SVJ520BFSP | Black&Decker SVJ520BFSP DUSTBUSTER instruction manual

www.blackanddecker.co.uk
SVJ520BFSP
1
5
11
2
3
4
8
9
12
10
6
7
15
13
14
2
16
3a
1
3
A
B
4
3
C
6
2
6a
2a
D
3
2
6d
6c
6
6b
6
E
F
10
10
17
12
G
12
H
12
I
4
J
13
15
8
10
K
16
L
14
M
5
7
N
O
5
18
P
6
Q
5
5
R
19
S
20
T
U
7
ENGLISH
(Original instructions)
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Intended use
Your BLACK+DECKER SVJ520BFSP Dustbuster® hand-held
vacuum cleaners have been designed for vacuum cleaning
purposes. These appliances are intended for household use
only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
@
Inspection and repairs
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
u Retain this manual for future
reference.
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorized
repair agent.
u Regularly check the charger lead for
damage. Replace the charger if the
lead is damaged or defective.
u Never attempt to remove or replace
any parts other than those specified in
this manual.
Using your appliance
Additional safety instructions
u
u
Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below may
result in electric shock, fire and/or
serious injury.
The intended use is described in this
Do not use the appliance to pick up
liquids or any materials that could
catch fire.
u Do not use the appliance near water.
u Do not immerse the appliance in water.
u Never pull the charger lead to
disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.
u This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
8
After use
u
u
u
Unplug the charger before cleaning the
charger or charging base.
When not in use, the appliance should
be stored in a dry place.
Children should not have access to
stored appliances.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
(Original instructions)
Even with the application of the relevant
safety regulations and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any
rotating/moving parts.
u Injuries caused when changing any
parts, blades or accessories.
u Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
u Impairment of hearing.
u Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u Never attempt to charge nonrechargeable batteries.
u If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/battery must be
placed in a well ventilated area when
charging.
ENGLISH
Electrical safety
Symbols on the charger
#
$
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code
S010Q 23
Read all of this manual carefully before
using the appliance
Only use with charger S010Q 23
Features
This tool includes some or all of the following features.
1. On/off power switch
2.Nozzle
3. Pull out crevice tool
4. Push in brush
5. Dust bowl
6. Power head
7. Charging base
8. Handle on/off power switch
9. Brush on button
10. Handle
11. Chassis release button
12. Main chassis
13. Beater bar unit
14. Beater bar
15. Floor head
16. Beater bar unit release button
Use
Switching on and off (Fig. A)
u To switch on, press the on/off switch (1) located on the
handle of the Dustbuster®, or alternatively on the chassis
handle (8).
u Press the button again (1 or 8), and the unit goes to a
BOOST mode.
u To switch off, press the on/off switch (1) or (8).
9
ENGLISH
(Original instructions)
Using the pull out crevice tool (Fig. B,C)
u Extend the crevice tool (3) as shown in figure C, until
it clicks in place. The push in brush (4) can be fitted if
required for dusting and upholstery cleaning.
u To retract the crevice tool (3) press the crevice tool release
button (3a) allowing it to return to its normal position
(Fig. B).
u
u
Plug the charging port (7) into an electrical outlet.
Switch the electrical outlet on. The LED charging indicator
(B) will Illuminate (Fig. O).
Multi LED Display
A
Attaching the power head (Fig. D)
u Slide the nozzle (2) into the opening of the power head
B
(6), ensuring that the connectors (6a) engage with the
recesses (2a). An auadible click will be heard.
C
Detaching the power head (Fig. E)
u Push th power head release button (6b).
u Lift the main dustbuster unit from the power head (6).
Removing the beater bar from the power head
for cleaning (Fig. F)
u Press the beater bar release button (6c).
u Lift the beater bar (6d) up and out of the power head.
u The beater bar can now be freed from any hair and accumulated debris.
Fitting the handle to the main chassis
(Fig. G, H)
u Slide the handle (10) into the main chassis (12) as shown
in figure G.
u
Secure with retaining screw (17) as shown in figure H.
Fitting the Dustbuster® to the Chassis
(Fig. I, J, K)
®
u Slide the Dustbuster , nozzle first, into the chassis
(12)
until an audible ‘click’ is heard as shown in figure I.
