Samsung | SWT80H2 | Samsung SWT80H2 User Manual

BEFORE USING THE WASHER
●
In case of pump drained washer,
remove the cap-hose from
the drain hole.
CAUTIONS
●
Be sure that the washer is grounded.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid
dangers of explosion or lightning strike.
●
●
Ventilation opening must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
●
Do not put your hands into the spin
dryer basket when it is spinning.
Your fingers can be caught
by spinning laundry and
damaged.
●
If the supply cord of this appliance is damaged,
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
●
Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
●
Warning to avoid overfilling and damages
this appliance must be filled with the operator
present using a moderate water supply
pressure only.
Disconnect the power cord from the
power supply when not in use.
PRECAUTIONS WHEN OPERATING
●
Don't use excessively hot water.
(50˚C or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
●
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
●
Close the water tap a little if the
water pressure is too high.
1
●
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
●
To avoid water splashes,
close the wash tub lid.
●
Be sure lay the drain hose down
(in case no drain pump)
●
Never splash water on the control panel.
DESCRIPTION OF PARTS
SPIN DRYER LID
When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by brake system.
INNER LID
POWER CORD
The plug’s shape may not
correspond with this drawing.
DRAIN HOSE
(WITH PUMP)
SPIN DRYER
BASKET
LINT FILTER
WASH TUB
WASH TUB LID
Be sure to keep the lid
closed during washing
and spinning.
WATER DRAIN HOSE
(WITHOUT PUMP)
PULSATOR
DRAIN FILTER
(with pump)
CONTROL PANEL
1. WASH SELECTOR
4. SPIN DRY TIMER
This is used to select wash action.
This is used to set the spin time, 1-5 minutes.(or 1-10 minutes)
5.WATER SELECTOR
2. WASH TIMER
This is used to set the wash time, 1-15 minutes.
During washing,WATER SELECTOR KNOB should
be selected to wash.During spin rinsing,WATER
SELECTOR KNOB should be selected to spin.
3. CYCLE SELECTOR
This is used to select the Washing /
Rinsing or draining
1
2
5
3
2
4
WASHING PROCEDURE
TO WASH
1. Before starting washing, check the following;
Connect the water supply hose and open the water tap.
- Lay the drain hose down toward a sinkhole.
(In case no drain pump)
- Place the drain hose in sink or bath.
(In case drain pump)
-Connect the power cord to the power supply outlet .
2. Set the WASH SELECTOR KNOB
to the desired mode.
6. Fill water in the wash tub
and add the detergent.
7. Set the WASH TIMER 1-15minutes.
3. Set the CYCLE SELECTOR KNOB to
‘WASH RINSE’. (In case drain pump “WASH”)
●
8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.
4. Set the WATER SELECTOR
KNOB to WASH . FOR B TYPE
5. Load laundry in the
wash tub.
SPIN DRY
1. Transfer the clothes into the spin basket
and arrange the clothes evenly.
3. Close the spin dryer lid.
2. Be sure to attach the safety cover and
close the inner lid.
4. Set the SPIN DRY TIMER 1-5minutes.
(or 1-10minutes)
inner lid
safty cover
3
RINSING
1. Set the CYCLE SELECTOR KNOB to
‘WASH RINSE’. (In case drain pump “WASH”)
3. Set the WASH TIMER
2~3minutes.
4. Drain the water.
Set the CYCLE
SELECTOR
KNOB to ‘DRAIN’
2. Supply the proper amount of water
as not to overflow the top of the
washing tub.
5.Repeat this cycle until drain water
is clean. (2~3 cycles)
OVER FLOW RINSE
1.Keep suppling water
Adjust water pressure to ensure
that the amount of water supplied
does not exceed that water drained.
(Without pump)
3.As soon as the WASH TIMER
shuts off, turn off the water tap.
(With pump)
2.Set the WASH
TIMER 6~8minutes.
4. Set the CYCLE
SELECTOR KNOB
to ‘DRAIN’.
ADDITIONAL RINSE
After rinsing you can select this
After stopping water
for more effective rinse
1 course
(Don't select only this course
inner lid
for rinse.) Load the laundry
evenly into the spin basket.
2
safety cover
Set the WATER SELECTOR KNOB to
SPIN and CYCLE
SELECTOR KNOB to
‘DRAIN’.
4 supply, cover the
laundry with safety cover
and close the inner lid.
the spin dryer
5 Close
lid.
water for about 1minute.
3 Supply
Adjust the water flow to prevent
the SPIN DRY
6 Set
TIMER 2~3 minutes.
overflow from the wash tub.
