Samsung | SWT65D2 | Samsung SWT65D2 User Manual

DESCRIPTION OF PARTS
FEATURES
POWERFUL WASHING BY LARGE PULSATOR
SPIN DRYER LID
INNER LID
This washing machine has a big pulsator so that it
can wash a lot of laundry evenly.
TWO WAY LINT FILTER
Two way lint fiter strains off the lint during washing.
So you can wash laundry cleanly.
NORMAL OR SOFT SELECTOR
You can wash laundry effetively by
two types,Normal or Soft.
CAUTIONS
When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by breake system.
WATER DRAIN
HOSE
(with pump)
SPIN DRYER BASKET
OVERFLOW
FILTER
SPIN DRYER HATCH
LINT FILTER
POWER CORD
The plug’s shape may not
correspond with this drawing.
WASH TUB
Be sure that the washer is grounded.
Disconnect the power cord from the
power supply when not in use.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
WASH TUB LID
DRAIN FILTER
Be sure to keep the lid
closed during washing
and spinning.
EARTH WIRE
Ventilation opening must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
Do not put your hands into the spin
dryer basket when it is spinning.
Your fingers can be caught
by spinning laundry and
damaged.
WATER DRAIN HOSE
If the supply cord of this appliance is damaged,
(WITHOUT PUMP)
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
PULSATOR
CONTROL PANEL
Warning to avoid overfilling and damages
this appliance must be filled with the
operator present using a moderate water
supply pressure only.
Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
This appliance is to be connected to the water
mains using new hose-sets and that
old hose-sets should not be reused.
1. WASH SELECTOR
4. SPIN DRY TIMER
This is used to select wash action.
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
Before washing,check all pockets.
During washing,WATER GUIDE KNOB
should be selected to wash.
During spin rinsing,WATER GUIDE KNOB
should be selected to spin.
This is used to set the wash time, 1-15 minutes.
3. CYCLE SELECTOR
This is used to set the Washing/Rinsing or Draining.
PRECAUTIONS WHEN OPERATING
Don't use excessively hot water.
(50 or more)
This is used to set the spin time, 1-5 minutes.
5. WATER SELECTOR
2. WASH TIMMER
WASH/RINSE
DELICATE
SOFT
NORMAL
DRAIN
WASH
W ASH S E L E C T O R
W A S H TI M E R
C Y C L E S ELE CT O R
SPIN
WATER SELECTOR
SPIN DRY TIMER
SW-T65B1, SWT65C1
To avoid water splashes,
close the wash tub lid.
If nails or pins remain in pockets,they may
damage the washer or clothes.
WASH/RINSE
DELICATE
SOFT
Close the water tap a little if the
water pressure is too high.
NORMAL
DRAIN
Never splash water on the control panel.
W ASH S E L E C T O R
W A S H TIM E R
CYCLE SELECTOR
SPIN DRY TIMER
SW-T65A1
1
2
WASHING PROCEDURE
TO WASH
RINSING
1. Before starting washing, check following;
Connect the water supply hose.
- Lay the drain hose down toward a sinkhole.
(In case no drain pump)
- Place the drain hose in sink or bath.
(In case drain pump)
- Connect the power cord to the power supply outlet .
5. Fill water in the wash tub
to the L lower water
level by carefully and
add the detergent.
2. Set the WASH SELECTOR KNOB
NORMAL
SOFT
to the desired mode.
6. Load laundry in the
wash tub and fill
water to proper
water level.
WASH SELECTOR
3. Set the WASH TIMER
2~3minutes.
1. Set the CYCLE SELECTOR KNOB to
WASH RINSE . (In case drain pump WASH )
4. Drain the water.
Set the CYCLE
SELECTOR
KNOB to DRAIN
2. Supply the proper amount of water
as not to overflow the top of the
washing tub.
5.Repeat this cycle until drain water
is clean. (2~3 cycle)
3. Set the WATER SELECTOR KNOB
to the desired mode.
(FOR SW-T65B1, SWT65C1)
WASH
SPIN
7. Set the WASH TIMER
1-15minutes.
OVER FLOW RINSE
3.As soon as the WASH TIMER
shuts off, turn off the water tap.
1.Keep suppling water(adjust water pressure
to ensure that the amount of water supplied
does not exceed that water drained.)
4. Set the CYCLE SELECTOR KNOB to
WASH RINSE . (in case drain pump WASH )
8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN for drain.
2.Set the WASH
TIMER 6~8minutes.
4. Set the CYCLE
SELECTOR KNOB
to DRAIN .
SPIN DRY
1. Transfer the clothes into the spin basket
and arrange the clothes evenly.
3. Close the spin dryer lid.
ADDITIONAL RINSE (SHOWER RINSE)(FOR SW-T65B1, SWT65C1-Option)
After rinsing you can select this
After stopping water
for more effective rinse
1 course
(Don't select only this course
inner lid
for rinse.) Load the laundry
evenly into the spin basket.
2. Be sure to attach the safety cover and
close the inner lid.
safety cover
4 supply, cover the
laundry with safety cover
and close the inner lid.
4. Set the SPIN DRY TIMER 1-5minutes.
the WATER SELECTOR
2 Set
KNOB to
WASH
the spin dryer
5 Close
lid.
SPIN
SPIN and CYCLE
SELECTOR KNOB to
‘DRAIN’.
inner lid
safty cover
water for about 1minute.
3 Supply
Adjust the water flow to prevent
the SPIN DRY
6 Set
TIMER 2~3 minutes.
overflow from the wash tub.
3
4
LAUNDRY GUIDE
INSTALLATION
ENVIRONMENT
Leave some space
1. Before connecting the drain hose, remove the
cover (a) from the drain hole.
2. After pressing the joint ring (b), insert the drain
hose(c) to drain direction.
