Samsung | WT80B1 | Samsung WT80B1 User Manual

Owner’s Instructions
SWT70A1/ SWT70B1/ SWT75A1
Before operating the unit, please read this manual
throughly, and retain for future reference.
BEFORE USING THE WASHER
CAUTIONS
PRECAUTIONS WHEN OPERATING
DESCRIPTION OF PARTS
CONTROL PANEL
WASHING PROCEDURE
To wash
Spin dry
Rinsing
Over flow rinse
Additional rinse
INSTALLATION
Environment
Changing the position of the drain hose
How to clean the filter
CLEANING THE MACHINE
AFTER OPERATION
LAUNDRY GUIDE
MAINTENANCE
TROUBLESHOOTING
SPECIFICATIONS
1
1
1
2
2
3
3
3
4
4
4
5
5
5
5
5
5
6
6
6
BEFORE USING THE WASHER
● Remove the cap-hose from the drain
● In case of pump drained washer,
remove the cap-hose from
the drain hole.
hose.
CAUTIONS
● Disconnect the power cord from the
power supply when not in use.
● Be sure that the washer is grounded.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
● Ventilation opnning must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
● Do not put your hands into the spin
dryer basket when it is spinning.
● If the supply cord of this appliance is damaged,
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
Your fingers can be caught
by spinning laundry and
damaged.
● Warning to avoid overfilling and damages
this appliance must be filled with the
operator present using a moderate water
supply pressure only.
● Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
● Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this
or any other appliance.
PRECAUTIONS WHEN OPERATING
●
●
Don't use excessively hot water.
(50˚C or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
● Be sure to cover with the inner
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
● To avoid water splashes,
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
close the wash tub lid.
● Close the water tap a little if the
● Never splash water on the control panel.
water pressure is too high.
1
DESCRIPTION OF PARTS
SPIN DRYER LID
When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by breake system.
INNER LID
WASH TUB LID
SPIN DRYER BASKET
Be sure to keep the lid
closed during washing
and spinning.
SPIN DRYER HATCH
EARTH WIRE
WASH TUB
STRAINER (FILTER)
POWER CORD
The plug’s shape may not
correspond with this drawing.
PULSATOR
WATER DRAIN HOSE
(WITHOUT PUMP)
CONTROL PANEL
1.WASH TIMMER
4.SPIN DRY TIMER
This is used to set the spin time, 1-5 minutes.
This is used to set the wash time, 1-15 minutes.
2.WASH SELECTOR
5.WATER INTAKE
3.CYCLE SELECTOR
6.WATER SELECTOR
Connect water inlet to a tap with a suitable hose.
Refer to the washing time and washing selection.
(For SWT70B1, SWT75A1)
During washing, WATER SELECTOR KNOB should
be selected to wash. During spin rinsing, WATER
SELECTOR KNOB should be selected to spin.
This is used to set the Washing/Rinsing or draining.
SWT70B1
SWT70A1
2
SWT75A1
WASHING PROCEDURE
TO WASH
1. Before starting washing, check following;
Connect the water supply hose.
- Lay the drain hose down toward a sinkhole.
(In case no drain pump)
- Place the drain hose in sink or bath.
(In case drain pump)
-Connect the power cord to the power supply outlet .
2. Set the WASH SELECTOR KNOB
to the desired mode.
SOFT
5. Fill water in the wash tub
to the ‘L’ lower water
level by carefully and
add the detergent.
6. Load laundry in the
wash tub and fill
water to proper
water level.
HEAVY
3. Set the CYCLE SELECTOR KNOB to
‘WASH.URINSE’.
WASH . RINSE
7. Set the WASH TIMER
1-15minutes.
WASH
DRAIN
CYCLE SELECTOR
RINSE
DRAIN
CYCLE SELECTOR
WASH TIMER
(in case drain pump ‘WASH’)
8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.
4. Set the WATER SELECTOR KNOB
to ‘WASH’ (For SWT70B1, SWT75A1)
WASH
DRAIN
SPIN
CYCLE SELECTOR
SPIN DRY
1. Transfer the clothes into the spin basket
and arrange the clothes evenly.
3. Close the spin dryer lid.
2. Be sure to attach the safety cover and
close the inner lid.
4. Set the SPIN DRY TIMER 1-5minutes.
inner lid
safty cover
SPIN DRY TIMER
3
RINSING
1. Set the WATER GUIDE
KNOB to “WASH”
4. Set the WASH TIMER
2~3minutes.
(For SWT70B1, SWT75A1)
WASH
SPIN
2. Set the CYCLE SELECTOR KNOB to
‘WASH.RINSE’
WASH . RINSE
WASH TIMER
WASH
DRAIN
RINSE
CYCLE SELECTOR
5. Drain the water.
Set the CYCLE
SELECTOR KNOB to
‘DRAIN’.
DRAIN
CYCLE SELECTOR
(in case drain pump “WASH)
DRAIN
CYCLE SELECTOR
6.Repeat this cycle until drain water
is clean. (2~3 cycle)
3. Supply the proper amount of water
as not to overflow the top of the
washing tub.
OVER FLOW RINSE
1.Keep suppling water(adjust water pressure
3.As soon as the WASH TIMER
shuts off, turn off the water tap.
to ensure that the amount of water supplied
does not exceed that water drained.)
