WDA320J | Black&Decker WDA320J WET N'DRY VAC instruction manual

3
2
1
4
8
6
5
www.blackanddecker.com.au
www.blackanddecker.co.nz
7
WDA315J
WDA320J
1
3
A
6
5
81mm
C
B
7
9
4
D
5
9
2
E
2
F
3
G
3
8
10
H
10
3
I
J
3
ENGLISH
(Original instructions)
Intended use
Your BLACK+DECKER WDA315J and WDA320J Dustbuster®
hand-held vacuum cleaners have been designed for light wet
and dry vacuum cleaning purposes. These appliances are
intended for household use only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
@
Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below may
result in electric shock, fire and/or
serious injury.
The intended use is described in this
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
u Retain this manual for future
reference.
u
Using your appliance
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Inspection and repairs
Before use, check the appliance for damaged or defective parts.
Check for breakage of parts, damage to
switches and any other conditions that
may affect its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorized
repair agent.
u Regularly check the charger lead for
damage. Replace the charger if the
lead is damaged or defective.
u Never attempt to remove or replace
any parts other than those specified in
this manual.
Do not use the appliance to pick up
liquids or any materials that could
Additional safety instructions
catch fire.
u Do not immerse the appliance in water.
After use
u Never pull the charger lead to
u Unplug the charger before cleaning.
disconnect the charger from the
u When not in use, the appliance should
socket. Keep the charger lead away
be stored in a dry place.
from heat, oil and sharp edges.
u Children should not have access to
u This appliance can be used by
stored appliances.
children aged from 8 years and above
and persons with reduced physical,
u
4
(Original instructions)
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any
rotating/moving parts.
u Injuries caused when changing any
parts, blades or accessories.
u Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
u Impairment of hearing.
u Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u
ENGLISH
Never attempt to charge non-
rechargeable batteries.
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/battery must be
placed in a well ventilated area when
charging.
u
Electrical safety
Symbols on the charger
#
$
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code.
Read all of this manual carefully before
using the appliance
Only use with charger S003AQ-15
S003AQ-15
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust chamber release button
3. Dust chamber
4. Wall bracket
5. Charger
6. Hanging attatchment
7. Removable squeegee
5
ENGLISH
(Original instructions)
Use
Switching on and off (Fig. A)
u
u
Push the On/off power switch (1) to the forward position to
turn on the unit.
Returning the On/off power (1) switch will turn the unit off.
Fitting the removable squeegee (Fig. B)
u
Insert the removable squeegee into the front of the
appliance. Make sure that the accessory is pushed fully in
as shown figure B.
Fitting the wall bracket (Fig. C)
u
u
Fit the wall bracket (4) to a suitable wall (preferably near a
power outlet) using the screws provided.
The unit can then be stored, when not in use, or during the
charging procedure, utilising the hanging attachment (6).
Charging (Fig. D, E)
u
u
Place the charger (5) into the charging port (9) on the
handle of the unit as shown in figure D.
Place the charging plug into a power outlet and switch on
as shown in figure E. The charger LED (9) will light.
Cleaning the filters (Fig. F, G, H, I, J)
Press the dust chamber release button (2) as shown in
figure F.
u Seperate the dust chamber (3) from the motor unit as
shown in figure G.
u Lift the pre filter assembly (8) out of the dust chamber (3).
Remove the wet/dry foam filter (10) from the filter assembly as shown in figure H.
u Empty the dust bowl (3) by lightly shaking over a suitable
container as shown in figure I.
u Rinse out the dust-bowl with warm soapy water.
u Wash the filter with warm soapy water as shown in figure
J.
u Allow the filter to dry naturally, using heat may cause the
filters to distort.
u Refit the filter (10) into dust chamber (3).
u Replace the dust chamber onto the motor unit. Make sure
the release button (2) clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
u
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water.
6
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
u Run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available from
your BLACK+DECKER dealer (cat. noVPF20)
u Remove the old filters as described above.
u Fit the new filters as described above.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
WDA315J H1
WDA320J H1
Voltage
10.8V
10.8V
Current
1.5Ah
2.0Ah
16.2Wh
21.6Wh
0.9Kg
0.9Kg
Watt Hours
Weight
(Original instructions)
ENGLISH
Australia & New Zealand
Stanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
N541204
06/2017
7
Download PDF