DVJ325BFSP | Black&Decker DVJ325BFSP DUSTBUSTER Type H1 instruction manual

4
3
1
2
5
6
10
7
8
9
www.blackanddecker.com.au
www.blackanddecker.co.nz
DVJ325BFSP
4a
1
4
B
A
9
4
C
10
3
10a
D
2
3a
D
3
10d
10c
10b
10
10
E
F
10
5
8
G
7
H
6
I
3
6
6
11
J
K
Intended use
12
Your BLACK+DECKER DVJ325BFSP Dustbuster® hand-held
vacuum cleanerr has been designed for vacuum cleaning purposes. These appliances are intended for household use only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
@
L
The intended use is described in this
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
u Retain this manual for future
reference.
u
M
4
Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below may
result in electric shock, fire and/or
serious injury.
(Original instructions)
Using your appliance
u
u
Do not use the appliance to pick up
liquids or any materials that could
catch fire.
u Do not use the appliance near water.
u Do not immerse the appliance in water.
u Never pull the charger lead to
disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.
u This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Inspection and repairs
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorized
repair agent.
u Regularly check the charger lead for
damage. Replace the charger if the
lead is damaged or defective.
ENGLISH
Never attempt to remove or replace
any parts other than those specified in
this manual.
Additional safety instructions
After use
u
Unplug the charger before cleaning the
charger or charging base.
u When not in use, the appliance should
be stored in a dry place.
u Children should not have access to
stored appliances.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any
rotating/moving parts.
u Injuries caused when changing any
parts, blades or accessories.
u Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
u Impairment of hearing.
u Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
5
ENGLISH
(Original instructions)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u Never attempt to charge nonrechargeable batteries.
u If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
#
Read all of this manual carefully before using the
appliance.
$
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
6
Read all of this manual carefully before
using the appliance
S010Q 14
Only use with charger S010Q 14
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Handle
3. Nozzle
4. Pull out crevice tool
5. LED charging indicator
6. Dust bowl
7. Dust bowl release button
8. Charging base
9. Detachable push in brush accessory
10. Power head
Use
Switching on and off (Fig. A)
u
u
u
Press the button (1) to turn on, the unit operates
in slow speed, low power mode, conserving the
battery life.
Press the button (1) again, and the unit goes to a BOOST
mode.
Pressing the button (1) again will turn the product off.
Using the pull out crevice tool (Fig. B,C)
u
u
Extend the crevice tool (4) as shown in figure C, until
it clicks in place. The push in brush (9) can be fitted if
required for dusting and upholstery cleaning.
To retract the crevice tool (4) press the crevice tool release
button (4a) allowing it to return to its normal position
(Fig. B).
Attaching the power head (Fig. D)
u
Slide the nozzle (3) into the opening of the power head
(10), ensuring that the connectors (10a) engage with the
recesses (3a). An auadible click will be heard.
Detaching the power head (Fig. E)
u
u
Push th power head release button (10b).
Lift the main dustbuster unit from the power head (10).
Removing the beater bar from the power head
for cleaning (Fig. F)
u
u
u
Press the beater bar release button (10c).
Lift the beater bar (10d) up and out of the power head.
The beater bar can now be freed from any hair and accumulated debris.
ENGLISH
(Original instructions)
Charging (Fig. G)
u
u
LED Patterns
Place the appliance onto the charging base (8) and plug
into the electrical outlet.
Switch the electrical outlet on. The LED charging indicator
(B) will illuminate.
Charging
Battery Fault
Charger Fault
Multi LED Display
Battery Hot
A
Warning! NEVER charge the unit with the power head
attached, as this will cause the unit to unbalance and may
cause safety problems.
B
Cleaning the filters (Fig. , H, I, J, K, L,
M)
Press the dust bowl release button (7) (Fig. H)
Eject the dust bowl (6) (Fig.I)
u Lift the filter assembly (11) using the metal handle provided from the dust bowl (6) (Fig. J)
Note: On unit DVJ325BFSP the pre filter is impregnated with
a fragrance allowing for a pleasing odour to be released when
the appliance is in use.
u Empty the dust bowl (6) by lightly shaking over a dustbin
(Fig. K).
u The filter (12) can now be removed from the filter assembly (11) (Fig. L)
u Empty any remaining dust from the dust bowl.
u Rinse out the dust-bowl with warm soapy water.
u Wash the filters with warm soapy water (Fig. M).
u Make sure the filters are dry
u Refit the filters into the appliance.
u Close the dust-bowl. Make sure the release latch (7) clicks
into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
u
C
A. Filter sensor
Whenever a filter is Blocked and needs cleaning, the red
filter LED (A) in the handle will illuminate.
Clean fine dust from filter (See section on ‘cleaning filters’
in this manual).
B. LED Charging display
The charging display LED (B) will illuminate when the unit
is charging and will indicate (flash) when further charging
is required.
C. BOOST mode
LED (C) Illuminates when the appliance is in BOOST
mode.
u
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
u Run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
7
ENGLISH
u
u
(Original instructions)
Regularly clean the ventilation slots in your appliance/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Replacing the filters
Australia & New Zealand
St
Stanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available from
your BLACK+DECKER dealer (cat. noVPF20).
There are also pre-scented filters available to be purchased
(cat. no: VSPF10LC). These fit all units.When these filters
reach the end of their lifespan they must be disposed of at a
local recycling centre.
Filters are supplied in foil packaging which needs to be
removed. To assemble filters see Fig. I.
Warning!
Cotton linen fragrance.
Wash face, hands and any exposed skin thoroughly after handling. Wear protective gloves/
protective clothing/eye protection/face protection. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. If skin irritation
occurs:
Get medical advice/attention.
Avoid release into the environment. Do not ingest.
u
u
Remove the old filters as described above.
Fit the new filters as described above.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
DVJ325BFSP
Voltage
10.8V
Current
2.5Ah
Watt Hours
27Wh
Weight (Power Head + unit)
1.6kg
N503902
8
06/2017
Download PDF

advertising