WASH . RINSE
WASH
DRAIN
CYCLE SELECTOR
RINSE
DRAIN
CYCLE SELECTOR
(in case drain pump “WASH)
WASH TIMER
2.Set the WASH
TIMER 6~8minutes.
4. Set the CYCLE
SELECTOR KNOB
to ‘DRAIN’.
DRAIN
CYCLE SELECTOR
WASH TIMER
ADDITIONAL RINSE (SHOWER RINSE FOR SWT70B1, SWT75A1)
After rinsing you can select this
After stopping water
for more effective rinse
1 course
(Don't select only this course
4 supply, cover the
inner lid
laundry with safety cover
safety cover
and close the inner lid.
for rinse.) Load the laundry
evenly into the spin basket.
the WATER SELECTOR KNOB to SPIN for
2 Set
5 Close the spin dryer lid.
SWT70B1, and CYCLE
SELECTOR KNOB to
‘DRAIN’.
WASH
SPIN
DRAIN
CYCLE SELECTOR
water for about 1minute.
3 Supply
Adjust the water flow to prevent
the SPIN DRY
6 Set
TIMER 2~3 minutes.
overflow from the wash tub.
SPIN DRY TIMER
4
INSTALLATION
ENVIRONMENT
CHANGING THE POSITION OF THE DRAIN HOSE
Before attempting to change the position of the drain hose,
disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole and
insert the drain hose into the hose holder.
Leave some space
Space at least 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2˚)
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
1
2
Hose holder
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise until it
Open
locks in position.
70~80cm
Install the drain hose about
70~80cm above the ground
for pump model.
HOW TO CLEAN THE FILTER (In case drain pump)
Filter
Close
Rag
CLEANING THE MACHINE
CLENING THE LINT FILTER
CLEANING THE WASH TUB
-If the dregs are piled up in the lint filter after finishing
the wash, push down and pull it out as shown in figure.
-Wash the filter net in water.
Wipe off strains on the cabinet and operation panel
with soft cloth.
Do not use benzene, thinners, cleanser, or wax,
nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
AFTER OPERATION
1. Remove the power cord from the outlet.
2. Take out the laundry.
3. Close the water tap and disconnect the water supply hose.
4. Clean the washing machine.
-Periodical cleaning will extend the life of your washing machine.
-Do not spray the unit water or use tinner, benzene, alcohol etc, for cleaning it.
5
LAUNDRY GUIDE
SPIN DRY TIME
WASHING TIME
KINDS OF CLOTHING
Extremely solid heavy fabric
10 to15minutes
Linen,cotton,etc.
8 to10minutes
Ordinary clothes
(underwear,etc)
7minutes
Slightly solied synthetic
fiber
2 to 5minutes
100%wool,mixed wool knitting,
thin synthetic fiber with tags
indicating hand washing
TYPE OF LAUNDRY
TIME
1min.
WASHING TIME
1~2min.
Thin(synthetic fiber)
wool
3~5min.
5min.
cotton
thick(cotton)
DETERGENT
2 to 5minutes
AMOUNT OF DETERGENT
WATER
LEVEL
32 g
Low (32l)
40 g
Mid (40l)
50 g
High (50l)
The amount of detergent is average.
Follow the instruction detergent printed
on the package for amount of detergent.
Choose the amount of detergent
depending on the fabric type.
MAINTENANCE
WHEN YOU LOAD THE LAUNDRY INTO
THE SPIN BASKET.
Press the laundry evenly and put the safety
cover into the spin basket drum as shown in
the figure.
TO PICK OUT THE CLOTHING WHICH HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safty,pull the power supply plug out of the socket.
1. Disassemble two screws from the spin dryer hatch.
2. The spin dryer hatch is fixed to the brim by the concave
and convex parts at two places. Expand the concave
and convex parts, and pull up the spin
dryer hatch to remove it.
3. Remove the clothing
4. Close the spin dryer hatch.
Push in hatch firmly until
the catch at the front is
engaged securely.
TROUBLE SHOOTING
TROUBLE
The washer
does not work.
CHECK POINT
TROUBLE
Check that the power cord is
connected to a power outlet well.
Power stoppage?
Clothes will
not move freely.
Is the laundry overloaded?
Incomplete
spinning
Are the laundry arranged evenly?
6
Incomplete
draining
CHECK POINT
Is the filter clogged
with lint?
● See “Cleaning the
machine” on page 5.
Is the spin dryer lid closed
completely?
The spin dryer Are laundry(socks,etc.) falling
basket will not out of the spin dryer basket and
run.
clinging to the axle?
● See “To pick out...”on page 6.
IF YOU NEED HELP.
Do not hesitate to call your local samsung service center.
They will be willing to help you.
Be sure to give them your name,address,telephone number and the purpose of the call.
SPECIFICATION
MODEL
SWT70A1
DIMENSIONS (W x D x H)mm
812 x 448 x 957
WATER PRESSURE
WEIGHT
With out pump
With pump
SWT70B1
812 x 448 x 918
SWT75A1
812 x 448 x 995
0.05~0.78 MPa
0.5 ~ 8.0 kg.f/cm2
29 kg
31 kg
EXTRACTION EFFICIENCY
50 %
STANDARD QUANTITY OF WATER
50 l
RATING TIME
Washing 1Hour / Spinning 15minutes
DC68 - 00100A
Download PDF