FMC772 | Stanley FMC772 SPEAKER instruction manual

(Original instructions)
(Original instructions)
Intended use
Your Stanley FatMax FMC772B Bluetooth speaker has been
designed for receiving audio transmission form Bluetooth
enabled devices. This appliance is intended for professional
and consumer use.
General safety warnings
Read all of this manual carefully before using the appliance.
The intended use is described in this manual. The use of
any accessory or attachment or the performance of any
operation with this appliance other than those recommended in this instruction manual may present a risk of
personal injury.
Retain this manual for future reference.
Using your appliance
Always take care when using the appliance.
The appliance is not to be used as a toy.
Use in a dry location only. do not allow the appliance to
become wet.
Do not immerse the appliance in water.
Do not open body casing. There are no user serviceable
parts inside.
Do not operate the appliance in explosive atmospheres,
To reduce the risk of damage to plugs and cords never
pull the cable to remove the plug from a socket outlet.
After use
When not in use, the appliance should be stored in a dry
Children should not have access to stored appliances.
When the appliance is stored or transported in a vehicle
it should be placed in the boot or restrained to prevent
movement following sudden changes in speed/direction.
Inspection and repairs
Before use, check the appliance for damaged or defective
parts. Check for breakage of parts, damage to switches
and any other conditions that may affect its operation.
Do not use the appliance if any part is damaged or defective.
Have any damaged or defective parts repaired or replaced
by an authorized repair agent.
Never attempt to remove or replace any parts other than
Safety of others
Safety instructions
Warning! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions listed below may result in
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a person responsible for their
Children must be supervised to ensure that they do not
play with the appliance.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any rotating/moving parts.
u Injuries caused when changing any parts, blades or accessories.
u Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods ensure you take regular
u Impairment of hearing.
u Health hazards caused by breathing dust developed when
using your tool (example:- working with wood, especially
oak, beech and MDF).
Labels on appliance
The following warning symbols are found on the appliance:
To reduce the risk of injury, the user must read
the instruction manual.
Additional safety instructions for batteries and
Batteries (not supplied)
u Never attempt to open for any reason.
u Do not expose the battery to water.
u Do not store in locations where the temperature may
exceed 40 °C.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
u Do not damage/deform the battery pack either by puncture
Do not charge damaged batteries.
Under extreme conditions, battery leakage may occur.
(Original instructions)
When you notice liquid on the batteries Carefully wipe the
liquid off using a cloth. Avoid skin contact.
u In case of skin or eye contact, follow the instructions
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
This appliance includes some or all of the following features.
Volume buttons
Power button
Bluetooth® / Auxiliary mode button
18v battery port
Auxiliary jack
Auxiliary jack holder
u Begin playing music on your device.
Note: The speaker does not have to be in the Bluetooth mode
when pairing, only when listening.
*The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by Stanley FatMax is under license. Other trademarks
and trade names are those of their respective owners.
Listening in auxiliary mode
To listen to a device in auxiliary mode, press and hold the
Bluetooth button (3) until the blue
light turns green. Plug the auxiliary jack (5) into the auxiliary
port of your device.
holder (6).
Incoming Call
If your phone receives a call while it is connected to the
speaker it will ring through the speaker.
Power/Volume Adjustment
To operate as a cordless product, insert a fully charged 18v
Stanley FatMax battery (not included) into the battery port.
Be sure battery is fully seated.
To turn the speaker on, press the power button (2). Press the
power button again to turn the speaker off.
Press the “+” button (1) to increase the volume. To decrease
the volume, press the “-” button.
Bluetooth® and auxiliary function
To transfer the call to your phone, deselect the headset option
on your phone. The speaker will remain mute until the call is
over. End the call normally with your cell phone. The speaker
will resume previous function.
**Samsung® is a registered trademarks of Samsung Group.
To transfer the call to your phone, select “audio source” on
your phone, then select “iPhone.” The speaker will remain
mute until the call is over. End the call normally with your cell
phone. The speaker will resume previous function.
***iPhone® is a registered trademark of Apple Inc.
When the speaker is turned on, it will automatically be in
Bluetooth mode. To switch to auxiliary mode, press and hold
the Bluetooth button (3) until the light turns green. To switch
back to Bluetooth mode, simply press and hold the Bluetooth
Using Bluetooth® Wireless
Turn the speaker on.
The speaker should already be in Bluetooth mode. If not,
press the Bluetooth button (3).
Find “P3BTS” under devices on your Bluetooth enabled
the pairing takes place. Once the pairing is successful the
blue light will remain steady.
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local Stanley FatMax repair agent.
Warning! Before proceeding, unplug the appliance.
(Original instructions)
Possible Solution
Possible Cause
Unit will not power on
Battery is not charged
Charge battery
Battery is not fully
Push battery fully into the
battery port and ensure it
is properly connected
Battery does not have
enough power
Charge battery
Battery has been removed
Replace battery
Device roamed out of
Bring device into range of
Bluetooth speaker
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product available for separate collection.
Separate collection of used products and packaging allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
Device may need to be
paired to the Bluetooth
again, see "Using
Bluetooth Wireless
Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or
by the retailer when you purchase a new product.
If two or more devices are
paired to speaker,
disconnect the speaker
in the settings of the one
of the devices.
Stanley FatMax provides a facility for the collection and
recycling of Stanley FatMax products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
Your Stanley FatMax corded/cordless appliance/tool has been
designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends
upon proper tool/appliance care and regular cleaning.
Warning! Switch off and unplug the appliance before carrying
out any cleaning.
u Dirt and grease may be removed from the exterior of the
appliance using a cloth.
Warning! NEVER use solvents or other harsh chemicals
for cleaning the non-metallic parts of the appliance. These
chemicals may weaken the materials used in these parts. Use
a cloth dampened only with water and mild soap. Never let
any liquid get inside the unit; never immerse any part of the
unit into a liquid.
Warning! NEVER spray or in any other way apply lubricants
or cleaning solvents inside the tool. This can seriously affect
the life and performance of the tool.
Service Notes
This product is not user serviceable. There are no user
serviceable parts inside the radio. Servicing at an authorized
service center is required to avoid damage to static sensitive
internal components.
You can check the location of your nearest authorised repair
address indicated in this manual. Alternatively, a list of authorised Stanley Fat Max repair agents and full details of our
after-sales service and contacts are available on the Internet
At the end of their useful life, discard batteries with
due care for our environment:
Run the battery down completely, then remove it from the
NiCd, NiMH and Li-Ion batteries are recyclable. Place
the battery(s) in a suitable packaging to ensure that the
terminals cannot be short-circuited. Take them to any
authorised repair agent or a local recycling station.
Do not short-circuit the battery terminals.
in a risk of personal injury or an explosion.
Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
(Original instructions)
(Original instructions)
Australia & New Zealand
Stanley Black & Decker
82 Taryn Drive, Epping, VIC 3076 Australia
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF