DV7210F | Black&Decker DV7210F DUSTBUSTER Type H1 instruction manual

®
www.blackanddecker.com.au
DV9610F-XE
DV7210F-XE
Australia
New Zealand
B
C
D
E
2
E
A
F
G
H
I
J
3
ENGLISH
(Original instructions)
Intended use
Your Black & Decker Dustbuster® handheld vacuum cleaner
has been designed for light dry vacuum cleaning purposes.
This appliance is intended for household use only.
Safety instructions
@
@
Warning! Read all safety warnings and all
instructions.Failure to follow the warnings and
instructions listed below may result in electric shock,
fire and /or serious injury.
Warning!When using battery-powered appliances,
basic safety precautions, including the following,
should always be followed to reduce the risk of fire,
leaking batteries, personal injury and material
damage.
Do not use the appliance if any part is damaged or
defective.
u Have any damaged or defective parts repaired or replaced
by an authorized repair agent.
u Regularly check the charger lead for damage. Replace the
charger if the lead is damaged or defective.
u Never attempt to remove or replace any parts other than
those specified in this manual.
u
Additional safety instructions
After use
u
u
u
Read all of this manual carefully before using the
appliance.
u The intended use is described in this manual. The use of
any accessory or attachment or the performance of any
operation with this appliance other than those
recommended in this instruction manual may present a risk
of personal injury.
u Retain this manual for future reference.
u
Using your appliance
Do not use the appliance to pick up liquids or any materials
that could catch fire.
u Do not use the appliance near water.
u Do not immerse the appliance in water.
u Never pull the charger lead to discon-nect the charger
from the socket. Keep the charger lead away from heat, oil
and sharp edges.
u This appliance can be used by chil-dren aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction
concerning use of the appli-ance in a safe way and
understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
u
Inspection and repairs
u
4
Before use, check the appliance for damaged or defective
parts. Check for breakage of parts, damage to switches
and any other conditions that may affect its operation.
Unplug the charger before cleaning the charger or charging base.
When not in use, the appliance should be stored in a dry
place.
Children should not have access to stored appliances.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any rotating/moving parts.
u Injuries caused when changing any parts, blades or accessories.
u Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods ensure you take regular
breaks.
u Impairment of hearing.
u Health hazards caused by breathing dust developed when
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Batteries and chargers
Batteries
u
u
u
u
u
u
u
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the temperature may
exceed 40°C.
Charge only at ambient temperatures between 10°C and
40°C.
Charge only using the charger provided with the appliance/tool. Using the wrong charger could result in an
electric shock or overheating of the battery.
When disposing of batteries, follow the instructions given
u
u
u
u
in the section "Protecting the environment".
Do not damage/deform the battery pack either by puncture
Do not charge damaged batteries.
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries carefully wipe the
liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
below.
Warning!
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
check that the mains voltage corresponds to the voltage on
the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
u Use your Black & Decker charger only to charge the battery in the appliance/tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
u Never attempt to charge nonrechargeable batteries.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/tool/battery must be placed in a well ventilated area when charging.
Electrical safety
check that the mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the charger unit with
a regular mains plug.
Symbols on the charger
#
Read all of this manual carefully before using the
appliance.
w
x
$
(Original instructions)
ENGLISH
Short circuit proof safety isolating transformer. The
mains supply is electrically separated from the
transformer output.
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
The charging base is intended for indoor use only.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Charging indicator
4. Charging socket
5. Dust bowl
6. Nozzle
7. Extention tubes
8. Floor head
Fig. A
9.
10. Filter
Installation
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
suitable for the wall type and is appropriate to the weight of
the appliance.
u Mark the location of the screw holes (within reach of an
electrical outlet for chargeing the vac while it is on the wall
bracket).
u Insert the charger cord into the curved slot in the wall
mount bracket leaving approximately 8-9 inches excess.
u Hang the appliance on the wall by placing the opening
on the base of the vac over the hooks in the wall mount
bracket.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
5
ENGLISH
(Original instructions)
Assembly
Optimising the suction force
cleared regularly during use.
These models may be supplied with some of the following
accessories:
u Extention tubes (7).
u Floor head (8).
u
Fit the extention tubes (7) together.
u
u
u
tubes.
Fit the narrow end of the extention tubes (7) into the appliance.
Alternatively, to use as a hand-held cleaner with brush on
appliance.
Emptying and cleaning the product.
Pre-filter (fig. I) (DV7210F-XE)
The Filter and pre- filter can be separated to allow better
cleaning.
u Twist the pre-filter (15) in a clockwise direction and lift from
the filter (13).
(DV9610F-XE)
u
u
u
Press the release latchs (12) and pull the nozzle (6)
straight off.
Empty the contents of the bowl.
To replace the nozzle, place it back onto the handle until it
Use
u
24 hours.
Charging the battery (Fig. D)
Make sure that the appliance is switched off. The battery
will not be charged with the on/off switch in the on position.
u Plug the jack plug of the charger into the charging socket
(4) of the appliance.
u Plug in the charger. Switch on at the mains. The charging
indicator (3) will be lit.
u Leave the appliance to charge for at least 16 hours.
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
u
indicator (3) will be lit as long as the appliance is connected to
the plugged-in charger.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C.
u
u
To switch the appliance on, slide the on/off switch (1)
forward to position 1.
To switch the appliance off, slide the on/off switch (1) back
to position 0.
the bristles on the brush.
u Lower the bristles for cleaning carpets or rugs.
u
tile or marble.
6
Warning!
regularly.
u Press the release latch (2) and pull the dust bowl (5)
straight off.
u
u
assembly (13) to empty the contents of the bowl.
To replace the dust bowl, place it back onto the handle
Warning!
-
u
u
u
for more thorough cleaning.
u
water.
u
ever worn or damaged.
dealer:
For DV7210F-XE use filter part number VF110-XJ.
For DV9610F-XE use filter part number VF110FC-XJ.
-
(Original instructions)
Maintenance
Your Black & Decker corded/cordless appliance/tool has been
designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
u Or run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. This product must not be
disposed of with normal household waste.
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product available for separate collection.
z
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw
materials.
ENGLISH
Battery
Z
u
u
u
u
u
u
u
u
If you want to dispose of the product yourself, the
battery must be removed as described below and
disposed of in accordance with local regulations.
Preferably discharge the battery by operating the appliance until the motor stops.
Press the release button (2) and remove the dust bowl (5).
Remove the seven screws holding the body of the appliance together.
Lift the housing cover away from the assembly.
Detach all lead connections from the battery pack.
Remove battery pack.
Place the battery in a suitable packaging to ensure that
the terminals cannot be short-circuited.
Take the battery to your service agent or to a local recycling station.
To claim on the guarantee, you will need to submit proof of
purchase to the seller or an authorised repair agent. You can
check the location of your nearest authorised repair agent
indicated in this manual. Alternatively, a list of authorised
Black & Decker repair agents and full details of our aftersales service and contacts are available on the Internet at:
www.2helpU.com
Please visit our website www.blackanddecker.com.au to register
your new Black & Decker product and to be kept up to date
on new products and special offers. Further information on the
Black & Decker brand and our range of products is available
at www.blackanddecker.com.au
Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or
by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
You can check the location of your nearest authorised repair
the address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of our
after-sales service and contacts are available on the Internet
at: www.2helpU.com
7
(Original instructions)
ENGLISH
Technical data
Voltage
Battery
Weight
DV9610F-XE
DV7210F-XE
(H1)
(H1)
Vdc
9.6
7.2
Type
NICD
NICD
1.58
1.13
kg
Charger
SA140020D
SA110020D
Input voltage
Vac
240
240
Output voltage
Vac
14
11
Current
mA
200
200
Approximate
h
16
16
0.22
0.17
charge time
Weight
kg
Australia & New Zealand
Stanley Black & Decker
82 Taryn Drive, Epping, VIC 3076 Australia
Tel.1800 444 224 (Aust) or Tel. 0800 339 258 (NZ)
90586851
8
06/12
Download PDF