SVA420B | Black&Decker SVA420B STICK-VAC instruction manual

www.blackanddecker.com.au
www.blackanddecker.co.nz
SVA420B
3
2
1
4
5
12
11
10
6
9
7
7a
9a
8
2
1
11
12
A
B
6
6
13
7
7
C
D
7
7
8
E
F
3
10
9
4
5
6
G
H
1
3
2
14
2
I
J
15
16
15
K
4
3
L
L1
18
17
M
5
ENGLISH
(Original instructions)
Intended use
Your BLACK+DECKER SVA420B 2 in 1 Stick vac has been
designed for vacuum cleaning purposes. These appliances
are intended for household use only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
@
@
Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below may
result in electric shock, fire and/or
serious injury.
Warning! When using batterypowered appliances, basic
safety precautions, including
the following, should always be
followed to reduce the risk of fire,
leaking batteries, personal injury
and material damage.
u
Never pull the charger lead to
disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.
u This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Inspection and repairs
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.
u Do not use the appliance if any part is
damaged or defective.
u Read all of this manual carefully before
u Have any damaged or defective parts
using the appliance.
repaired or replaced by an authorized
u The intended use is described in this
repair agent.
manual. The use of any accessory
u Regularly check the charger lead for
or attachment or the performance
damage. Replace the charger if the
of any operation with this appliance
lead is damaged or defective.
other than those recommended in this
u Never attempt to remove or replace
instruction manual may present a risk
any parts other than those specified in
of personal injury.
this manual.
u Retain this manual for future
reference.
Using your appliance
u
Do not use the appliance to pick up
liquids or any materials that could
catch fire.
u Do not use the appliance near water.
u Do not immerse the appliance in water.
6
Additional safety instructions
After use
u
u
Unplug the charger before cleaning the
charger or charging base.
When not in use, the appliance should
be stored in a dry place.
(Original instructions)
u
Children should not have access to
stored appliances.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc. Even with the application of
the relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided.
These include:
u Injuries caused by touching any
rotating/moving parts.
u Injuries caused when changing any
parts, blades or accessories.
u Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
u Impairment of hearing.
u Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Batteries and chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
u Do not expose the battery to heat.
u Do not store in locations where the
u
u
temperature may exceed 40°C.
only at ambient temperatures
between 10°C and 40°C.
u Charge only using the charger provided with the appliance/tool. Using
the wrong charger could result in an
electric shock or overheating of the
battery.
u
Charge
ENGLISH
disposing of batteries, follow
the instructions given in the section
“Protecting the environment”.
u Do not damage/deform the battery
pack either by puncture or impact, as
this may create a risk of injury and fire.
u Do not charge damaged batteries.
u Under extreme conditions, battery
leakage may occur. When you notice
liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin
contact.
u In case of skin or eye contact, follow
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
u
When
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u Never attempt to charge nonrechargeable batteries.
u If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
7
ENGLISH
u
(Original instructions)
The appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
+
Read all of this manual carefully before using
the appliance
#
w
$
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
Short circuit proof safety isolating transformer.
The mains supply is electrically separated
from the transformer output.
Z
Indication of polarity.
The charging base is intended for indoor use
only.
Read all of this manual carefully before
using the appliance
K12S180050A
Separate collection. This Products must not be
disposed of with normal household waste.
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust bowl release button
8
Switching on and off (Fig. A)
u
u
To switch on, press the on/off switch (1) located on the
handle of the main unit (1), or alternatively on the chassis
handle (4).
To switch off, press the on/off switch (1) or (4).
Using Accessories (Fig. B)
u
u
The appliance is supplied with a brush tool (11) and a
crevice tool (12).
Fit the chosen accessory into the front of the appliance as
shown in Figure B.
Fitting the upper handle to the main chassis
(Fig. C, D)
u
The stick vac chassis is supplied in 2 parts, the upper handle (6) and the lower chassis (7), but they are connected
by a wire.
Slide the upper handle (6) into the main chassis (7) as
u
Ensure the wire is not trapped.
u
The following symbols appear on this appliance along with the
date code
K12S180050A
Use
SMPS
Labels on appliance
+
3. Dust bowl
4. Chassis on/off power switch
5. Brush control switch
6. Upper handle
7. Main chassis
7a. Chassis release button
8. Floor head
9. Floor charging base
9a. Tool storage
10. Charger
11. Brush tool accessory
12. Crevice tool accessory
u
(Fig. E)
u
Fitting the vacuum to the Chassis
(Fig. F, G)
u
u
u
To release the vacuum from the chassis press the chassis
release button (7a) and lift clear.
The appliance can now be operated via the on/off button
(4) on the handle (6). This also allows you to utilise the
beater bars via the ‘brush on’ control (5) as shown in
(Original instructions)
Charging (Fig. H)
The charging base (9) will need to be securely fastened to
a wall.
Note:
surface are used.
u Place the appliance into the charging base (9) as shown in
.
u Plug the charger (10) into the charging base (9)
u Plug the charger (10) into an electrical outlet.
u Switch the electrical outlet on. The LED charging indicator
(14) will Illuminate (Fig. I).
u
u
u
Press the dust bowl release button (2) and lift out the dust
bowl (3) (Fig.J)
u
u
Empty the dust bowl by lightly shaking over a dustbin.
u
u
ENGLISH
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
your BLACK+DECKER dealer (cat. no: SVF11).
u
u
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
SVA420B
u
u
u
u
Close the dust-bowl. Make sure the release latch (2)
clicks into place.
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water.
u
Removing and cleaning the beater bar (Fig. M)
u
Pinch and lift the plastic tab on the pivoting clip (17) away
Voltage
14.4V
Watt hours
28.8Wh
Weight
2Kg
Charger
K12S180050A
Input Voltage (Vac)
100-240
Output Voltage (V)
18
Current (mA)
500
Approx charge time (h)
4
u
u
Ensure the beater bar and pivoting clip are replaced
before using the vacuum.
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
u Run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/
charger using a soft brush or dry cloth.
9
ENGLISH
10
(Original instructions)
11
Australia & New Zealand
Stanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
90638842
05/2016
Download PDF