4
INSTALLATION
HOW TO CLEAN THE FILTER (In case drain pump)
ENVIRONMENT
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise until it
locks in position.
Leave some space
Space at last 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2˚)
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
CONNECTING THE DRAIN HOSE
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
a
b
Install the drain hose about
70~80cm above the ground
for pump model.
CLEANING THE MACHINE
A
CLEANING THE LINT FILTER
OVERFLOW FILTER
If the dregs are filled up in the lint filter after
finishing the wash, push down and pull it
out as shown in figure.
Remove the collected lint and rinse the filter net.
Pull the upper side of the overflow filter
with two fingers into the hole ‘A’
in the direction of arrow as
shown in the figure.
1
2
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
5
LAUNDRY GUIDE
SPIN DRY TIME
WASHING TIME
KINDS OF CLOTHING
Extremely solid heavy fabric
TIME
1min.
WASHING
WASHING TIME SELECTION
1~2min.
10 to15minutes
3~5min.
5min.
NORMAL
Linen,cotton,etc.
8 to10minutes
Ordinary clothes
(underwear,etc)
7minutes
Slightly solied synthetic
fiber
2 to 5minutes
100%wool,mixed wool knitting,
thin synthetic fiber with tags
indicating hand washing
TYPE OF LAUNDRY
Thin(synthetic fiber)
wool
cotton
thick(cotton)
DETERGENT
AMOUNT OF
DETERGENT
WATER
LEVEL
37 g
Low (37l)
SOFT
2 to 5minutes
45 g
Mid (45l)
54 g
High (54l)
The amount of detergent is average.
Follow the instruction detergent printed
on the package for amount of detergent.
Choose the amount of detergent
depending on the fabric type.
MAINTENANCE
WHEN YOU LOAD THE LAUNDRY INTO
THE SPIN BASKET.
Press the laundry evenly and put the safety
cover into the spin basket drum as shown in
the figure.
TO PICK OUT THE CLOTHING WHICH HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safty, pull the power supply plug out of the socket.
1. Disassemble a screw from the spin dryer hatch.
2. The spin dryer hatch is fixed to the brim by the concave
and convex parts at two places. Expand the concave
and convex parts, and pull up the spin
dryer hatch to remove it.
3. Remove the clothing
4. Close the spin dryer hatch.
Push in hatch firmly until
the catch at the front is
engaged securely.
screw
TROUBLE SHOOTING
TROUBLE
CHECK POINT
The washer
does not work.
Check that the power cord is
connected to a power outlet well.
Power stoppage?
TROUBLE
Is the filter
Clothes will
not move freely. Is the laundry overloaded?
Incomplete
spinning
CHECK POINT
Incomplete
draining
The spin dryer
basket will not
run.
Are the laundry arranged evenly?
6
clogged
with lint?
Is the spin dryer lid closed
completely?
Are laundry(socks,etc.)falling
out of the spin dryer basket and
clinging to the axle?
❍ See “To pick out...”
on page 6.
Owner’s Instructions
SWT80H0(P)/SWT80H1(P)/SWT80H2(P)
Before operating the unit, please read this manual throughly,
and retain for future reference.
BEFORE USING THE WASHER
CAUTIONS
PRECAUTIONS WHEN OPERATING
DESCRIPTION OF PARTS
CONTROL PANEL
WASHING PROCEDURE
TO WASH
SPIN DRY
RINSING
OVER FLOW RINSE
ADDITIONAL RINSE
INSTALLATION
ENVIRONMENT
HOW TO CLEAN THE FILTER
CONNECTING DRAIN HOSE
CLEANING THE MACHINE
LAUNDRY GUIDE
MAINTENANCE
TROUBLESHOOTING
SPECIFICATIONS
1
1
1
2
2
3
3
3
4
4
4
5
5
5
5
5
6
6
6
IF YOU NEED HELP.
Do not hesitate to call your local samsung service center.
They will be willing to help you.
Be sure to give them your name,address,telephone number and the purpose of the call.
SPECIFICATION
792 x 465 x 951
DIMENSIONS (W x D x H)mm
0.05~0.78 MPa
0.5 ~ 8.0 kg.f/cm2
29 kg
31 kg
50 %
WATER PRESSURE
WEIGHT
With out pump
With pump
EXTRACTION EFFICIENCY
54l
6.0kg
6.0kg
340W
200W
480W
STANDARD QUANTITY OF WATER
NOMAL CAPACITY
Washing
Spinning
Washing
MOTOR INPUT
MOTOR MAX INPUT
RATING TIME
Spinning
Washing 1Hour
Spinning 15minutes
DC68-01287A
Download PDF