Samsung | RA21FASW | Samsung RA21FASW User Manual

DA68-01658A(REV0.3)01.pdf
7/8/08
11:58:07 PM
This operating instruction book covers various
models, the characteristics of your refrigerator
may differ slightly from those described in this
manual.
DA68-01658A(REV0.3)
DA68-01658A(REV0.3)02.pdf
7/8/08
3:06:09 AM
(OPTION)
(Option)
INSTALLING THE APPLIANCE
Selecting the location for appliance.
• Install the appliance
properly on the flat and
firm surface.
- Stand table option
model can not be
adjustable for the height
of appliance.
Install appliance in the available space.
about 30cm
• Allow 1 foot (30cm)
from the ceiling, and
2 inches (5 cm) from
the wall.
about 5cm
about 5cm
Install appliance in the appropriate location.
• Place the appliance
away from direct
sunlight or heat.
Do not install appliance in a damp place.
• There is a risk of
electric shock or
malfunctions.
SAFETY WARNINGS
Specification of electric power.
• The electric power specification
of the appliance is
attached inside at the top
of the door or outside at
the back.
Do not use any extension cords or double
adaptors.
• Do not plug several
appliances into the same
multiple power board.
This could cause over
heating and the risk of fire.
Earthing the appliance.
• If the socket is the
2-legged type, the
appliance must be earthed.
• Do not connect the earthing
wire to the gas pipes or telephone lines.
Replacing the lamp.
1. Unplug the power cord from the socket.
2. Remove Tray partition and shelf.
3. Unscrew by plus-type driver then take
out lamp cover.(optional model only)
4. Turn the lamp counter clockwise.
5. Replace with new lamp same specification
as original one.
Warning ! : Disconnect power supply before
replacing the lamp.
SETTING UP THE REFRIGERATOR
Step 1
Clean up inside of the refrigerator with a
clean cloth.
Step 2
Insert the power plug into the socket while
keeping the door open for checking the
interior light, then turn the temperature
control button to “MAX”.
Step 3
Close the door and let the refrigerator
operate for 2-3 hours.
Step 4
Check the refrigerator temperature by
touching inside the freezer.
Step 5
The appropriate temperature should
be controlled by turing the temperature
control button to “4”, or the desired
temperature can be adjustable. Now your
refrigerator is ready to work.
PROPER DISPOSAL OF THE REFRIGERATOR
Before you throw away your old refrigerator or freezer
When disposing of this or other refrigerators, remove
the door/door seals,door latch so that small children or
animals cannot get trapped inside.
■ Leave the shelves in place so that children may not easily
climb inside.
■ R600a or R134a is used as a refrigerant, check the
compressor label on the rear of the appliance or the
rating label inside the fridge to see which refrigerant is
used for your refrigerator.
when this product contains flammable gas (Refrigerant
R600a) contact your local authority in regard to safe
disposal of this product.
■ Cyclo Pentane used as a insulation blowing gas.
The gases in the insulation material require speacial
disposal procedure. Please dispose of the packaging
material for this product in an environmentally friendly
manner, Please contact your local authorities in regard to
the envirommentally safe disposal of this product. This
product contains flammable insulation blowing gas.
■ Please dispose of the packaging material for this product
in on environmentally friendly.
■
ICE MAKING
1)
Fill the ice tray with
water of about 80% of its
capacity, or of its “water
level” indicator.
2) Carefully place the ice tray on the freezer
shelf otherwise the splashed water will be
frozen and cause the ice tray stuck hard.
3)
For making quick ice
cubes, the temperature
control button must be set
to “ MAX”
4) The water will become the ice cubes within
3-4 hours. Please remove the ice tray by
pulling it out. Never use any kind of
instrument. This may cause damage on
the freezer.
5)
To take the ice cubes from
the ice cube tray, you should
gently twist the ice tray (As
shown), Do not bend it over.
TEMPERATURE CONTROL
The temperature control is level “2”
• The temperature at low level
“2” is used if extreme cool
is not needed.
• It is used when there is not
much food in the
refrigerator.
The temperature control is level “4”
• The temperature at level “4” is suitable for
storing food.
• It is appropriate for
operating the refrigerator.
The temperature control is level “MAX”
• “MAX” is properly used if the power cool
is in need.
• It is used when there are
a lot of food.
Wait 5
minutes
NOTE : After unplug the appliance,
wait for about 5 minutes
before restarting.
NOTE : To save energy consumption, Do not set
the refrigerator temperature lower than
necessary.
DA68-01658A REV0.2(P-05).pdf
2/27/08
4:40:18 PM
FOOD STORAGE GUIDE
Allow warm food and beverages to cool
down before storing them in the appliance.
Liquid or nasty smell food should be covered
or well-wrapped before it is stored.
Do not let the refrigerator door open for a
long while. This will cause its lost of cool air.
Do not spray water directly on the
refrigerator. This is a risk of electric shock
or leak.
Never store any bottles of beverages in the
freezer. There is a risk of bottle explosion.
Do not put the gas container near the
appliance. As the compressor starts working, it
may catch a fire on the electric circuit.
Please keep the space between shelves for
air circulation.
Do not store volatile or flamable substances in
the refrigerator. The storage of benzene, thinner,
alcohol, ether LP gas or other such substances
may cause explosions.
Avoid placing food at the front of cover
vegetable bin,
because the door
can not close and
food should be
damage.
CLEANING ACCESSORIES
• Before using, the appliance should be cleaned up.
• The appliance should be cleaned regularly.
Cleaning the exterior
Cleaning the rubber door seals
Clean the exterior with a mild detergent and cloth.
Dry it with a clean cloth.
If the rubber door seals are dirty, the door will
not does properly and the refrigerator and
freezer will be unable to function efficiently.
Clean the rubber door seals with a mild
detergent. Then wipe again with a clean cloth.
(But inside the rubber doesn’t have to be
cleaned)
Cleaning the interior and other
accessories.
After removing all the stored foods, clean the interior
and other accessories with a mild detergent and
damp cloth. Then wipe again with a clean cloth.
Warning:
• Remove the power plug before cleaning.
• Do not clean appliance with bezene, thinner, or strong detergent. This will ruin the coated materials
and become rusty.
TROUBLE SHOOTING
If there are following problems with your appliance, please check them by yourself before contacting
the service center, If you can’t find the solution, note down the appliance model and running number,
then contact the service center.
The appliance is not operating at all or the temperature is too high
1. Check that the power plug is properly connected.
2. Check that the power plug fuse has not blown.
3. Is the temperature control on the front panel set to the correct temperature?
4. Is there too much stored food? Space of food out as much as possible to improve ventilation.
The side of the appliance are normally warm
The warm sides of the appliance is not abnormal. Because the heat exchanger pipes are installed
in the front corners of the appliance to prevent condensation from defrosting. In vety humid weater,
condensation may form on the outer surface of the appliance when moisture in the air comes into
contact with the cool surface of the appliance. Thus, do not cover the refrigerator with cloth or other
materials.
Download PDF