®
u To release the Dustbuster from the chassis press the
chassis release button (11) and lift clear.
u The appliance can now be operated via the on/off button
(8) on the handle (10) along with the ‘BOOST’ mode as
shown in figure K. This also allows you to utilise the beater
bars via the ‘brush on’ control (9).
A.Filter sensor
Whenever a filter is Blocked and needs cleaning, the red
filter LED (A) in the handle will illuminate.
Clean fine dust from filter (See section on ‘cleaning filters’
in this manual).
B. LED Charging display
Battery icon (B) will illuminate when appliance requires
charging. Led display indicates state of charge (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode
allowing you to operate at higher power.
LED Patterns
Removing and clearing the beater bars
(Fig. L, M)
u To remove the beater bar unit (13) from the floor head (15)
Depress the release button (16) as shown in figure L.
u The beater bar (14) can now be removed. The end pieces
are also removable allowing you to clear the brushes from
any hair or other debris that may have accumulated (Fig.
M).
Charging (Fig. N, O)
u
Place the appliance into the charging base (7) as shown in
10
figure N .
Charging
Battery Fault
Charger Fault
Battery Hot
Cleaning the filters (Fig. P, Q, R, S, T,
U)
u
u
Press the dust bowl release button (18) (Fig. P)
Eject the dust bowl (5) (Fig. Q)
(Original instructions)
ENGLISH
Lift the filter assembly (19) from the dust bowl (5) (Fig.R).
Empty the dust bowl by lightly shaking over a dustbin
(Fig. S).
Note: The pre filter is impregnated with a fragrance allowing
for a pleasing odour to be released when the appliance is in
use.
u The filter (20) can now be removed from the pre filter (19)
Figure T.
u Empty any remaining dust from the dust bowl.
u Rinse out the dust-bowl with warm soapy water.
u Wash the filters with warm soapy water (Fig. U).
u Make sure the filters are dry
u Refit the filters onto the appliance.
u Close the dust-bowl. Make sure the release latch (18)
clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
Warning!
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water
Products and batteries contain materials that can be recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
u
u
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
u Run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available
from your BLACK+DECKER dealer (cat. no : VPFE20).
There are also pre-scented filters available to be purchased
(cat. no: VSPF10CG). These fit all units. When these filters
reach the end of their lifespan they must be disposed of at a
local recycling centre.
Filters are supplied in foil packaging which needs to be
removed.
Cotton linen fragrance.
Wash face, hands and any exposed skin thoroughly after handling. Wear protective gloves/
protective clothing/eye protection/face protection. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses if present and
easy to do. Continue rinsing. If skin irritation occurs: Get medical advice/attention. Avoid release into the environment. Do not ingest.
u Remove the old filters as described above.
u Fit the new filters as described above.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Technical Data
SVJ520BFSP
Voltage
18V
Watt hours
36Wh
Weight (Power head + unit
+ chassis)
3.3Kg
Guarantee
Black & Decker is confident of the quality of its products and
offers consumers a 24 month guarantee from the date
of purchase. This guarantee is in addition to and in no way
prejudices your statutory rights. The guarantee is valid within
the territories of the Member States of the European Union
and the European Free Trade Area.
To claim on the guarantee, the claim must be in accordance
with Black&Decker Terms and Conditions and you will need to
submit proof of purchase to the seller or an authorised repair
agent. Terms and conditions of the Black&Decker 2 year guarantee and the location of your nearest authorised repair agent
can be obtained on the Internet at www.2helpU.com, or
by contacting your local Black & Decker office at the address
indicated in this manual.
Please visit our website www.blackanddecker.co.uk to register
your new Black & Decker product and receive updates on new
products and special offers
11
Australia
Black & Decker (Australia) Pty. Ltd.
20 Fletcher Road, Mooroolbark,
Victoria, 3138
Tel. Fax
03-8720 5100
03-9727 5940
New Zealand
Black & Decker
5 Te Apunga Place
Mt Wellington
Aukland 1060
Tel. Fax
+64 9 259 1133
+64 9 259 1122
United Kingdom &
Republic Of Ireland
www.blackanddecker.co.uk emeaservice@sbdinc.com
Black & Decker
210 Bath Road
Slough, Berkshire SL1 3YD
Tel. Fax
01753 511234
01753 512365
N503389 REV-01
02/2018
Download PDF