NSVA315J | Black&Decker NSVA315J DUSTBUSTER instruction manual

www.blackanddecker.com.au
www.blackanddecker.co.nz
NSVA315J
1
9
2
3
4
8
7
5
6
2
8
9
A
1
8
B
4
7
7a
5
6
C
D
7
E
2
F
3
3
4
G
H
10
4
10
4
I
4
J
(Original instructions)
ENGLISH
Failure to follow the warnings
and instructions listed below may
result in electric shock, fire and/or
serious injury.
11
The intended use is described in this
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
u Retain this manual for future
reference.
u
Using your appliance
Do not use the appliance to pick up
liquids or any materials that could
catch fire.
u Do not immerse the appliance in water.
u Never pull the charger lead to
disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.
u This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
u
K
Intended use
Your BLACK + DECKER NSVA315J Dustbuster® vacuum
cleaner with floor head and handle has been designed for
light dry vacuum cleaning purposes. This appliance is
intended for household use only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
@
Warning! Read all safety
warnings and all instructions.
5
ENGLISH
(Original instructions)
Inspection and repairs
Before use, check the appliance for damaged or defective parts.
Check for breakage of parts, damage to
switches and any other conditions that
may affect its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorized
repair agent.
u Regularly check the charger lead for
damage. Replace the charger if the
lead is damaged or defective.
u Never attempt to remove or replace
any parts other than those specified in
this manual.
Additional safety instructions
After use
Unplug the charger before cleaning.
u When not in use, the appliance should
be stored in a dry place.
u Children should not have access to
stored appliances.
u
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the implementation of safety devices, certain residual
risks can not be avoided. These include:
6
Injuries caused by touching any
rotating/moving parts.
u Injuries caused when changing any
parts, blades or accessories.
u Injuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
u Impairment of hearing.
u Health hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
u
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
u Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u Never attempt to charge nonrechargeable batteries.
u If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/battery must be
placed in a well ventilated area when
charging.
(Original instructions)
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
#
$
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code.
Read all of this manual carefully before
using the appliance
Only use with charger S003AQ-15
S003AQ-15
Features
This tool includes some or all of the following features.
1. Extension pole release button
2. On/Off switch
3. Dust chamber release button
4. Dust chamber
5. Floor head connector
6. Floor head
7. Charger
8. Extension pole
9. Handle
Assembly (Fig. A, B, C)
Push the handle (9) firmly into the extension pole (8) as
shown in figure A.
Note: This process only needs to be performed once, as you
will be unable to remove the handle from the extension pole
once it is locked in place.
u Push the extension pole (8) into the opening on the
Dustbuster® until it clicks into place as shown in figure B.
To release the extension pole from the Dustbuster® press
the extension pole release button (1).
u Fit the floor head (6) to the opening on the dust chamber
(4) at the front of the Dustbuster® unit via the floor head
connector (5) as shown in figure C.
u
Charging the battery (Fig. D, E)
u
Place the charger (7) into the charging port (7a) at the rear
of the unit and plug into the electrical outlet.
u
ENGLISH
Switch the electrical outlet on.
Use
u
Before first use, the battery must be charged for at least
10 hours.
Switching on and off (Fig. F)
To switch the appliance on, push the on/off switch (2) to
the forward position.
u To switch the appliance off, return the on/off switch (2) to
the back position.
Warning! Never pick up wet applications with these units.
u
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filters (Fig. G, H, I, J).
Press the dust chamber release button (3)and remove the
dust chamber (4) from the motor unit as shown in figure G.
u While holding the dust chamber (4) over a suitable
receptacle, pull out the filter (10).
u Shake the dust chamber (4) over a suitable receptacle to
empty the contents as shown in figure I.
u To replace the dust bowl, push it back onto the motor unit
until it locks firmly into position.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
u The dust bowls and filters can be washed in warm soapy
water.
u Make sure that the filters and the dust bowl are dry before
re-fitting.
u
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your BLACK+DECKER
dealer:
Storage (Fig. K)
Your BLACK+DECKER NVSA315J can be hung from a wall
fitting (not supplied) by using the hole in the handle (11) as
shown in figure K.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
7
ENGLISH
(Original instructions)
Warning! Before performing any maintenance on corded/
cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
u Or run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. Products and batteries marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
NSVA315J
Voltage (Vdc)
Battery
Weight (Kg)
Charger
Input Voltage (Vac)
Output Voltage (V)
Current (mA)
Approx charge time (h)
10.8
Li-Ion
1.3
S003AQ-15
100 - 240
15
150
10
Australia & New Zealand
St
Stanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
N516704
8
04/2017
Download PDF

advertising