Space at least 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2 )
Never install the washer near water.
(a)
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
(b)
(b)
(In case of pump drained washer)
Avoid direct sunlight or heating devices.
MOUNTING THE LEGS
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Lay down the washer with its back facing downward.
Insert four legs into the leg mounting sections of the
base corners of the main body.
Claw
Insert the claw of the leg with the
Square hole
square hole of the leg
2
mounting section, and
1
push the leg in the arrow
direction as shown in the
figure until it clicks.
70~80cm
Install the drain hose about
70~80cm above the ground
for pump model.
(C)
(C)
SPIN DRY TIME
WASHING TIME
CONNECTING THE DRAIN HOSE
Bottom face of main body
LEG
CLEANING THE MACHINE
KINDS OF CLOTHING
Extremely solid heavy fabric
WASHING
WASHING TIME SELECTION
1~2min.
10 to15minutes
NORMAL
Linen,cotton,etc.
8 to10minutes
Ordinary clothes
(underwear,etc)
7minutes
Slightly solied synthetic
fiber
2 to 5minutes
100%wool,mixed wool knitting,
thin synthetic fiber with tags
indicating hand washing
OVERFLOW FILTER
If the dregs are filled up in the lint filter after
finishing the wash, push down and pull it
out as shown in figure.
Remove the collected lint and rinse the filter net.
Pull the upper side of the overflow filter
with two fingers into the hole ‘A’
in the direction of arrow as
shown in the figure.
1
AMOUNT OF
DETERGENT
SOFT
2 to 5minutes
2
DRAIN FILTER
In case of incomplete drain,disassemble
the drain filter with screw driver(+), and
remove lints from the filter as shown
in the filter as shown in the figure.
Low
40g
Middle(40 )
50g
High
(30 )
(50 )
TO PICK OUT THE CLOTHING WHICH HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safty,pull the power supply plug out of the socket.
1.Disassemble a screw from the spin dryer hatch.
2.The spin dryer hatch is fixed to the brim by the concave and convex
parts at two places.
Expand the concave and
convex parts, and pull up
the spin dryer hatch to remove it.
3. Remove the clothing
4. Close the spin dryer hatch.
Push in hatch firmly until
the catch at the front is
engaged securely.
TROUBLE SHOOTING
TROUBLE
CLEANING THE WASHER BODY
5
30g
MAINTENANCE
WHEN YOU LOAD THE LAUNDRY INTO
THE SPIN BASKET.
Press the laundry evenly and put the safety
cover into the spin basket drum as shown in
the figure.
The washer
does not work.
Wipe off strains on the cabinet and operation panel
with soft cloth.Do not use benzene, thinners, cleanser,
or wax, nor scrub the washer with a brush.
Painted surfaces or piastic parts wii be damaged.
WATER
LEVEL
The amount of detergent is average.
Follow the instruction detergent printed
on the package for amount of detergent.
Choose the amount of detergent
depending on the fabric type.
CLEANING THE WASH TUB
First,fill water in the wash tub to ‘L’ level, then drain
water from the wash tub simultaneously with
operating wash cycle for 1~2 minutes.
Close the wash tub lid.
3~5min.
5min.
DETERGENT
A
CLENING THE LINT FILTER
TYPE OF LAUNDRY
Thin(synthetic fiber)
wool
cotton
thick(cotton)
TIME
1min.
CHECK POINT
TROUBLE
Check that the power cord is
connected to a power outlet well.
Power stoppage?
Clothes will
not move freely.
Is the laundry overloaded?
Incomplete
spinning
Are the laundry arranged evenly?
6
CHECK POINT
Incomplete
draining
Is the filter clogged
with lint?
See “Cleaning the
machine” on page 5.
The spin dryer
basket will not
run.
Is the spin dryer lid closed
completely?
Are laundry(socks,etc.) falling
out of the spin dryer basket and
clinging to the axle?
See To pick out... on page 6.
IF YOU NEED HELP.
Do not hesitate to call your local samsung service center.
They will be willing to help you.
Be sure to give them your name,address,telephone number and the purpose of the call.
Owner’s Instructions
SW-T65A1(P)/SW-T65B1(P)/
SWT65C1(P)
SPECIFICATION
Before operating the unit, please read this manual
throughly, and retain for future reference.
DIMENSIONS (mm)
FEATURES
CAUTIONS
PRECAUTIONS WHEN OPERATING
DESCRIPTION OF PARTS
CONTROL PANEL
WASHING PROCEDURE
TO WASH
SPIN DRY
RINSING
OVER FLOW RINSE
ADDITIONAL RINSE
INSTALLATION
ENVIRONMENT
CONNECTING THE DRAIN HOSE
MOUNTING THE LEGS
CLEANING THE MACHINE
LAUNDRY GUIDE
MAINTENANCE
TROUBLE SHOOTING
SPECIFICATIONS
1
1
1
2
2
3
3
3
4
4
4
5
5
5
5
5
6
6
6
WATER PRESSURE
WEIGHT
EXTRACTION EFFICIENCY
STANDARD QUANTITY OF WATER
RATING TIME
CAPACITY
SW-T65A1P
SW-T65B1P
SWT65C1P
W 776mm D 434mm H 844mm
W 776mm D 444mm H 953mm
W 776mm D 436mm H 941mm
0.05~0.78 MPa
0.5 ~ 8.0
f/
SW-T65A1
24kg
SW-T65A1P
26kg
SW-T65B1
26kg
SW-T65B1P
28kg
SWT65C1
26kg
SWT65C1P
28kg
50 %
50
Washing 1Hour
Spinning 15minutes
(Maximum dry mass textiles)
4.5kg
MOTOR MAX INPUT
450W
DC68-00274A
Download PDF