLY
insert the metal tube into the left and right wings, connect the left Ване and
right wing together. |
Add glue on the connecting part for vertical wing. Wait fora while,
paste the vertical wing to the horizontal wing.
Put the wings on the commiting part for the fuselage, use je wing bolts to fasten
the main wings. (As shown in pictures)
Add glue as shown in picture, wait fora while, put the vertisl wing and
horizontal wing onto the right position of the fuselage.
Plug the wires into the receiver, connecting’ Connect the XT-60 connectors of the ESC
them to the appro-priateplaces. í and battery.Fasten the battery in the
(Please see the instructions on the receiver) TE place ‚Close the battery hatch.
Ш” CENTER OF GRAVITY (CG) u Assembly finished.
Add glue on A Sonilicuna part for the vs pants, glue dos: on ths tine gear
and put the ee on right position of the bottom fuselage. (As shown in pictures)
Assemble the epropeller and ins as shown in the Micros.
IY CHARGING THE LIPO BATTERY — Y” CONTROL DIRECTION TEST
WARNING- gefore plugging in the battery, turn on the transmitter 7 You should bind your aircraft and transmitter before doing these
and make sure the throttle and the throttle trim are set to OFF (all tests. Move the controls on the transmitter to make sure aircraft
control surface are moved correctly.
the way down). KEEP CLEAR OF THE PROPELLER! (Remember: that Note:Make sure tail pushrods move freely and that paint or decals
this is very sharp propeller!) ë are not adhered to them.
Open the battery hatch cover at the top of the fuselage and install the ‘
battery in the forward compartment, which is angled down towards
the nose.
Install the battery first, and then plug it in. Make sure that no wires are
out of place, and close the battery hatch.
Safety Instruction of li-poly battery
|. Do not disassemble or reconstruct the battery.
2. Do not short-circuit the battery. |
3. Do nt eee airy ny he fasion or hed cc in 90)
4. OF poe a Ge |
E Elevator
2
Co Do nor attempt direct soldering of the battery. Ee
a. Do not reverse ci arge or over discharge the battery. =
10.Do not reverse ño. or reverse connect.
IH Do not connect the battery to the ordinary charger socket or r car cigarette jack
12.Do not use the battery for unspecified equipment.
13.Do not touch the leaking battery directly,please wash your skin or clothes with water.
14.Do not mix the Li-Poly battery with other discharged battery in using.
15.Do not contínue charging the battery over the prescribed time. ;
16.Do not use or keep the battery under the direct sunlight. 6
17.Do not use the battery nearby the place where generates static electricity.
18,Do not use the battery when the environmental temperature is under 0°C or over 45°C
Aileron
19.1f you find the battery leaking smelling or à orm using it and return it to the selle
20.Keep the battery away from children. Aen : |
21 Use the specified charger and observe chiral #4 E Rudder
22.When used by minors ,parents should show them to the correct instruction.
Cautions
Do not over charge or over dis-charge battery.
ШУ” TROUBLE SHOOTING
Problem
Cause
Solution
Motor does not run
1.Battery is not fully charged.
2.The battery of ranemitial| is
not sufficient
3.Check the wire connection
inside the model
1.Charge the batteries.
2.Install a full charged
battery
3.Contact the local dealer
No reaction of the
1.The servo cable didn't plug
properly or inverted plug.
1.Check the connection of
the servo cable
control surface 2.the servo is damaged 2.Change another servo.
1.The rudder is not in the center í ¿ ;
в я 9 position of the airframe # Te De m wc
an not fly straight e main wing is not fixed in Bg
y Be 20 the center position ofthe ET the
- airframe.
Can not climb
1.The battery is not fully
charged.
| 2 .Elevator is out of trim.
1.Charge the battery
2.Adjust the trim on
the Transmitter.
Limited control range
The batteries are almost flat
Install new batteries
в
ь E
IW ACCESSORIES
< ава
Fuselage Main win Horizontal win
9310000205-0 9310000206-0 9310000207
Vertical wing por no FPV Canopy
9310000208-0 9310000209-0 931000021020
EE
Wheel pants а | Tail wheel
9310000211-0 931000 12-0 9310000213-0
||
= —-
Brushises motor Control wire-steel Spinner set
39100002150 9310000216-0 9310000217-0
1 215-0
в
TA
— il — E —е—
e Fe Re E
x
è
us = сы —— ал
+34 10 3 „Я
Decal set
9310000218-0
Flap Hinges
310000070
Pin horns
3100000861
oy т
+ pr
=
je
= “=a
5 > ; x
x
то) 5 < És Р

advertisement

Key Features

  • Durable EPO airframe
  • Ultra stable flight performance
  • Easy assembly
  • Optional wing flaps
  • Canopy for FPV equipment
  • Brushless motor
  • Li-Po battery

Related manuals

Frequently Answers and Questions

How do I charge the Li-Po battery?
The Li-Po battery should be charged using a specialized charger. Refer to the battery's instructions for specifics on charging the battery.
What should I do if the motor does not run?
First check that the battery is fully charged. If it is, check the wire connection inside the model.
What should I do if the control surfaces do not react?
Make sure the servo cable is plugged in properly and that it is not inverted. If the problem persists, the servo may be damaged and should be replaced.
What should I do if the plane can not fly straight?
Check to make sure the rudder is in the center position of the airframe and that the main wing is fixed in the center position of the airframe.
What should I do if the plane can not climb?
First ensure the battery is fully charged, then check the elevator trim on the transmitter.
Download PDF

advertisement